Ultimate Lateral Resistance to Piles in Cohesionless Soils
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 131, Issue 1
Abstract
Several methods are available for predicting the ultimate lateral resistance to piles in cohesionless soils. However, these methods often produce significantly different ultimate resistance values. This makes it difficult for practicing engineers to effectively select the appropriate method when designing laterally loaded piles in cohesionless soils. By analyzing the lateral soil resistance distribution along the width of the pile and based on the test results of model rigid piles in cohesionless soils collected from the published literature, a simple method is proposed for calculating the ultimate lateral resistance (including frontal soil resistance and side shear resistance) to piles in cohesionless soils. The calculated ultimate lateral resistance from the proposed method agrees well with that obtained from centrifugal tests of flexible model piles. Predicting the lateral load capacity of laboratory and field rigid test piles in cohesionless soils using the proposed method also yields satisfactory results.
Get full access to this article
View all available purchase options and get full access to this article.
References
Adams, J. I., and Radhakrishna, H. S. (1973). “The lateral capacity of deep augured footings.” Proc., 8th Int. Conf. Soil Mechanics Foundation Engineering, Vol. 2, Moscow, 1–8.
American Petroleum Institute (API). (1991). “Recommended practice for planning, designing and constructing fixed offshore platforms.” API recommended practice 2A (RP2A), 19th ed., Washington, D.C.
Barton, Y. O., and Finn, W. D. L. (1983). “Lateral pile response and p-y curves from centrifuge tests.” Proc., 15th Annual Offshore Technology Conf., Houston, Paper 4502, 503–508
Bhushan, K., Lee, L. J., and Grime, D. B. (1981). “Lateral load tests of drilled piers in sand.” Proc., Drilled Piers and Caissons, M. W. O’Neill, ed., St. Louis.
Borgard, D., and Matlock, H. (1980). Simplified calculation of curves for laterally loaded piles in sand, Earth Technology Corporation, Inc., Houston.
Briaud, J.-L., and Smith, T. D. (1983). “Using the pressuremeter curve to design laterally loaded piles.” Proc., 15th Offshore Technology Conf., Houston, Paper 4501, 495–502.
Brinch Hansen, J. (1961). “The ultimate resistance of rigid piles against transversal forces.” Bulletin No. 12, Danish Geotechnical Institute, Copenhagen, Denmark, 5–9.
Broms, B. B. (1964). “Lateral resistance of piles in cohesive soils.” J. Soil Mech. Found. Div., 90(2), 27–64.
Chari, T. R., and Meyerhof, G. G. (1983). “Ultimate capacity of single piles under inclined loads in sand.” Can. Geotech. J., 20, 849–854.
Fleming, W. G. K., Weltman, A. J., Randolph, M. F., and Elson, W. K. (1992). Piling engineering. Surrey University Press, London.
Jamiolkowski, M., and Garassino, A. (1977). “Soil modulus for laterally loaded piles.” Proc., 9th Int. Conf. Soil Mechanics Foundation Engineering, Tokyo, 87–92.
Joo, J. S. (1985). “Behavior of large scale rigid model piles under inclined loads in sand.” Ms Engineering thesis, Memorial Univ. of Newfoundland, St. John’s, Newfoundland, Canada.
Kulhawy, F. H. (1984). “Limiting tip and side resistance: Fact or fallacy.” Proc., Symp. on Design and Analysis of Pile Found., ASCE, New York, 80–98.
Kulhawy, F. H. (1991). “Drilled shaft foundations.” Foundation engineering handbook., 2nd Ed., Chap. 14, H.-Y. Fang ed., Van Nostrand Reinhold, New York.
Kulhawy, F. H., Trautmann, C. H., Beech, J. F., O’Rourke, T. D., McGuire, W., Wood, W. A., and Capano, C. (1983). “Transmission line structure foundations for uplift-compression loading.” Rep. No. EL-2870, Electric Power Research Institute, Palo Alto, Calif.
Meyerhof, G. G., Mathur, S. K., and Valsangkar, A. J. (1981). “Lateral resistance and deflection of rigid wall and piles in layered soils.” Can. Geotech. J., 18, 159–170.
Meyerhof, G. G., and Sastry, V. V. R. N. (1985). “Bearing capacity of rigid piles under eccentric and inclined loads.” Can. Geotech. J., 22, 267–276.
Murff, J. D., and Hamilton, J. M. (1993). “ -ultimate for undrained analysis of laterally loaded piles.” J. Geotech. Eng., 119(1), 91–107.
NAVFAC (1982). “Foundations and earth structures.” Design Manual 7.2, U.S. Department of the Navy, Alexandria, Va.
Poulos, H. G., and Davis, E. H. (1980). Pile foundation analysis and design, Wiley, New York.
Prasad, Y. V. S. N., and Chari, T. R. (1999). “Lateral capacity of model rigid piles in cohesionless soils.” Soils Found., 39(2), 21–29.
Randolph, M. F., Dolwin, J., and Beck, R. (1994). “Design of driven piles in sand.” Geotechnique, 44(3), 427–448.
Reese, L. C., Cox, W. R., and Koop, F. D. (1974). “Analysis of laterally loaded piles in sand.” Proc., 6th Offshore Technology Conf., Vol. 2, Houston, 473–483.
Smith, T. D. (1987). “Pile horizontal modulus values.” J. Geotech. Eng., 113(9), 1040–1044.
Tomlinson, M. J. (1986). Foundation design and construction, 5th Ed., Pitman Books Ltd., London.
Wong, K. S., and Teh, C. I. (1995). “Negative skin friction on piles in layered soil deposits.” J. Geotech. Eng., 121(6), 457–465.
Information & Authors
Information
Published In
Copyright
© 2004 ASCE.
History
Received: Oct 27, 2003
Accepted: May 25, 2004
Published online: Jan 1, 2005
Published in print: Jan 2005
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.