Effect of Loading Mode on Strain Softening and Instability Behavior of Sand in Plane-Strain Tests
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 135, Issue 1
Abstract
Experimental data to study the effect of loading mode on the strain softening and instability behavior of sand under plane-strain conditions are presented in this paper. A new plane-strain apparatus was adopted to conduct consolidated drained and undrained tests under both deformation-controlled and load-controlled loading modes. The drained behavior of very loose and medium dense sand and the undrained behavior of very loose sand under plane-strain conditions were characterized. The test results show that the loading mode affects the postpeak behavior and controls whether strain softening or instability will occur in the postpeak region. Shear bands occurred in tests conducted on medium dense sand, but not in tests for very loose sand. The failure line and critical state line are not affected by the loading mode. The study also shows that the concept of a unique “ultimate state” for both dense and loose sand as previously established based on conventional drained triaxial tests is not supported by the plane-strain data.
Get full access to this article
View all available purchase options and get full access to this article.
References
Alshibli, A. K., Batiste, S. N., and Sture, S. (2003). “Strain localization in sand: Plane strain versus triaxial compression.” J. Geotech. Geoenviron. Eng., 129(6), 483–494.
Been, K., Jefferies, M. G., and Hachey, J. E. (1991). “The critical state of sands.” Geotechnique, 35(2), 99–112.
Casagrande, A. (1971). “On liquefaction phenomena.” Geotechnique, 21(3), 197–202.
Chu, J., and Leong, W. K. (2001). “Pre-failure strain softening and pre-failure instability of sand: a comparative study.” Geotechnique, 51(4), 311–321.
Chu, J., Leroueil, S., and Leong, W. K. (2003). “Unstable behaviour of sand and its implication for slope stability.” Can. Geotech. J., 40, 873–885.
Chu, J., and Lo, S.-C. R. (1993). “On the measurement of critical state parameters of dense granular soils.” Geotech. Test. J., 16(1), 27–35.
Chu, J., and Lo, S.-C. R. (1994). “Asymptotic behaviour of a granular soil in strain path testing.” Geotechnique, 44(1), 65–82.
Chu, J., Lo, S.-C. R., and Lee, I. K. (1992). “Strain softening behavior of a granular soil in strain path testing.” J. Geotech. Engrg., 118(2), 191–208.
Chu, J., Lo, S.-C. R., and Lee, I. K. (1996). “Strain softening and shear band formation of sand in multi-axial testing.” Geotechnique, 46(1), 63–82.
DeGregorio, V. B. (1990). “Loading systems, sample preparation, and liquefaction.” J. Geotech. Engrg., 116(5), 805–821.
Desrues, J., and Viggiani, G. (2004). “Strain localization in sand: An overview of the experimental results obtained in Grenoble using stereophotogrammetry.” Int. J. Numer. Analyt. Meth. Geomech., 28, 279–321.
di Prisco, C., Imposimato, C., and Vardoulakis, I. (2000). “Mechanical modelling of drained creep triaxial tests on loose sand.” Geotechnique, 50(1), 73–82.
Drescher, A., and Vardoulakis, I. (1982). “Geometric softening in triaxial tests on granular material.” Geotechnique, 32(4), 291–303.
Drescher, A., Vardoulakis, I. G., and Han, C. (1990). “A biaxial apparatus for testing soils.” Geotech. Test. J., 13(3), 226–234.
Finno, R. J., Harris, W. W., Mooney, M. A., and Viggiani, G. (1997). “Shear bands in plane strain compression of loose sand.” Geotechnique, 47(1), 149–165.
Finno, R. J., Harris, W. W., and Viggiani, G. (1996). “Strain localization and undrained steady state of sand.” J. Geotech. Engrg., 122(6), 462–473.
Fourie, A. B., Blight, G. E., and Papageorgiou, G. (2001). “Static liquefaction as a possible explanation for the Merriespruit tailings dam failure.” Can. Geotech. J., 38, 707–719.
Han, C., and Vardoulakis, I. G. (1991). “Plane-strain compression experiments on water-saturated fine-grained sand.” Geotechnique, 41(1), 49–78.
Hettler, A., and Vardoulakis, I. (1984). “Behavior of dry sand tested in a large triaxial apparatus.” Geotechnique, 34(2), 183–197.
Hird, C. C., and Hassona, F. A. K. (1990). “Some factors affecting the liquefaction and flow of saturated sands in laboratory tests.” Eng. Geol. (Amsterdam), 28, 149–170.
Lade, P. V. (1992). “Static instability and liquefaction of loose fine sandy slopes.” J. Geotech. Engrg., 118(1), 51–71.
Lade, P. V., and Pradel, D. (1990). “Instability and flow of granular materials. I: Experimental observations.” J. Eng. Mech., 116(11), 2532–2550.
Lambe, T. W., and Whitman, R. V. (1979). Soil mechanics, SI version, Wiley, New York.
Leong, W. K., Chu, J., and Teh, C. I. (2000). “Liquefaction and instability of a granular fill material.” Geotech. Test. J., 23(2), 178–192.
Lindenberg, J., and Koning, H. L. (1981). “Critical density of sand.” Geotechnique, 31(2), 231–245.
Lo, S.-C. R., and Chu, J. (1991). “The measurement of by triaxial strain path testing.” Soils Found., 31(2), 181–187.
Lo, S.-C. R., Chu, J., and Lee, I. K. (1989). “A technique for reducing membrane penetration and bedding errors.” Geotech. Test. J., 12(4), 311–316.
Lundgren, R., Mitchell, J. K., and Wilson, J. H. (1968). “Effects of loading method on triaxial test results.” J. Soil Mech. and Found. Div., 94(2), 407–419.
Marachi, N. D., Duncan, J. M., Chan, C. K., and Seed, H. B. (1981). “Plane-strain testing of sand,” Laboratory Shear Strength of Soil, ASTM Special Technical Publication 740, R. N. Yong, and F. C. Townsend, eds., ASTM, Philadelphia, 294–302.
Martin, G. R. (1998). “Post-liquefaction shear strength from laboratory and field tests.” Proc., National Science Foundation Workshop on Shear Strength of Liquefied Soils, National Science Foundation, Urbana, Ill., 40–52.
Mokni, M., and Desrues, J. (1998). “Strain localisation measurements in undrained plane-strain biaxial tests on Hostun RF sand.” Mech. Cohesive-Frict. Mater., 4, 419–441.
Peric, D., Runesson, K., and Sture, S. (1992). “Evaluation of plastic bifurcation results for plane strain versus axisymmetry,” J. Eng. Mech., 118(3), 512–524.
Poulos, S. J., Castro, G., and France, J. W. (1985). “Liquefaction evaluation procedure.” J. Geotech. Engrg., 111(6), 772–792.
Prashant, A., and Penumadun, D. (2004). “Effect of intermediate principal stress on overconsolidated kaolin clay.” J. Geotech. Geoenviron. Eng., 130(3), 284–292.
Rowe, P. W., and Barden, L. (1964). “Importance of free ends in triaxial testing.” J. Soil Mech. and Found. Div., 90(1), 1–15.
Sladen, J. A., D’Hollander, R. D., Krahn, J., and Mitchell, D. E. (1985). “Back analysis of the Nerlerk berm liquefaction slides.” Can. Geotech. J., 22, 579–588.
Wanatowski, D. (2005). “Strain softening and instability of sand under plane-strain conditions.” Ph.D. thesis, Nanyang Technological Univ., Singapore.
Wanatowski, D., and Chu, J. (2006). “Stress-strain behavior of a granular fill measured by a new plane-strain apparatus.” Geotech. Test. J., 29(2), 149–157.
Wang, Q., and Lade, P. V. (2001). “Shear banding in true triaxial tests and its effect on failure in sand.” J. Eng. Mech., 127(8), 754–761.
Yamamuro, J. A., and Lade, P. V. (1998). “Steady-state concepts and static liquefaction of silty sands.” J. Geotech. Geoenviron. Eng., 124(9), 868–877.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Apr 18, 2006
Accepted: May 19, 2008
Published online: Jan 1, 2009
Published in print: Jan 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.