Durability Evaluation of Glass Fiber Reinforced-Polymer-Concrete Bonded Interfaces
Publication: Journal of Composites for Construction
Volume 9, Issue 4
Abstract
In this investigation, -long plain concrete beam specimens reinforced with externally bonded wet-laid glass fiber reinforced-polymer sheets are investigated. The specimens are precracked with a three point flexural load, subjected to a constant four point flexural load of about 25% of the initial ultimate moment, and placed into different environmental conditions. The four environmental conditions under investigation are indoor laboratory, outdoor, elevated temperature/dry, and freeze/thaw. By varying the exposure time in different environments and using the photoelastic coating method to evaluate strain distributions, the durability of the externally reinforced concrete beams is evaluated. An innovative approach based on fracture mechanics and local bond shear stress-slip relationships is proposed to explain the degradation mechanism. This approach is capable of qualitatively and quantitatively characterizing the environmental effect in terms of the parameters of the shear stress-slip law. Four one-dimensional shear stress-slip relationships are evaluated in terms of their ability to model the environment-dependent strain distribution and debond data obtained in the present investigation.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This material is based upon work supported by the National Science Foundation under Grants NSF0219484 and NSF9908934. The writers gratefully acknowledge donations of materials by Master Builders Technologies. The able assistance of students Ayca Eminaga, Sally Gimbert, and Young Jong Yum with the experimental program is appreciated.
References
Bizindavyi, L., and Neale, K. W. (1999). “Transfer lengths and bond strengths for composites bonded to concrete.” J. Compos. Constr., 3(4), 153–160.
Brosens, K., and Van Gemert, D. (1997). “Anchoring stresses between concrete and carbon fibre reinforced laminates.” Non-Metallic (FRP) Reinforcement for Concrete Structures, Proc. 3rd Int. Symposium, Vol. 1, JCI, Tokyo, 271–278.
Brown, T. L. (2003). “Long-term durability of concrete reinforced with sheet-bonded fiber reinforced polymers.” MSc thesis, Dept. of Architectural Engineering, The Pennsylvania State University, University Park, Pa.
Chen, J. F., and Teng, J. G. (2001). “Anchorage strength models for FRP and steel plates bonded to concrete.” J. Struct. Eng., 127(7), 784–791.
Dai, J. G., and Ueda, T. (2003). “Local bond stress slip relations for FRP sheets-concrete interfaces.” Proc., Sixth Int. Symposium on FRP Reinforcement for Concrete Structures (FRPRCS), Vol. 1, Singapore, 143–152.
Dally, J. W., and Riley, W. F. (1991). Experimental stress analysis, 3rd Ed., McGraw-Hill, New York.
Fukuzawa, K., Numao, T., Wu, Z., Yoshizawa, H., and Mitsui, M. (1997). “Critical strain energy release rate of interface debonding between carbon fiber sheet and mortar.” Non-Metallic (FRP) Reinforcement for Concrete Structures, Proc. 3rd Int. Symposium, Vol. 1, JCI, Tokyo, 295–302.
GangRao, H., and Barger, J. (2001). “Aging of bond between FRP and concrete cubes.” FRP composites in civil engineering, Vol. II, J.-G. Teng, ed., Elsevier, 1569–1578.
Green, M. F., Bisby, L. A., Beaudoin, Y., and Labossiere, P. (2000). “Effect of freeze-thaw cycles on the bond durability between fibre reinforced polymer plate reinforcement and concrete.” Can. J. Civ. Eng., 27(5), 949–959.
Karbhari, V. M., Engineer, M., and. Eckelii, D. A. (1997). “On the durability of composite rehabilitation schemes for concrete: Use of a peel test.” J. Mater. Sci., 32, 147–156.
Leung, H. Y., Balendran, R. V., and Lim, C. W. (2001). “Flexural capacity of strengthened concrete beams exposed to different environmental conditions.” FRP composites in civil engineering, Vol. II, J.-G. Teng, ed., Elsevier, 1597–1606.
Lopez, M. M., Naaman, A. E., and Till, R. D. (1999). “Bending behavior of reinforced concrete beams strengthened with carbon fiber reinforced polymer laminates and subjected to freeze-thaw cycles.” Fourth Int. Symposium, Fiber Reinforced Polymer Reinforcement for Reinforced Concrete Structures, ACI International SP-188, ACI International, 559–576.
Maeda, T., Asano, Y., Sato, Y., Ueda, T., and Kakuta, Y. (1997). “A study on bond mechanism of carbon fiber sheet.” Non-Metallic (FRP) Reinforcement for Concrete Structures, Proc. 3rd Int. Symposium, Vol. 1, JCI, Tokyo, 279–286.
Miller, B., Nanni, A., and De Lorenzis, L. (2001). “Bond of FRP laminates to concrete.” ACI Mater. J., 98, 246–254.
Murthy, S., Myers, J., and Micelli, F. (2002). “Environmental effects on concrete-FRP bond under various degrees of sustained loading.” CDCC—Int. Conf. on Durability of Fibre Reinforced Polymer (FRP) Composites for Construction, Dept. of Civil Engineering University of Sherbrooke, Sherbrooke, Canada, 333–346.
Nelder, J. A., and Mead, R. (1965). “A simplex method for function minimization.” Comput. J., 7, 308–313.
Savoia, M., Ferracuti, B., and Mazzotti, C. (2003). “Non linear bond-slip law for FRP-concrete interface.” Proc., of the Sixth Int. Symposium on FRP Reinforcement for Concrete Structures (FRPRCS), Vol. 1, World Scientific, Singapore, 163–172.
Täljsten, B. (1996). “Strengthening of concrete prisms using the plate-bonding technique.” Int. J. Fract., 82, 253–266.
Tysl, S. R., Imbrogno, M., and Miller, B. D. (1998). “Effect of surface delamination on the freeze/thaw durability of CFRP-reinforced concrete beams.” CDCC—Int. Conf. on Durability of Fibre Reinforced Polymer (FRP) Composites for Construction, Dept. of Civil Engineering University of Sherbrooke, Sherbrooke, Canada, 317–324.
Wabo, MBrace. (2002). “Chapter 4: Technical data.” Engineering design guidelines, ⟨http://www.wbacorp.com/maiṉpages/mbrace̱design-guide.html⟩ (May 4, 2005).
Wu, Z., Matsuzaki, T., and Tanabe, K. (1997). “Interface crack propagation in FRP-strengthened concrete structures.” Non-Metallic (FRP) Reinforcement for Concrete Structures, Proc. 3rd Int. Symposium, Vol. 1, JCI, Tokyo, 319–326.
Yoshizawa, H., and Wu, Z. (1997). “Analysis of debonding fracture properties of CFS strengthened RC member subject to tension.” Non-Metallic (FRP) Reinforcement for Concrete Structures, Proc. 3rd Int. Symposium, Vol. 1, JCI, Tokyo, 287–294.
Yuan, H., Wu, Z., and Yoshizawa, H. (2001). “Theoretical solutions on interfacial stress transfer of externally bonded steel/composite laminates.” Struct. Eng./Earthquake Eng., 18(1), 27s–39s.
Information & Authors
Information
Published In
Copyright
© 2005 ASCE.
History
Received: Oct 13, 2003
Accepted: Aug 12, 2004
Published online: Aug 1, 2005
Published in print: Aug 2005
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.