Improved Approach to Construct Constitutive Surfaces for Stable-Structured Soils Covering Both Saturated and Unsaturated Conditions
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 134, Issue 6
Abstract
Constitutive surfaces are indispensable for investigation of the behavior of soils. Saturated and unsaturated soils coexist in most engineering problems and it is meaningful to develop constitutive surfaces covering both saturated and unsaturated conditions which help to investigate the behavior for both saturated and unsaturated soils in a unified way. At present, the methodologies used for saturated and unsaturated soils are different and few researchers consider the constitutive surfaces for saturated soils. For unsaturated soils, the suction-controlled triaxial tests are usually laborious, time consuming, costly, and may not justify routine engineering projects. This paper discusses the role of constitutive surfaces in soil mechanics and presents an improved approach over existing interpolation methods to construct the constitutive surfaces for saturated and unsaturated conditions for a stable-structured soil using simple laboratory tests.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was sponsored by the Spencer J. Buchanan Professorship at Texas A&M University. The writers gratefully thank Dr. Robert L. Lytton and Dr. Charles Aubeny for their valuable discussions and suggestions.
References
Alonso, E. E., Gens, A., and Josa, A. (1990). “A constitutive model for partially saturated soils.” Geotechnique, 40(3), 405–430.
Alonso, E. E., Vaunat, J., and Gens, A. (1999). “Modeling the mechanical behavior of expansive clays.” Eng. Geol. (Amsterdam), 54(1–2), 173–183.
ASTM. (1993a). “Standard test method for capillary-moisture relationships for coarse and medium textured soils by porous plate apparatus.” ASTM D 2325-68, 1993 annual book of ASTM standards, Philadelphia.
ASTM. (1993b). “Standard test method for one-dimensional swell or settlement potential of cohesive soils.” ASTM D4546-96, 1993 annual book of ASTM standards, Philadelphia.
ASTM. (1993c). “Standard test methods for specific gravity of soil solids by water pycnometer.” ASTM D 854, 1993 Annual book of ASTM standards, Philadelphia.
Briaud, J. L., Zhang, X., and Moon, S. (2003). “The shrink test—Water content method for shrink and swell predictions.” J. Geotech. Geoenviron. Eng., 129(7), 590–600.
Bishop, A. W. (1959). “The principle of effective stress.” Tek. Ukeblad, 33, 859–863.
Dakshinamurthy, V., Fredlund, D. G., and Rahardjo, H. (1984). “Coupled three-dimensional consolidation theory of unsaturated porous media.” Proc., 5th Int. Conf. Expansive Soils, Institute of Engineers, Adelaide, South Australia, 99–104.
Delage, P., and Graham, J. (1996). “State-of-the-art report: Understanding the behavior of unsaturated soils requires reliable conceptual models.” Proc., of 1st Int. Conf. on Unsaturated Soils, UNSAT’ 95, E. E. Alonso and P. Delage, eds., Vol. 3, Balkema, Rotterdam, The Netherlands, 1223–1256.
Escario, V. (1969). “Swelling of soils in contact with water at a negative pressure.” Proc., 2nd Int. Conf. Expansive Soils, Texas A&M Univ., College Station, Tex., 207–217.
Fredlund, D. G., and Rahardjo, H. (1993). Soil mechanics for unsaturated soils, Wiley, New York.
Fredlund, M. D. (2000). “The role of unsaturated soil property functions in the practice of unsaturated soil mechanics.” Ph.D. dissertation, Univ. of Saskatchewan, Saskatoon, Canada.
Ho, D. Y. F., Fredlund, D. G., and Rahardjo, H. (1992). “Volume change indices during loading and unloading of an unsaturated soil.” Can. Geotech. J., 29(2), 195–207.
Lloret, A., and Alonso, E. E. (1985). “State surfaces for partially saturated soils.” Proc., 11th Int. Conf., SMFE, Vol. 2, Balkema, Rotterdam, The Netherlands, 557–562.
Lloret, A., Villar, M. V., Sánchez, M., Gens, A., Pintado, X., and Alonso, E. E. (2003). “Mechanical behavior of heavily compacted bentonite under high suction changes.” Geotechnique, 53(1), 27–40.
Matyas, E. L. (1969). “Some properties of two expansive clays from western Canada.” Proc. 2nd Int. Conference on Expansive Soils, S. J. Buchanan, ed., Texas A&M University Press, College Station, Tex., 263–278.
Matyas, E. L., and Radhakrishna, H. S. (1968). “Volume change characteristics of partially saturated soils.” Geotechnique, 18(4), 432–448.
Pham, Q. H. (2005). “A volume-mass constitutive model for unsaturated soils.” Ph.D. dissertation, Univ. of Saskatchewan, Saskatoon, Canada.
Roscoe, K. H., and Burland, J. B. (1968). “On the generalized stress-strain behavior of ‘wet’ clay.” Engineering plasticity, J. Heyman and F. A. Leckie, eds., Cambridge University Press, Cambridge, U.K., 535–609.
Sharma, R. S. (1998). “Mechanical behaviour of unsaturated highly expansive clays.” D.Phil. thesis, Univ. of Oxford, Oxford, U.K.
Terzaghi, K. (1936). “The shear resistance of saturated soils.” Proc., 1st Int. Conf. Soil Mechanics Foundation Engineering, Vol. 1, Cambridge, Mass., 54–56.
Vu, H. Q., and Fredlund, D. G. (2006). “Challenges to modelling heave in expansive soils.” Can. Geotech. J., 43(12), 1249–1272.
Wheeler, S. J. (1996). “Inclusion of specific water volume within an elastoplastic model for unsaturated soils.” Can. Geotech. J., 33, 42–57.
Zhang, X. (2004). “Consolidation theories for saturated-unsaturated soils and numerical simulations of residential buildings on expansive soils.” Ph.D. dissertation, Texas A&M Univ., College Station, Tex.
Zhang, X., and Lytton, R. L. (2006). “Stress state variables for saturated and unsaturated soils.” Proc., 4th Int. Conf. on Unsaturated Soils, April 2006, Carefree, Ariz., Geotechnical Special Publication No. 147, 2380–2391, ASCE, Reston, Va.
Zhang, X., and Lytton, R. L. (2007a). “Discussion of ‘Analysis of deep moisture barriers in expansive soils. I: Constitutive model formulation’ by Rojas et al. October 2006.” Int. J. Geomech., in press.
Zhang, X., and Lytton, R. L. (2007b). “Discussion of ‘Analysis of deep moisture barriers in expansive soils. II: Water flow formulation and implementation’ by Rojas et al. October 2006.” Int. J. Geomech., in press.
Zhang, X., and Lytton, R. L. (2007c). “Modeling of coupled hydro-mechanical behavior using modified state surface approach.” Can. Geotech. J., under review.
Zhang, X., and Lytton, R. L. (2007d) “Use of state surface approach to explain the Barcelona basic model.” Proc., Int. Conf. 2007 Mechanics of Unsaturated Soils, Springer, Berlin, 101–107.
Zhang, X., Lytton, R. L., and Briaud, J. L. (2005). “Coupled consolidation theory for saturated-unsaturated soils.” Proc., 3rd Biot Conf. on Poromechanics (Biot Centennial), Y. Abousleiman, A. H.-D. Cheng, and F.-J. Ulm, eds., Univ. of Oklahoma, Norman, Okla., 323–330.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 134 • Issue 6 • June 2008
Pages: 876 - 882
Copyright
© 2008 ASCE.
History
Received: Dec 28, 2004
Accepted: Aug 27, 2007
Published online: Jun 1, 2008
Published in print: Jun 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.