Case Study of Quantifying Energy Loss through Ceiling-Attic Recessed Lighting Fixtures through 3D Numerical Simulation
Publication: Journal of Architectural Engineering
Volume 23, Issue 1
Abstract
Air leakage through recessed lighting fixtures has been identified as a common issue that causes extra energy consumption in residential buildings. However, few quantitative studies in this area were found. As such, a preliminary assessment of the magnitude of this type of energy loss was conducted by using three-dimensional (3D) transient computational fluid dynamics (CFD) models. A hypothetical layout of recessed lighting fixtures was designed with boundary conditions of four different seasons, which were obtained from recorded roof/attic temperature data sets. The results of the study indicate that leakage of recessed lighting fixtures could be a significant channel of energy loss in such attic-related residential buildings, especially in the summer and winter.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors express sincere appreciation to Dr. Jerrold Winandy for providing the multiyear temperature data collected by the USDA Forest Products Lab. Dr. Winandy retired as project leader in the Engineered Composites Science Research Work Unit at the lab in 2008.
References
ANSYS Fluent 13.0 [Computer software]. ANSYS, Inc., Canonsburg, PA.
Armando, L., and McCarthy, S. (2000). “A recessed can of worms.” 〈http://www.waptac.org/data/files/Website_docs/Training/Standardized_Curricula/Curricula_Resources/Armanda_A-Recessed-Can-of-Worms.pdf〉 (Mar. 1, 2013).
Baechler, M. C., Williamson, J. L., Gilbride, T. L., Cole, P. C., Hefty, M. G., and Love, P. M. (2010). Building America best practices series, Vol. 7.1: Guide to determining climate regions by county (No. PNNL-17211 Rev. 1), Pacific Northwest National Laboratory (PNNL), Richland, WA.
Baker, J., and Lugano, F. (1999). “A passive approach to practical climate control.” Postprints of the wooden artifacts group, American Institute for Conservation of Historic and Artistic Works, Wooden Artifacts Group, Washington, DC, 34–45.
Balaras, C., and Argiriou, A. (2002). “Infrared thermography for building diagnostics.” Energy Build., 34(2), 171–183.
CBSC (California Building Standard Commission). (2013). 2013 California energy code---California Code of Regulations, Title 24, Section 6.3.12, International Code Council, Washington, DC.
Duan, R., et al. (2015). “Mesh type and number for the CFD simulations of air distribution in an aircraft cabin.” Numer. Heat Transfer, Part B, 67(6), 489–506.
Emmerich, S. J., McDowell, T. P., and Anis, W. (2005). “Investigation of the impact of commercial building envelope airtightness on HVAC energy use.” NISTIR 7238, U.S. Dept. of Commerce, Technology Administration, National Institute of Standards and Technology, Washington, DC.
GEC (General Electric Company). (1984). “Incandescent lamps.” Pamphlet TP-110R2, Nela Park, OH.
Home Depot. (2015). “Recessed lighting applications.” 〈http://www.homedepot.com/hdus/en_US/DTCCOM/HomePage/Know_How/Brand_Pages/Lighting_Fans/Halo/Docs/RecessedPlanningPad.pdf〉 (Sep. 30, 2015).
ICC (International Code Council). (2012). “International energy conservation code, section 402.4.” Country Club Hills, IL.
Jokisalo, J., Kalamees, T., Kurnitski, J., Eskola, L., Jokiranta, K., and Vinha, J. (2008). “A comparison of measured and simulated air pressure conditions of a detached house in a cold climate.” J. Build. Phys., 32(1), 67–89.
MATLAB [Computer software]. MathWorks, Natick, MA.
Na, R., Lin, S., Shen, Z., and Gu, L. (2014). “Evaluating energy loss through recessed lighting fixtures (RLF) in residential buildings through a case study.” Proc., 2014 Int. Conf. on Computing in Civil and Building Engineering, ASCE, Reston, VA, 1691–1698.
Persily, A. (2004). “QandA on building security.” ASHRAE J., 46(9), 20–23.
Plympton, P. C., Dagher, L., and Zwack, W. (2007). Industry stakeholder recommendations for DOE's RD&D for increasing energy efficiency in existing homes. National Renewable Energy Laboratory, Golden, CO.
Savers, E. (2006). “Tips on saving money and energy at home.” U.S. Dept. of Energy, Washington, DC.
SBCC (Washington State Building Code Council). (2009). “Washington state building code, section 502.4.4.” Olympia, WA.
Sherman, M. H., and Dickerhoff, D. J. (1998). “Airtightness of U.S. dwellings.” ASHRAE Trans., 104(2), 1359–1367.
U.S. EIA (U.S. Energy Information Administration). (2009). “Structural and geographic characteristics of U.S. homes, by climate region.” 〈http://www.eia.gov/consumption/residential/data/2009/#structural〉 (Mar. 1, 2013).
Van der Meer, B. (2002). “Air leakage in recessed lighting.” Builder brief, Pennsylvania Housing Research/Resource Center, University Park, PA.
Walters, D. K., and Cokljat, D. (2008). “A three-equation eddy-viscosity model for Reynolds-averaged Navier–Stokes simulations of transitional flow.” J. Fluids Eng., 130(12), 121401.
Wang, S., and Shen, Z. (2012a). “Effects of roof pitch on air flow and heating load of sealed and vented attics for gable-roof residential buildings.” Sustainability, 4(9), 1999–2021.
Wang, S., and Shen, Z. (2012b). “Impacts of ventilation ratio and vent balance on cooling load and air flow of naturally ventilated attics.” Energies, 5(129), 3218–3232.
Wang, S., Shen, Z., and Gu, L. (2012). “Numerical simulation of buoyancy-driven turbulent ventilation in attic space under winter conditions.” Energy Build., 47, 360–368.
Winandy, J. E., Barnes, H. M., and Hatfield, C. A. (2000). “Roof temperature histories in matched attics in Mississippi and Wisconsin.” U.S. Dept. of Agriculture, Forest Service, Forest Products Laboratory.
Younes, C., Shdid, C. A., and Bitsuamlak, G. (2012). “Air infiltration through building envelopes: A review.” J. Build. Phys., 35(3), 267–302.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Nov 3, 2015
Accepted: Jun 28, 2016
Published online: Sep 29, 2016
Published in print: Mar 1, 2017
Discussion open until: Mar 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.