Critical State of Granular Materials Based on the Sliding-Rolling Theory
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 134, Issue 1
Abstract
By representing the assembly by a simplified column model, a constitutive theory was recently developed for a two-dimensional assembly of rods. This theory, referred to as the sliding-rolling theory, is extended in this paper to represent the triaxial stress-strain behavior of granular materials. The sliding-rolling theory provides a dilatancy rule and an expression for the slope of the line of zero dilatancy in the stress space. These rules are then combined with triaxial observations to provide a microstructural interpretation of the critical state of granular materials. According to the theory, the slope of the critical state line in the stress space depends on the interparticle friction angle and the degree of contact normal anisotropy. To verify the basic ideas of the sliding-rolling theory, numerical experiments are conducted using the discrete-element method on three-dimensional assemblies of spheres.
Get full access to this article
View all available purchase options and get full access to this article.
References
Anandarajah, A. (1994). “Discrete-element method for simulating behavior of cohesive soil.” J. Geotech. Engrg., 120(9), 1593–1613.
Anandarajah, A. (2004). “Sliding and rolling constitutive theory for granular materials.” J. Eng. Mech., 130(6), 665–680.
Anandarajah, A., and Kuganenthira, N. (1995). “Some aspects of fabric anisotropy of soils.” Geotechnique, 45(1), 69–81.
Arulmoli, K., Muraleetharan, K. K., Hossain, M. M., and Fruth, L. S. (1992). VELACS—Verification of Liquefaction Analysis by Centrifuge Studies: Laboratory Testing Program Soil Data Rep., U.S. National Science Foundation.
Balendran, B., and Nemat-Nasser, S. (1993). “Double sliding model for cyclic deformation of granular materials, including dilatancy effects.” J. Mech. Phys. Solids, 41(3), 573–612.
Bardet, J. P. (1994). “Numerical simulations of the incremental responses of idealized granular materials.” Int. J. Plast., 10(8), 879–908.
Brauns, J. (1968). “Über den Einfluss des Einzelkornbruches auf die Belastbarkeit von Haufwerken, besonders von regelmässigen Kupelpackungen im Dreiaxialversuch.” Ph.D. thesis, TH Karlsruhe.
Castro, G. (1975). “Liquefaction and cyclic mobility of saturated sands.” J. Geotech. Engrg. Div., 101(6), 551–569.
Castro, G., and Poulos, S. J. (1977). “Factors affecting liquefaction and cyclic mobility.” J. Geotech. Engrg. Div., 103(6), 501–506.
Cundall, P. A., and Strack, O. D. L. (1979). “A discrete numerical model for granular assemblies.” Geotechnique, 29(1), 47–65.
De Josselin de Jong, G. (1971). “The double sliding, free rotating model for granular assemblies.” Geotechnique, 21(2), 155–163.
Drescher, A., and De Josselin de Jong, G. (1972). “Photoelastic verification of a mechanical model for the flow of a granular material.” J. Mech. Phys. Solids, 20, 337–351.
Feda, J. (1982). Mechanics of particulate materials: The principles, Elsevier, New York.
Finno, R. J., and Rechenmacher, A. L. (2003). “Effects of consolidation history on critical state of sand.” J. Geotech. Geoenviron. Eng., 129(4), 350–360.
Habib, P., and Luong, M. P. (1978). “Sols pulverulents sous chargement cyclique.” Matiriauz et Structures Sous Chargement Cyclique, Association Amicale des ingenieurs anciens eleves de l'ecole nationale des ponts et chaussees (Palaiseau, September 28–29), 49–79.
Hendron, A. J. (1963). “The behavior of sand in one-dimensional compression.” Ph.D. thesis, Univ. of Illinois.
Ishihara, K. (1993). “Liquefaction and flow failure during earthquakes. 33rd Rankine lecture.” Geotechnique, 43(3), 351–415.
Ishihara, K., Tatsuoka, F., and Yasuda, S. (1975). “Undrained deformation and liquefaction of sand under cyclic stresses.” Soils Found., 15(1), 29–44.
Iwashita, K., and Oda, M. (1998). “Rolling resistance at contacts in simulation of shear band development by DEM.” J. Eng. Mech., 124(3), 285–292.
Konishi, J., Oda, M., and Nemat-Nasser, S. (1982). Deformation and failure of granular materials, Balkema, Cape Town, South Africa.
Li, X. S., and Dafalias, Y. F. (2000). “Dilatancy for cohesionless soils.” Geotechnique, 50(4), 449–460.
Matsuoka, H. (1974). “Stress-strain relationship of sands based on the mobilized plane.” Soils Found., 14(2), 45–61.
Newland, P. L., and Allely, B. H. (1957). “Volume changes in drained triaxial tests on granular materials.” Geotechnique, 7(1), 17–34.
Rowe, P. W. (1962). “The stress-dilatancy relation for static equilibrium of an assembly of particles in contact.” Proc. R. Soc. London, Ser. A, 269, 500–527.
Satake, M. (1982). “Fundamental quantities in the graph approach to granular materials.” Proc., U.S./Japan Seminar on New Models and Constitutive Relations in the Mechanics of Materials, Elsevier, New York, 9–19.
Schofield, A., and Wroth, P. (1968). The critical state soil mechanics, McGraw-Hill, New York.
Taylor, D. W. (1948). Fundamentals of soil mechanics, Wiley, New York.
Thurston, C. W., and Deresiewicz, H. (1959). “Analysis of a compression test of a model granular medium.” J. Appl. Mech., 26(2), 251–258.
Verdugo, R., and Ishihara, K. (1996). “The steady state of sandy soils.” Soils Found., 36(2), 81–91.
Wan, R. G., and Guo, R. G. (1998). “A simple constitutive model for granular soils: Modified stress-dilatancy approach.” Comput. Geotech., 22(2), 109–133.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Jul 14, 2006
Accepted: Apr 9, 2007
Published online: Jan 1, 2008
Published in print: Jan 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.