Self-Suction and Self-Jet Control on Wind Loads and Turbulent Flow Structures over a Circular Cylinder
Publication: Journal of Aerospace Engineering
Volume 32, Issue 1
Abstract
An experimental study on a passive, self-suction, and self-jet control method was conducted to manipulate the flow around a circular cylinder at the Reynolds number . The influence of the spacing of the passive bypass jet rings on the aerodynamic forces and flow structures was investigated in detail. The results indicate that the aerodynamic forces acting on the cylinder increase with distance from the jet rings until reaching a critical distance. The critical spacing ratio, , is approximately 2.69 for the convex surface case (Case 1) and for the plane surface case (Case 2). Compared to a bare cylinder, the fluctuations of the lift coefficient and mean drag coefficient are reduced by approximately 94.61% and 33.18%, respectively, when (the most effective case) due to the stable wake and reduction of the dissipation of turbulent kinetic energy in the near wake, as well as the extra energy input by the flow from the outlet holes.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work is funded by the National Key Research and Development Program of China (2016YFC0701107); the National Natural Science Foundation of China through Grant Nos. 51378153, 51578188 and 51722805, and the Fundamental Research Funds for the Central Universities (HIT. BRETIII. 201512 and HITBRETIV. 201803).
References
Bearman, P. W. 1969. “On vortex shedding from a circular cylinder in the critical Reynolds number regime.” J. Fluid Mech. 37 (3): 577–585. https://doi.org/10.1017/S0022112069000735.
Bearman, P. W., and J. K. Harvey. 1993. “Control of circular cylinder flow by the use of dimples.” AIAA J. 31 (10): 1753–1756. https://doi.org/10.2514/3.11844.
Chen, W. L., Y. Cao, H. Li, and H. Hu. 2015a. “Numerical investigation of steady suction control of flow around a circular cylinder.” J. Fluids Struct. 59: 22–36. https://doi.org/10.1016/j.jfluidstructs.2015.09.002.
Chen, W. L., D. L. Gao, W. Y. Yuan, H. Li, and H. Hu. 2015b. “Passive jet control of flow around a circular cylinder.” Exp. Fluids 56 (11): 201. https://doi.org/10.1007/s00348-015-2077-5.
Chen, W. L., H. Li, and H. Hu. 2014. “An experimental study on a suction flow control method to reduce the unsteadiness of the wind loads acting on a circular cylinder.” Exp. Fluids 55 (4): 1–20. https://doi.org/10.1007/s00348-014-1707-7.
Chen, W. L., X. J. Wang, F. Xu, H. Li, and H. Hu. 2017. “Passive jet flow control method for suppressing unsteady vortex shedding from a circular cylinder.” J. Aerosp. Eng. 30 (1): 04016063. https://doi.org/10.1061/(ASCE)AS.1943-5525.0000661.
Chen, W. L., D. B. Xin, F. Xu, H. Li, J. P. Ou, and H. Hu. 2013. “Suppression of vortex-induced vibration of a circular cylinder using suction-based flow control.” J. Fluids Struct. 42: 25–39. https://doi.org/10.1016/j.jfluidstructs.2013.05.009.
Delany, N. K., and N. E. Sorensen. 1953. Low-speed drag of cylinders of various shapes. Washington, DC: National Advisory Committee for Aeronautics.
Favier, J., A. Dauptain, D. Basso, and A. Bottaro. 2009. “Passive separation control using a self-adaptive hairy coating.” J. Fluid Mech. 627: 451–483. https://doi.org/10.1017/S0022112009006119.
Feng, L. H., and J. J. Wang. 2010. “Circular cylinder wake vortex synchronization control with synthetic jet positioned at back stagnation point.” J. Fluid Mech. 662: 232–259. https://doi.org/10.1017/S0022112010003174.
Feng, L. H., and J. J. Wang. 2012. “Synthetic jet control of separation in the flow over a circular cylinder.” Exp. Fluids 53 (2): 467–480. https://doi.org/10.1007/s00348-012-1302-8.
Keefe, R. T. 1962. “Investigation of the fluctuating forces acting on a stationary circular cylinder in a subsonic stream and of the associated sound field.” J. Acoust. Soc. Am. 34 (11): 1711–1714. https://doi.org/10.1121/1.1909102.
Korkischko, I., and J. R. Meneghini. 2012. “Suppression of vortex-induced vibration using moving surface boundary-layer control.” J. Fluids Struct. 34 (3): 259–270. https://doi.org/10.1016/j.jfluidstructs.2012.05.010.
Lee, S. J., and H. B. Kim. 1997. “The effect of surface protrusions on the near wake of a circular cylinder.” J. Wind Eng. Ind. Aerodyn. 69–71: 351–361. https://doi.org/10.1016/S0167-6105(97)00168-2.
Leehey, P., and C. E. Hanson. 1970. “Aeolian tones associated with resonant vibration.” J. Sound Vib. 13 (4): 465–483. https://doi.org/10.1016/S0022-460X(70)80052-9.
Lim, H. C., and S. J. Lee. 2002. “Flow control of circular cylinders with longitudinal grooved surfaces.” AIAA J. 40 (10): 2027–2036. https://doi.org/10.2514/2.1535.
Moeller, M. J., and P. Leehey. 1984. “Unsteady forces on a cylinder in cross flow at subcritical Reynolds numbers.” In Vol. 1 of ASME Symp. on Flow-Induced Vibrations, edited by M. P. Païdoussis, O. M. Griffin, and M. Sevik, 57–71. New York: ASME.
Mohr, K. H. 1981. “Messungen instationären drücke bei queranströmung von kreiszylindern unter berücksichtigung fluidelastischer effekte.” Ph.D. thesis, Zentralbibliothek d. Kernforschungsanlage.
Munson, B. R., F. D. Young, and T. H. Okiis. 2002. Fundamentals of fluid mechanics. 5th ed. New Delhi, India: Wiley.
Mustto, A. A., and G. C. R. Bodstein. 2011. “Subgrid-scale modeling of turbulent flow around circular cylinder by mesh-free vortex method.” Eng. Appl. Comput. Fluid Mech. 5 (2): 259–275. https://doi.org/10.1080/19942060.2011.11015369.
Norberg, C. 2001. “Flow around a circular cylinder: Aspects of fluctuating lift.” J. Fluids Struct. 15 (3–4): 459–469. https://doi.org/10.1006/jfls.2000.0367.
Relf, E. F., and E. F. G. Simmons. 1924. The frequency of eddies generated by the motion of circular cylinders through a fluid. Abingdon, UK: Taylor & Francis Group.
Roshko, A. 1961. “Experiments on the flow past a circular cylinder at very high Reynolds number.” J. Fluid Mech. 10 (3): 345–356. https://doi.org/10.1017/S0022112061000950.
Shih, W. C. L., C. Wang, D. Coles, and A. Roshko. 1993. “Experiments on flow past rough circular cylinders at large Reynolds numbers.” J. Wind Eng. Ind. Aerodyn. 49 (1–3): 351–368. https://doi.org/10.1016/0167-6105(93)90030-R.
Sui, J., J. Wang, S. Liang, and Q. Tian. 2016. “VIV suppression for a large mass-damping cylinder attached with helical strakes.” J. Fluids Struct. 62: 125–146. https://doi.org/10.1016/j.jfluidstructs.2016.01.005.
Szepessy, S., and P. W. Bearman. 1992. “Aspect ratio and end plate effects on vortex shedding from a circular cylinder.” J. Fluid Mech. 234: 191–217. https://doi.org/10.1017/S0022112092000752.
West, G. S., and C. J. Apelt. 1993. “Measurements of fluctuating pressures and forces on a circular cylinder in the Reynolds number range 1045.” J. Fluids Struct. 7 (3): 227–244. https://doi.org/10.1006/jfls.1993.1014.
Wieselsberger, C. 1921. “Neuere feststellungen über die gesetze des flüssigkeits und luftwiderstands.” Phys. Z. 22: 321.
Xu, F., W. L. Chen, Y. Q. Xiao, H. Li, and J. P. Ou. 2014. “Numerical study on the suppression of the vortex-induced vibration of an elastically mounted cylinder by a traveling wave wall.” J. Fluids Struct. 44 (7): 145–165. https://doi.org/10.1016/j.jfluidstructs.2013.10.005.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Feb 2, 2018
Accepted: Jul 9, 2018
Published online: Oct 30, 2018
Published in print: Jan 1, 2019
Discussion open until: Mar 30, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.