Membrane Behavior of Model Soil–Bentonite Backfills
This article has been corrected.
VIEW CORRECTIONPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 131, Issue 4
Abstract
Two model soil-bentonite (SB) backfills were evaluated for their ability to behave as semipermeable membranes. The base soils for the model backfills consisted of natural clay with 89% (dry weight) fines and a mixture of sand with 5% dry sodium bentonite. Specimens of both base soils were mixed with a sufficient amount of 5% sodium bentonite–water slurry to correspond to slumps in accordance with standard practice for SB vertical cutoff walls. Membrane behavior was evaluated by measuring the chemico-osmotic efficiency coefficient , resulting from maintaining a KCl concentration difference across the specimen. The results indicate that both model backfills act as semipermeable membranes, with ranging from 0.018 to 0.024 for the natural clay backfill and from 0.118 to 0.166 for the sand–bentonite backfill. More significant membrane behavior (higher ) is correlated with higher consolidation stress, lower void ratio, and lower hydraulic conductivity. The benefit of the chemico-osmotic liquid flux due to the existence of membrane behavior in SB vertical cutoff walls is illustrated through an example analysis using the measured results. The results of the study provide the first quantitative evidence that SB vertical cutoff walls can behave as semipermeable membranes.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Financial support for this study, which is part of a collaborative research effort between Colorado State University and Bucknell University, was provided by the U.S. National Science Foundation (NSF), Arlington, Va., under Grant No. CMS-0099430. The opinions expressed in this paper are solely those of the writers and are not necessarily consistent with the policies or opinions of the NSF.
References
Barbour, S. L., and Fredlund, D. G. (1989). “Mechanisms of osmotic flow and volume change in clay soils.” Can. Geotech. J., 26(4), 551–562.
Daniel, D. E. (1994). “State-of-the-art: Laboratory hydraulic conductivity tests for saturated soils.” ASTM STP 1142, ASTM, West Conshohoken, Pa., 30–78.
D’Appolonia, D. J. (1980). “Soil-bentonite slurry trench cutoffs.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 106(4), 399–417.
Evans, J. C. (1993). “Vertical cutoff walls.” Geotechnical practice for waste disposal, D. E. Daniel, ed., Chap. 17, Chapman and Hall, London, 430–454.
Evans, J. C., Costa, M., and Cooley, B. (1995). “The state of stress in soil-bentonite slurry trench cutoff walls.” Geoenvironment 2000, Geotechnical special publication No. 46, Y. B. Acar and D. E. Daniel, eds., ASCE, New York, 1173–1191.
Filz, G. M. (1996). “Consolidation stresses in soil-bentonite backfilled trenches.” Proc., 2nd Int. Congress on Environmental Geotechnics, M. Kamon, ed., A. A. Balkema, Rotterdam, The Netherlands, 497–502.
Filz, G. M., Baxter, D. Y., Bentler, D. J., and Davidson, R. R. (1999). “Ground deformations adjacent to a soil-bentonite cutoff wall.” Proc., GeoEngineering for Underground Facilities, ASCE, Reston, Va., 121–139.
Fritz, S. J. (1986). “Ideality of clay membranes in osmotic processes: A review.” Clays Clay Miner., 34(2), 214–223.
Fritz, S. J., and Marine, I. W. (1983). “Experimental support for a predictive osmotic model of clay membranes.” Geochim. Cosmochim. Acta, 47(8), 1515–1522.
Keijzer, Th. J. S., Kleingeld, P. J., and Loch, J. P. G. (1997). “Chemical osmosis in compacted clayey material and the prediction of water transport.” Geoenvironmental engineering, contaminated ground: Fate of pollutants and remediation, R. N. Young and H. R. Thomas, eds., Thomas Telford Ltd., London, 199–204.
Kemper, W. D., and Quirk, J. P. (1972). “Ion mobilities and electric charge of external clay surfaces inferred from potential differences and osmotic flow.” Soil Sci. Soc. Am. Proc., 36(3), 426–433.
Kemper, W. D., and Rollins, J. B. (1966). “Osmotic efficiency coefficients across compacted clays.” Soil Sci. Soc. Am. Proc., 30(5), 529–534.
Lambe, T. W. (1951). Soil testing for engineers, Wiley, New York.
Lambe, T. W., and Whitman, R. V. (1969). Soil mechanics, Wiley, New York.
Malusis, M. A., and Shackelford, C. D. (2002a). “Chemico-osmotic efficiency of a geosynthetic clay liner.” J. Geotech. Geoenviron. Eng., 128(2), 97–106.
Malusis, M. A., and Shackelford, C. D. (2002b). “Coupling effects during steady-state solute diffusion through a semipermeable clay membrane.” Environ. Sci. Technol., 36(6), 1312–1319.
Malusis, M. A., Shackelford, C. D., and Olsen, H. W. (2001a). “A laboratory apparatus to measure chemico-osmotic efficiency coefficients for clay soils.” Geotech. Test. J., 24(3), 229–242.
Malusis, M. A., Shackelford, C. D., and Olsen, H. W. (2001b). “Flow and transport through clay membrane barriers.” Geoenvironmental engineering: Geoenvironmental impact management, R. N. Young and H. R. Thomas, eds., Thomas Telford Ltd., London, 334–341.
Marine, I. W., and Fritz, S. J. (1981). “Osmotic model to explain anomalous hydraulic heads.” Water Resour. Res., 17(1), 73–82.
McKelvey, J. G., and Milne, I. H. (1962). “The flow of salt solutions through compacted clay.” Proc., 9th National Conf. on Clays and Clay Minerals, Lafayette, Ind., Pergamon, New York, 248–259.
Millet, R. A., Perez, J. Y., and Davidson, R. R. (1992). “USA practice slurry wall specifications later.” ASTM STP 1129, ASTM, West Conshohoken, Pa., 42–66.
Mitchell, J. K. (1993). Fundamentals of soil behavior, 2nd Ed., Wiley, New York.
Olsen, H. W. (1969). “Simultaneous fluxes of liquid and charge in saturated kaolinite.” Soil Sci. Soc. Am. Proc., 33, 338–344.
Olsen, H. W., Yearsley, E. N., and Nelson, K. R. (1990). “Chemico-osmosis versus diffusion-osmosis.” Transp. Res. Rec. 1288, Transportation Research Record, Washington, D.C., 15–22.
Olson, R. E., and Daniel, D. E. (1981). “Measurement of the hydraulic conductivity of fine-grained soils.” ASTM STP 746, ASTM, West Conshohoken, Pa., 18–64.
Santamarina, J. C., Klein, K. A., Palomino, A., and Guimaraes, M. S., and (2002). “Micro-scale aspects of chemical-mechanical coupling: Interparticle forces and fabric.” Chemico-mechanical coupling in clays; from nano-scale to engineering applications, C. Di Maio, T. Hueckel, and B. Loret, eds., A. A. Balkema, Lisse, The Netherlands, 47–63.
Shackelford, C. D. (1994). “Waste-soil interactions that alter hydraulic conductivity.” ASTM STP 1142, ASTM, West Conshohoken, Pa., 111–168.
Shackelford, C. D., and Lee, J.-M. (2003). “The destructive role of diffusion on clay membrane behavior.” Clays Clay Miner., 51(2), 187–197.
Shackelford, C. D., Malusis, M. A., and Olsen, H. W. (2001). “Clay membrane barriers for waste containment.” Geotech. News, 19(2), 39–43.
Shackelford, C. D., Malusis, M. A., and Olsen, H. W. (2003). “Clay membrane behavior for geoenvironmental containment.” Soil and Rock America Conference 2003 Proc., Joint 12th Panamerican Conference on Soil Mechanics and Geotechnical Engineering and the 39th U. S. Rock Mechanics Symposium, P. J. Culligan, H. H. Einstein, and A. J. Whittle, eds., Vol. 1, Verlag Glückauf GMBH, Essen, Germany, 767–774.
Shackelford, C. D., and Redmond, P. L. (1995). “Solute breakthrough curves for processed kaolin at low flow rates.” J. Geotech. Eng., 121(1), 17–32.
Spooner, P. A., Wetzel, R. S., Spooner, C. E., Furman, C. A., Tokarski, E. F., and Hunt, G. E. (1984). “Slurry trench construction for pollution migration control.” EPA-540/2-84-001, US Environmental Protection Agency, Cincinnati.
Xanthakos, P. P. (1979). Slurry walls, McGraw–Hill, New York.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 131 • Issue 4 • April 2005
Pages: 418 - 429
Copyright
© 2005 ASCE.
History
Received: Sep 5, 2003
Accepted: Sep 9, 2004
Published online: Apr 1, 2005
Published in print: Apr 2005
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.