Numerical Evaluation of the Long-Term Behavior of Precast Continuous Bridge Decks
Publication: Journal of Bridge Engineering
Volume 17, Issue 1
Abstract
Continuous bridge decks constructed with precast girders undergo significant stress changes caused by the concrete delayed deformations because of creep and shrinkage. These effects must be taken into account in the design of new structures. The validation of the analysis procedures should ideally be carried out through the comparison between the calculations and the results observed in real structures. However, experimental results of the construction and long-term behavior of these structures are scarce. The construction of a major bridge in Portugal has provided the opportunity to monitor one such structure. This paper presents the monitoring campaign and the analysis strategy that was developed to assess the long-term variation of strains and stresses in precast continuous bridges. The numerical analysis was validated by comparison with the results observed in the real bridge. The consequences of carrying out simplified analyses based on limited information about the concrete properties and the construction sequence are also evaluated.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers acknowledge the support from the Portuguese Foundation for Science and Technology through the Research Project “UNSPECIFIEDPTDC/ECM/68430/2006—Continuous precast bridge decks for railway bridges: Numerical and experimental assessment” and the Ph.D. grants UNSPECIFIEDSFRH/BD/29125/2006 and UNSPECIFIEDSFRH/BD/25339/2005 attributed to the first and second writers. Support from the contractor consortium, TACE, and the infrastructure owner, BRISA, is also gratefully acknowledged.
References
American Concrete Institute (ACI). (1992). “Prediction of creep, shrinkage, and temperature effects in concrete structures.” ACI 209R-92, American Concrete Institute, Detroit.
Barr, P. J., Kukay, B. M., and Halling, M. W. (2008). “Comparison of prestress losses for a prestress concrete bridge made with high-performance concrete.” J. Bridge Eng., 13(5), 468–475.
Bazant, Z. P. (2001). “Prediction of concrete creep and shrinkage: Past, present and future.” Nucl. Eng. Des., 203(1), 27–38.
Borst, R. (1991). Computational methods in non-linear solid mechanics. Part 2: physical non-linearity, Delft Univ. of Technology, Delft, Netherlands.
Cruz, P. J. S., and Wisniewski, D. F. (2004). “Ave River Bridge—A major precast prestressed concrete U-girder bridge in Portugal.” PCI J., 49(4), 72–85.
European Committee for Standardization (CEN). (2004). “Design of concrete structures—Part 1-1: General rules and rules for buildings.” Eurocode 2: EN 1992-1-1, Brussels, Belgium.
Figueiras, J. A. (1983). “Ultimate load analysis of anisotropic and reinforced concrete plates and shells.” Ph.D. thesis, Dept. of Civil Engineering, Univ. College of Swansea, U.K.
Freyermuth, A. H. (1969). “Design of continuous highway bridges with precast, prestressed concrete girders.” PCI J., 14(2), 14–39.
Ghali, A., Favre, R., and Elbadry, M. (2002). Concrete structures: Stresses and deformations, 3rd. Ed., Spon, London.
Hastak, M., Mirmiran, A., Miller, R., Shah, R., and Castrodale, R. (2003). “State of practice for positive moment connections in prestressed concrete girders made continuous.” J. Bridge Eng., 8(5), 267–272.
Kwak, H. G., and Seo, Y. J. (2000). “Long-term behavior of composite girder bridges.” Comput. Struct., 74(5), 583–599.
Ma, Z., Huo, X., Tadros, M. K., and Baishya, M. (1998). “Restraint moments in precast/prestressed concrete continuous bridges.” PCI J., 40–57.
Marí, A. R. (2000). “Numerical simulation of the segmental construction of three dimensional concrete frames.” Eng. Struct., 22(6), 585–596.
Mattock, A. H. (1961). “Precast-prestressed concrete bridges 5: Creep and shrinkage studies.” J. PCA Res. Devel. Lab., 43(6), 32–66.
McDonagh, M. D., and Hinkley, K. B. (2003). “Resolving restraint moments and designing for continuity in precast prestressed concrete girder bridges.” PCI J., 48(4), 2–17.
Miller, R., Castrodale, R., Mirmiran, A., and Hastak, M. (2004). “Connection of simple-span precast concrete girders for continuity.” NCHRP Report 519—, Transportation Research Board, Washington, DC.
Mirmiran, A., Kulkarni, S., Castrodale, R., Miller, R., and Hastak, M. (2001). “Nonlinear continuity analysis of precast, prestressed concrete girders with cast-in-place decks and diaphragms.” PCI J., 46(5), 60–80.
Newhouse, C. D., Roberts-Wollmann, C. L., Cousins, T. E., and Davis, R. T. (2008). “Modeling early-age bridge restraint moments: Creep, shrinkage, and temperature effects.” J. Bridge Eng., 13(5), 431–438.
Osterle, R. G., Gilkin, J. D., and Larson, S. C. (1989). NCHRP Report 322—Design of precast-prestressed bridge girders made continuous, Transportation Research Board, Washington, DC.
Peterman, R. J., and Ramirez, J. A. (1998). “Restraint moments in bridges with full-span prestressed concrete form panels.” PCI J., 43(1), 54–73.
Santos, L. M. (2001). “Observação e análise do comportamento diferido de pontes de betão.” Ph.D. thesis, Instituto Superior Técnico da Univ. Técnica de Lisboa, Portugal (in Portuguese).
Santos, T. O. (2007). “Retracção do betão em pontes. Observação e análise.” Ph.D. thesis, Faculdade de Ciências e Tecnologia da Univ. Nova de Lisboa, Portugal (in Portuguese).
Sousa, C., and Neves, A. (2009). “DIANA user-supplied subroutine for concrete creep modelling.” LABEST, Faculty of Engineering, Univ. of Porto, Portugal.
Sousa, C., Sousa, H., Neves, A., and Figueiras, J. (2009). “Finite-element analysis of the long-term behavior of the precast access viaduct of the Leziria Bridge.” LABEST, Faculty of Engineering, Univ. of Porto, Portugal.
Valdés, M. (1997). “Behavior during construction and under permanent loads of continuous precast concrete bridges.” Ph.D. thesis, E. T. S. Ingenieros de Caminos, Univ. Politécnica de Catalunya, Barcelona, Spain (in Spanish).
Witte, F. C. (2005). “DIANA user’s manual, Release 9.” TNO DIANA, BV, Delft, Netherlands.
Witte, F. C., and Kikstra, W. P. (2005). “DIANA user’s manual—Material Library.” TNO DIANA, BV, Delft, Netherlands.
Information & Authors
Information
Published In
Copyright
© 2012 American Society of Civil Engineers.
History
Received: May 13, 2010
Accepted: Feb 14, 2011
Published online: Feb 15, 2011
Published in print: Jan 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.