Multiscale Modeling of Flood-Induced Piping in River Levees
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 134, Issue 9
Abstract
A three-dimensional transient fully coupled fluid-particle model is utilized to simulate flood-induced piping under river levees and taking into account the effects of soil-fluid-structure interactions. The porous soil medium is modeled as a mixture of two phases, namely the fluid phase (water) and the particulate solid phase. The fluid is idealized as a continuum by using an averaged form of Navier–Stokes equations that accounts for the presence of the solid particles. These particles are modeled at a microscale using the discrete element method. The interphase momentum transfer is modeled using an established relationship that accounts for the dynamic change in porosity and possible occurrence of nonlinear losses. The hydraulic structure (levee) is modeled as an impervious rigid block and its motion is described by a combination of external and internal forces from the surrounding fluid and solid particles. A computational simulation is conducted to investigate the response of a granular deposit when subjected to a rapidly increasing head difference. The simulation provided information at the microscale level for the solid phase as well as at the macroscopic level for the pore-water flow. The settlement and failure mechanism of the structure were captured as the hydraulic head difference gradually increased and the solid phase underwent subsequent deformations. The results suggest that failure of such structures may occur suddenly and at hydraulic gradients well below the critical gradient. The proposed computational framework for analyzing river and flood-protection levees would provide a new dimension to the design of such vital geotechnical systems. The technique can be effectively used to investigate failure mechanisms under complex loading and flow conditions.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by the Louisiana Board of Regents Support Fund, Grant No. UNSPECIFIEDLEQSF(2005-07)-RD-A-32. This support is gratefully acknowledged. The writers would also like to thank anonymous reviewers for helpful suggestions and valuable remarks that helped improve the manuscript for this paper.
References
Anderson, T., and Jackson, R. (1967). “A fluid mechanical description of fluidized beds.” Ind. Eng. Chem. Fundam., 6(4), 527–539.
Aydin, F. (2007). “Micromechanical simulations of flood-induced piping in river levees.” Master’s thesis, Tulane Univ., New Orleans.
Carman, P. (1937). “Fluid flow through granular beds.” Trans. Inst. Chem. Eng., 15, 150–166.
Cleary, J., Sinnott, M., and Morrison, R. (2006). “Prediction of slurry transport in SAG mills using sph fluid flow in a dynamic DEM based porous media.” Minerals Eng., 19(15), 1517–1527.
Cundall, P. A., and Strack, O. D. L. (1979). “A discrete numerical model for granular assemblies.” Geotechnique, 29(1), 47–65.
Darcy, H. (1856). Les fontaines publiques de la vile de Dijon, Victor Dalmont, Paris (in French).
El Shamy, U. (2004). “A coupled continuum-discrete fluid-particle model for granular soil liquefaction.” Ph.D. thesis, Rensselaer Polytechnic Institute, Troy, N.Y.
El Shamy, U., and Zeghal, M. (2005). “Coupled continuum-discrete model for saturated granular soils.” J. Eng. Mech., 131(4), 413–426.
Ergun, S. (1952). “Fluid flow through packed columns.” Chem. Eng. Process., 43(2), 89–94.
Forchheimer, P. (1901). “Wasserbewegung durch Boden.” Zeitschrift des Vereines Deutscher Ingenieure, 45(6), 1782–1788 (in German).
Geo-Slope International Ltd. (2004). SEEP/W, finite element seepage analysis—GeoStudio version 6.19, Alberta, Canada, Student License.
Griffiths, D. V., and Fenton, G. A. (1993). “Seepage beneath water retaining structures founded on spatially random soil.” Geotechnique, 43(4), 577–587.
Griffiths, D. V., and Fenton, G. A. (1997). “Three-dimensional seepage through spatially random soil.” J. Geotech. Geoenviron. Eng., 123(2), 153–160.
Griffiths, D. V., and Fenton, G. A. (1998). “Probabilistic analysis of exit gradients due to steady seepage.” J. Geotech. Geoenviron. Eng., 124(9), 789–797.
Harlow, F., and Welch, J. (1965). “Numerical calculation of time-dependent viscous incompressible flow of fluid with free surface.” Phys. Fluids, 8, 2182–2189.
Hoomans, B. P. H., Kuipers, J. A. M., Briels, W. J., and van Swaaij, W. P. M. (1996). “Discrete particle simulation of bubble and slug formation in a two-dimensional gas fluidised bed: A hard-sphere approach.” Chem. Eng. Sci., 51(1), 99–118.
Interagency Performance Evaluation Task Force (I.P.E.T). (2006). “Performance evaluation of the New Orleans and Southeast Louisiana hurricane protection system.” Final Draft, U.S. Army Corps of Engineers, Waterways Experiment Station, Vicksburg, Miss.
Itasca Consulting Group. (2005). Particle flow code, PFC3D, release 3.1, Minneapolis.
Jackson, R. (2000). The dynamics of fluidized particles, Cambridge University Press, London.
Jiang, M., Yu, H.-S., and Harris, D. (2006). “Discrete element modeling of deep penetration in granular soils.” Int. J. Numer. Analyt. Meth. Geomech., in press.
Kafui, K. D., Thornton, C., and Adams, M. J. (2002). “Discrete particle-continuum fluid modeling of gas-solid fluidised beds.” Chem. Eng. Sci., 57, 2395–2410.
Kawaguchi, T., Tanaka, T., and Tsuji, Y. (1998). “Numerical simulation of two-dimensional fluidized beds using the discrete element method (comparison between the two- and three-dimensional models).” Powder Technol., 96, 129–138.
Koo, M. H., and Leap, D. I. (1998). “Modeling three-dimensional groundwater flows by the body-fitted coordinate (BFC) method: II. Free and moving boundary problems.” Transp. Porous Media, 30(3), 345–362.
Kutter, B. (1992). “Dynamic centrifuge modeling of geotechnical structures.” Transportation Research Record. 1336, Transportation Research Board, Washington, D.C., 24–30.
Lewis, R. W., and Schrefler, B. A. (1998). The finite element method in the deformation and consolidation of porous media, 2nd Ed., Wiley, New York.
Lu, Z., and Zhang, D. (2002). “Stochastic analysis of transient flow in heterogeneous, variably saturated porous media: The van Genucten-Mualem constitutive model.” Vadose Zone Journal, 1, 137–149.
Nath, B. (1981). “A novel finite element method for seepage analysis.” Int. J. Numer. Analyt. Meth. Geomech., 5, 139–163.
Ojha, C. S. P., Singh, V. P., and Adrian, D. D. (2001). “Influence of porosity on piping models of levee failure.” Chin. J. Catal., 127(12), 1071–1074.
Ojha, C. S. P., Singh, V. P., and Adrian, D. D. (2003). “Determination of critical head in soil piping.” J. Hydraul. Eng., 129(7), 511–518.
Oner, M., Dawkins, W. P., Mosher, R., and Hallal, I. (1997). “Soil-structure interaction effects in floodwalls.” Electronic Journal of Geotechnical Engineering, http://www.ejge.com/1997/Ppr9707/Ppr9707.htm .
Ozkan, S. (2003). “Analytical study on flood induced seepage under river levees.” Ph.D. thesis, Louisiana State Univ., Baton Rouge, La.
Peter, P. (1974). “Piping problem in the Danube valley in Czechoslovakia.” Proc., 4th Danube European Conf., SMFE, Bled, Slovenia, 35–40.
Potapov, A., Hunt, M., and Campbell, C. (2001). “Liquid-solid flows using smoothed particle hydrodynamics and the discrete element method.” Powder Technol., 116, 204–213.
Seed, R. B., et al. (2006). “Investigation of the performance of the New Orleans flood protection systems in Hurricane Katrina on August 29, 2005.” Final Rep., Univ. of California at Berkeley, Berkeley, Calif.
Sellmeijer, J. (1988). “On the mechanism of piping under impervious structures.” Ph.D. thesis, Technical Univ. Delft, Delft, The Netherlands.
Sellmeijer, J. B., and Koenders, M. A. (1991). “A mathematical model for piping.” Appl. Math. Model., 15(6), 646–651.
Skempton, A. W., and Brogan, J. M. (1994). “Experiments on piping in sandy gravels.” Geotechnique, 44(3), 449–460.
Terzaghi, K., and Peck, R. (1967). Soil mechanics in engineering practice, Wiley, New York.
Tomlinson, S. S., and Vaid, Y. P. (2000). “Seepage forces and confining pressure effects on piping erosion.” Can. Geotech. J., 37, 1–13.
Trussell, R., and Chang, M. (1999). “Review of flow through porous media as applied to head loss in water filters.” J. Environ. Eng., 125(11), 998–1006.
Tsuji, Y., Kawaguchi, T., and Tanaka, T. (1993). “Discrete particle simulation of two-dimensional fluidized bed.” Powder Technol., 77, 79–87.
Turnbull, W. J., and Mansur, C. I. (1961). “Investigation of underseepage—Mississippi river levees.” Trans. Am. Soc. Civ. Eng., 126(1), 1429–1485.
Van Zyl, D., and Harr, M. (1981). “Seepage erosion analysis of structures.” Proc., 10th Int. Conf. on Soil Mechanics and Foundation Engineering, Stockholm, Sweden, Balkema, Rotterdam, The Netherlands, 503–509.
Weijers, J. B. A., and Sellmeijer, J. B. (1993). “A new model to deal with the piping mechanism.” Filters in Geotechnical and Hydraulic Engineering, Proc., 1st Int. Conf. “Geo-Filters,” Karlsruhe, Germany, Balkema, Rotterdam, The Netherlands, 349–355.
Wolff, T. F. (1997). “Geotechnical reliability of levees.” Proc., Hydrology and Hydraulics Workshop on Risk-Based Analysis for Flood Damage Reduction Studies, U.S. Army Corps of Engineers, Hydrologic Engineering Center, Davis, Calif., Paper 6.
Zeghal, M., and El Shamy, U. (2004). “A continuum-discrete hydromechanical analysis of granular deposit liquefaction.” Int. J. Numer. Analyt. Meth. Geomech., 28, 1361–1383.
Zhu, Y., Fox, P., and Morris, J. (1999). “A pore-scale numerical model for flow through porous media.” Int. J. Numer. Analyt. Meth. Geomech., 23, 881–904.
Zienkiewicz, O. C., Chan, A. H. C., Pastor, M., Schrefler, B. A., and Shiomi, T. (1998). Computational geomechanics with special reference to earthquake engineering, Wiley, West Sussex, U.K.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 134 • Issue 9 • September 2008
Pages: 1385 - 1398
Copyright
© 2008 ASCE.
History
Received: Feb 13, 2007
Accepted: Jan 7, 2008
Published online: Sep 1, 2008
Published in print: Sep 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.