Predicting the Erosion Rate of Chemically Treated Soil Using a Process Simulation Apparatus for Internal Crack Erosion
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 134, Issue 6
Abstract
Chemical stabilization is an effective ground improvement technique for controlling erosion. Two stabilizers, lignosulfonate and cement, were used to study how effectively they could stabilize erodible silty sand collected from Wombeyan Caves, NSW, Australia. To conduct this research, four dosages of cement (0.5, 1, 1.5, and 2%) and four dosages of lignosulfonate (0.1, 0.2, 0.4, and 0.6%) by dry weight of soil were selected. All treated and untreated soil specimens were compacted to 90 and 95% of their maximum dry density to study the effect of compaction level on erodibility. The erosion characteristics of treated and untreated soil samples were investigated using a process simulation apparatus for internal crack erosion designed and built at the University of Wollongong. The findings of this study indicated that both chemical stabilizers increased the resistance to erosion because of their cementing properties. It was also found that the critical shear stress increased linearly with the amount of stabilizer, and the coefficient of soil erosion decreased as a power function of the critical shear stress.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers express their gratitude to Ian Laird and Alan Grant, geotechnical laboratory technicians at the University of Wollongong for their assistance in setting up the PSAICE. The initial support for this research provided by the Chemstab Consulting Pty. Ltd, Australia is also acknowledged.
References
Arulanandan, K., Krone, R. B., and Loganathan, P. (1975). “Pore and eroding fluid influences on surface erosion on soil.” J. Geotech. Engrg. Div., 101, 51–66.
Biggs, A. J. W., and Mahony, K. M. (2004). “Is soil science relevant to road infrastructure?” Proc., 13th Int. Soil Conservation Organization Conf. (ISCO)—Brisbane, Conserving Soil and Water for Society: Sharing Solutions, Brisbane, Australia, Paper No. 410.
Chemstab Consulting Pty Ltd. (2003). Technical manual, Horsley, NSW, Australia.
Christensen, R. W., and Das, B. M. (1973). “Hydraulic erosion of remolded cohesive soils.” Soil Erosion: Causes and Mechanisms; Prevention and Control, Special Rep. No. 135, Highway Research Board, Washington, D.C., 8–19.
Cole, B. A., Ratanasen, C., Maiklad, P., Liggins, T. B., and Chirapunthu, S. (1977). “Dispersive clay in irrigation dams in Thailand.” ASTM Spec. Tech. Publ., 623, 25–41.
Fell, R., Wan, C. F., Cyganiewicz, J., and Foster, M. (2003). “Time for development of internal erosion and piping in embankments dams.” J. Geotech. Geoenviron. Eng., 129(4), 307–314.
Indraratna, B. (1996). “Utilization of lime, slag and fly ash for improvement of a colluvial soil in New South Wales, Australia.” Geotech. Geologic. Eng., 14, 169–191.
Indraratna, B., Nutalaya, P., and Kugamenthira, N. (1991). “Stabilization of a dispersive soil by blending with fly ash.” Q. J. Eng. Geol., 24, 275–290.
Karol, R. H. (2003). Chemical grouting and soil stabilization, 3rd Ed., Marcel Dekker, New York.
Pengelly, A. D., Boehm, D. W., Rector, E., and Welsh, J. P. (1997). “Engineering experience with in-situ modification of collapsible and expansive soils.” Unsaturated Soil Engineering Practice, ASCE Geotechnical Special Publication No. 68, 277–298.
Perry, J. P. (1977). “Lime treatment of dams constructed with dispersive clay soils.” Trans. ASAE, 20, 1093–1099.
Phillips, J. T. (1977). “Case histories of repairs and designs for dams built with dispersive clay.” ASTM Spec. Tech. Publ., 623, 330–340.
Puppala, A. J., and Hanchanloet, S. (1999). “Evaluation of a new chemical (SA-44/LS-40) treatment method on strength and resilient properties of a cohesive soil.” Proc., Transportation Research Board Annual Meeting, Transportation Research Board, Washington, D.C.
Reddi, L. N., Lee, I. M., and Bonala, M. V. S. (2000). “Comparison of internal and surface erosion using flow pump tests on a sand-kaolinite mixture.” Geotech. Test. J., 23(1), 116–122.
Sargunan, A. (1977). “Concept of critical shear stress in relation to characterization of dispersive clays.” ASTM Spec. Tech. Publ., 623, 390–397.
Shaikh, A., Ruff, J. F., Charlie, W. A., and Abt, S. R. (1988). “Erosion rate of dispersive and non-dispersive clays.” J. Geotech. Engrg., 114(5), 589–600.
Shulga, G., Rekner, F., and Varslavan, J. (2001). “Lignin based inter polymer complexes as a novel adhesive for protection against erosion of sandy soil.” J. Agric. Eng. Res., 78(3), 309–316.
Tingle, J. S., and Santori, R. L. (2003). “Stabilization of clay soils with nontraditional additives.” Transportation Research Record. 1819, Transportation Research Board, Washington, D.C., 72–84.
U.S. Army Corps of Engineers (USACE). (1995). Manual on chemical grouting, No. EM 1110-1-3500, paragraph 2–6, Washington, D.C.
Wan, C. F., and Fell, R. (2004). “Investigation of erosion rate of soils in embankment dams.” J. Geotech. Geoenviron. Eng., 130(4), 373–380.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Oct 24, 2006
Accepted: Sep 21, 2007
Published online: Jun 1, 2008
Published in print: Jun 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.