Enhancement of Microjitter Attenuation Capability for a Stepper-Actuated Two-Axis Gimbal-Type Antenna by Using a Spring-Blade Isolator
Publication: Journal of Aerospace Engineering
Volume 30, Issue 4
Abstract
A two-axis gimbal-type X-band antenna used to transmit real-time image data from a satellite to a ground station is a potential source of microjitter, which can degrade image quality from high-resolution observation satellites. Activation of discontinuous stepper motors during pointing of the antenna mechanism in the azimuth and elevation directions is one of the primary sources of microjitter disturbances. It is desirable to enhance microjitter attenuation capability by isolating disturbances from stepper motor activation with a reliable technical solution not requiring major design modification of the antenna. In this study, the application of a low-torsional-stiffness spring-blade isolator on the output shaft of the stepper actuator is proposed. The spring-blade isolators were designed based on the derived torque budgets of the antenna, ensuring structural safety of the blades. The design of the spring-blade isolators was verified through structural analysis and a torque measurement test. In addition, the effectiveness of the isolators was demonstrated in a microjitter measurement test of the -band antenna.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by the National Research Foundation of Korea (NRF) grant funded by the Korea government (MSIP) (NRF-2015R1A2A2A01003672).
References
Bialke, B. (2011). “Microvibration disturbance fundamentals for rotating mechanism.” Proc., 34th Annual Guidance and Control Conf., American Astronautical Society, Washington, DC, 417–432.
Cheong, S. H., Kim, T. H., Jung, J. M., Lee, S. G., and Kim, Y. H. (2013). “Design of 2-axis gimbal spaceborne X-band antenna for high data rate payload transmission.” Proc., 2013 Asia-Pacific Microwave Conf., IEEE, New York, 479–481.
ECSS (European Cooperation for Space Standardization). (2009). “Space engineering, mechanism.”, Noordwijk, Netherlands.
Fujita, T., Tagawa, Y., Kajiwara, K., Yoshioka, H., Takeshita, H., and Yasuda, M. (1993). “Active 6-dof microvibration control system using piezoelectric actuators.” 3rd Int. Conf. on Adaptive Structures, SPIE, Bellingham, WA, 514–528.
Kamesh, D., Pandiyan, R., and Ghosal, A. (2012). “Passive vibration isolation of reaction wheel disturbances using a low frequency flexible space platform.” J. Sound Vib., 331(6), 1310–1330.
Kim, D. K., and Choi, H. T. (2014). “Velocity optimization method of X-band antenna for jitter attenuation.” 21st Int. Congress on Sound and Vibration, Korean Society for Aeronautical and Space Sciences, Gangnam-gu, Seoul.
Kozilek, H., Specht, B., Yong, S. S., and Lee, S. G. (2013). “Micro vibration improvement of a stepper actuated mechanism.” 15th European Space Mechanisms and Tribology Symp., Noordwijk, Netherlands.
Lu, X., Wicker, F. D., Towsley, D., Xiong, Z., and Lio, P. (2010). “Detection probability estimation of directional antennas and omni-directional antennas.” Wireless Pers. Commun., 55(1), 51–63.
MSC Patran/Nastran [Computer software]. MSC Software, Santa Ana, CA.
Oh, H. U., Izawa, K., and Taniwaki, S. (2005). “Development of variable damping isolator using bio-metal fiber for reaction wheel vibration isolation.” Smart Mater. Struct., 14(5), 928–933.
Oh, H. U., Jeon, S. H., Kim, T. H., and Kim, Y. H. (2015). “Experimental feasibility study for micro-jitter attenuation of stepper-actuated X-band antenna-pointing mechanism by using pseudoelastic SMA mesh washer.” Smart Mater. Struct., 24(4), .
Oh, H. U., Lee, K. J., and Jo, M. S. (2013). “A passive launch and on-orbit vibration isolation system for the spaceborne cryocooler.” Aerosp. Sci. Technol., 28(1), 324–331.
Oh, H. U., Onoda, J., and Minesugi, K. (2004). “Semiactive isolator with liquid-crystal type ER fluid for momentum-wheel vibration isolation.” J. Vib. Acoust., 126(2), 272–277.
Vaillon, L., and Philippe, C. (1999). “Passive and active microvibration control for very high pointing accuracy space systems.” Smart Mater. Struct., 8(6), 719–728.
Yoshioka, H., and Murai, N. (2002). “An active microvibration isolation system.” Proc., 7th Int. Workshop on Accelerator Alignment, European Synchrotron Radiation Facility, Grenoble, France.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Jun 4, 2016
Accepted: Oct 6, 2016
Published ahead of print: Feb 12, 2017
Published online: Feb 13, 2017
Published in print: Jul 1, 2017
Discussion open until: Jul 13, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.