Deeply Buried Thermoplastic Pipe Field Performance over Five Years
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 134, Issue 8
Abstract
This paper presents the updated long-term field performance data from the thermoplastic pipe deep burial study that the writers first initiated in the summer of 1999. The data from the past four to five years are presented in terms of pipe deflections and soil pressure measured at the pipe crown. Examinations of the historic field performance data revealed pipe-soil interaction behavior that had not been reported previously. The long-term pipe performance of both polyvinyl chloride and high density polyethylene pipes installed under at least of soil fill was characterized with nearly constant deflections/circumferential shortening and fluctuating soil pressures. Review of the long-term soil pressure data revealed some interesting trends regarding the relationships among pipe material type, pipe wall design, and fill height. Detailed review of the soil pressure data also led to a reasonable speculation that the seasonal fluctuations of environmental (air temperature, soil moisture) conditions caused the fluctuations in the peripheral soil pressure. Theoretical analysis based on the full-field elastic solutions showed that the temperature most likely had a much larger influence on the soil pressure fluctuations than the changes in the soil moisture conditions.
Get full access to this article
View all available purchase options and get full access to this article.
References
Adams, D. N., Muindi, T., and Selig, E. T. (1988). “Polyethylene pipe under high fill.” Transportation Research Record. 1231, National Research Council, Washington, D.C., 88–95.
Burns, J. Q., and Richard, R. M. (1964). “Attenuation of stresses for buried cylinders.” Proc., of Symp. on Soil-Structure Interaction, Engineering Research Laboratory, Univ. of Arizona, Tucson, Ariz., 378–392.
Chambers, R. E., McGrath, T. J., and Heger, F. J. (1980). “Plastic pipe for subsurface drainage of transportation facilities.” National Cooperative Highway Research Program (NCHRP) Rep. No. 225, Transportation Research Board (TRB), National Research Council, Washington, D.C.
Chua, K. M., and Lytton, R. L. (1989). “Viscoelastic approach to modeling performance of buried pipes.” J. Transp. Eng., 115(3), 253–269.
Dhar, A. S., and Moore, I. D. (2002). “Corrugated high-density polyethylene pipe—Laboratory testing and two-dimensional analysis to develop limit states design.” Transportation Research Record. 1814, National Research Council, Washington, D.C., 157–163.
Geokon, Inc. (2007). Model 4800E/C total pressure cell—Instruction manual, Lebanon, N.H.
Hoeg, K. (1966). “Pressure distribution on underground structural cylinder.” Rep. No. AFWL-TR-65-98, Final Rep. to U.S. Air Force Weapons Laboratory, Research and Technology Division, Air Force Systems Command, Kirtland Air Force Base, N.M.
Janson, L. E. (1990). “Short-term versus long-term pipe ring stiffness in the design of buried plastic sewer pipes.” Proc., Int. Conf. on Pipeline Design and Installation, ASCE, New York, 160–167.
Koerner, R. M. (1994). Designing with geosynthetics, 3rd Ed., Prentice- Hall, Upper Saddle River, N.J.
Masada, T., and Sargand, S. M. (2007). “Peaking deflections of flexible pipe during initial backfilling process.” J. Transp. Eng., 133(2), 105–111.
Moser, A. P., Bishop, R. R., Shupe, O. K., and Bair, D. R. (1985). “Deflection and strains in buried FRP pipes subjected to various installation conditions.” Transportation Research Record. 1008, National Research Council, Washington, D.C., 109–116.
Mwanang’onze, H., Moore, I. D., and Green, M. (2003). “Coefficient of thermal expansion coefficient for plain polyethylene pipe.” Proc., Pipelines 2003 Conf., Vol. 2, ASCE, Roston, Va., 1302–1311.
Petroff, L. J. (1990). “Stress relaxation characteristics of the HDPE pipe-soil system.” Proc., Int. Conf. on Pipeline Design and Installation, ASCE, New York, 280–294.
Rogers, C. D. F. (1988). “Some observations on flexible pipe response to load.” Transportation Research Record. 1191, National Research Council, Washington, D.C., 1–11.
Sargand, S. M., Hazen, G. A., and Masada, T. (2002a). “Field verification of structural performance of thermoplastic pipe under deep backfill conditions.” FHWA/OH-2002/023 Final Rep. to Ohio Dept. of Transportation and Federal Highway Administration.
Sargand, S. M., and Masada, T. (1996). “Influence of rib spacing on deflection performance of profile-wall plastic pipe.” Geotech. Test. J., 19(2), 217–222.
Sargand, S. M., and Masada, T. (2000). “Performance of large-diameter honeycomb-design HDPE pipe under a highway embankment.” Can. Geotech. J., 37, 1099–1108.
Sargand, S. M., and Masada, T. (2006). “Long-term monitoring of pipe under deep cover.” Draft Final Rep. to Ohio Dept. of Transportation, Civil Engineering Dept., Ohio Univ., Athens, Ohio.
Sargand, S. M., Masada, T., and Gruver, D. (2003a). “Thermoplastic pipe deep-burial project in Ohio: Initial findings.” Proc., Pipeline 2003 Conf., Vol. 2, ASCE, Reston, Va., 1288–1301.
Sargand, S. M., Masada, T., and Schehl, D. (2001). “Soil pressure measured at various fill heights above deeply buried thermoplastic pipe.” Transportation Research Record. 1770, National Research Council, Washington, D.C., 227–235.
Sargand, S. M., Masada, T., Tarawneh, B., and Gruver, D. (2005). “Field performance and analysis of large-diameter high-density polyethylene pipe under deep soil fill.” J. Geotech. Geoenviron. Eng., 131(1), 39–51.
Sargand, S. M., Masada, T., Tarawneh, B., and Hanna, Y. (2004). “Use of soil stiffness gauge in thermoplastic pipe installation.” J. Transp. Eng., 130(6), 768–776.
Sargand, S. M., Masada, T., White, K. E., and Altarawneh, B. (2002b). “Profile-wall high-density polyethylene pipes in diameter under deep soil cover: Comparisons of field performance data and analytical predictions.” Transportation Research Record. 1814, National Research Council, Washington, D.C., 186–196.
Sargand, S. M., Masada, T., White, K. E., and Altarawneh, B. (2003b). “Soil arching over deeply buried thermoplastic pipe.” Transportation Research Record. 1849, National Research Council, Washington, D.C., 109–123.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Oct 31, 2005
Accepted: Dec 17, 2007
Published online: Aug 1, 2008
Published in print: Aug 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.