Life-Cycle Cost Assessment of Maintenance Strategies for RC Structures in Chloride Environments
Publication: Journal of Bridge Engineering
Volume 17, Issue 2
Abstract
Corrosion of the reinforcing steel can cause cover cracking and eventual spalling of reinforced concrete (RC) surfaces, resulting in costly and disruptive repairs. The present paper will compare the effect of maintenance and repair strategies on the timing, extent, and cost of remediation actions over the service life of a RC structure in a chloride environment. The paper presents a probabilistic reliability analysis, which is used to predict the likelihood and extent of corrosion-induced cracking to RC structures. A spatial time-dependent reliability model has been developed where concrete properties, concrete cover, and the surface chloride concentrations are treated as random fields. This allows for the calculation of the probability that a given extent of damage will occur for any time period. Maintenance strategies and repair efficiencies are incorporated in a Monte-Carlo event-based simulation analysis, allowing a comparison in terms of cost and number of repairs over the service life of a RC structure. Thus, the expected timing and extent of repairs can be predicted for various design parameters, inspection intervals, repair thresholds, maintenance strategies, and efficiency of repairs. Results are presented for a RC bridge deck subject to a marine environment. The life-cycle cost (LCC) analysis considers repair and user delay costs. User delay costs can be up to ten times higher than the cost of repair itself. The statistical variability of predicted LCCs can be large, with coefficients of variation exceeding one.
Get full access to this article
View all available purchase options and get full access to this article.
References
American Concrete Institute (ACI) Committee 209. (1978). “Prediction of creep, shrinkage and temperature effects.” Detroit, MI, 2.
AASHTO. (2008). “Report: ‘Bridging the Gap’”. Washington, D.C.
Ahmed, S. F. U., Maalej, M., and Mihashi, H. (2007). “Cover cracking of reinforced concrete beams due to corrosion of steel.” ACI Mater. J., 104(2), 153–161.
Building Research Establishment (BRE). (2003). Residual Life Models for Concrete Repair—Assessment of the Concrete Repair Process, Building Research Establishment.
Bertolini, L., Elsener, B., Pedeferri, P., and Polder, R. (2004). Corrosion of steel in concrete—prevention, diagnosis, repair, WILEY-VCH Verlag GmbH & Co, Weinheim, Germany.
Breysse, D., Elachachi, S. M., Sheils, E., Schoefs, F., and O’Connor, A. (2009). “Life-cycle cost analysis of ageing structural components based on non-destructive condition assessment.” Aust. J. Struct. Eng., 9(1), 55–66.
Broomfield, J. P. (2007). Corrosion of steel in concrete—understanding, investigationand repair, Taylor & Francis, Oxon, England.
Ehlen, M. A., Thomas, M. D. A., and Bentz, E. C. (2009). “Life-365 service life prediction model version 2.0.” Concr. Int., 31(5), 41–46.
El-Reedy, M. A. (2008). “Steel reinfrorced concrete structures, Taylor & Francis, New York.
Frier, C., and Sorensen, J. D. (2007). “Stochastic analysis of the multi-dimensional effect of chloride ingress into reinforced concrete.” Applications of Statistics in Civil Engineering (ICASP10), Taylor & Francis Tokyo, 1–8.
Ibrahim, M., Al-Gahtani, A. S., Maslehuddin, M., and Dakhil, F. H. (1999). “Use of surface treatment materials to improve concrete durability.” J. Mater. Civ. Eng., 11(1), 36–40.
Kenshel, O. M. (2009). “Influence of spatial variability on whole life management of reinforced concrete bridges,” Ph.D. thesis, Dept. Of Civil, Structural & Environmental Engineering, Trinity College, Dublin.
Li, Y. (2004). Effect of spatial variability on maintenance and repair decisions for concrete structures, Delft Univ., Netherlands.
Malioka, V., and Faber, M. H. (2004). “Modeling of the spatial variability for concrete structures.” Proc., 2nd Int. Conf. on Bridge Maintenance, Safety, and Management, IABMAS’04 (CD-ROM), E. Watanable, D. M. Frangopol, and T. Utsunomiya, eds., A.A. Balkema, Rotterdam, Netherlands, 825–826.
Marchand, J., and Samson, E. (2009). “Predicting the service-life of concrete structures—limitations of simplified models.” Cem. Concr. Compos., 31(8), 515–521.
Mullard, J. A., and Stewart, M. G. (2009). “Stochastic assessment of timing and efficiency of maintenance for corroding RC structures.” J. Struct. Eng., 135(8), 887–895.
Mullard, J. A. (2010). “Spatial time-dependent reliability analysis and optimisation of maintenance strategies for RC structures subject to corrosion damage.” Discipline of Civil, Surveying and Environmental Engineering. Ph.D. thesis, The Univ. of Newcastle, Australia.
Mullard, J. A., and Stewart, M. G. (2011). “Corrosion-induced cover cracking: New test data and predictive models.” ACI Struct. J., 108(1), 71–79.
Sakai, K., Shimomura, T., and Sugiyama, T. (1999). “Design of concrete structures in the 21st century.” Proc., of the Int. Conf.—Controlling Concrete Degradation, Thomas Telford, Heron Quay, London.
Stewart, M. G. (1995). “Workmanship and its influence on probalistic models of concrete compressive strength.” ACI Mater. J., 122(7), 794–803.
Stewart, M. G. (2006). “Spatial variability of damage and expected maintenance costs for deteriorating RC structures.” Struct. Infrastruct. Eng., 2(2), 79–90.
Stewart, M. G., and Mullard, J. A. (2007). “Spatial time-dependent reliability analysis of corrosion damage and the timing of first repair for RC structures.” Eng. Struct., 29(7), 1457–1464.
Stewart, M. G., and Suo, Q. (2009). “Extent of spatially variable corrosion damage as an indicator of strength and time-dependent reliability of RC beams.” Eng. Struct., 31(1), 198–207.
Sudret, B. (2008). “Probabilistic models for the extent of damage in degrading reinforced concrete structures.” Reliab. Eng. Syst. Saf., 93(3), 410–422.
Val, D. V., and Stewart, M. G. (2003). “Life cycle cost analysis of reinforced concrete structures in marine environments.” Struct. Saf., 25(4), 343–362.
Val, D. V., and Trapper, P. A. (2008). “Probalistic evaluation of initiation time of chloride-induced corrosion.” Reliab. Eng. Syst. Saf., 93(3), 364–372.
Val, D. V., and Stewart, M. G. (2009). “Reliability assessment of ageing reinforced concrete structures—Current situation and future challenges.” Struct. Eng. Int., 19(2), 211–219.
Vanmarcke, E. (1983). Random fields: Analysis and synthesis., MIT Press, Cambridge, MA.
Vu, K., and Stewart, M. G. (2000). “Structural reliability of concrete bridges including improved chloride-induced corrosion models.” Struct. Saf., 22(4), 313–333.
Vu, K. A. T., and Stewart, M. G. (2005). “Predicting the likelihood and extent of RC corrosion-induced cracking.” J. Struct. Eng., 131(11), 1681–1689.
Yang, S.-I., Frangopol, D. M., and Neves, L. C. (2006). “Optimum maintenance strategy for deteriorating bridge structures based on lifetime functions.” Eng. Struct., 28(2), 196–206.
Yunovich, M., Thompson, N. G., Balvanyos, T., and Lave, L. (2001). ”Corrosion Costs and Preventative Strategies in the United States.” FHWA-RD-01-156, CC Technologies Laboratories, Inc. to Federal Highway Administration (FHwA), Washington, D.C.
Zhang, J., and Mailvaganam, N. P. (2006). “Corrosion of concrete reinforcement and electrochemical factors in concrete patch repair.” Can. J. Civ. Eng., 33(6), 785–793.
Information & Authors
Information
Published In
Copyright
© 2012 American Society of Civil Engineers.
History
Received: Oct 11, 2010
Accepted: Mar 23, 2011
Published online: Mar 24, 2011
Published in print: Mar 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.