Physicochemical and Engineering Behavior of Cement Treated Clays
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 130, Issue 7
Abstract
This paper examines the relationship between the microstructure and engineering properties of cement-treated marine clay. The microstructure was investigated using x-ray diffraction, scanning electron microscopy, pH measurement, mercury intrusion porosimetry, and laser diffractometric measurement of the particle size distribution. The engineering properties that were measured include the water content, void ratio, Atterberg limit, permeability, and unconfined compressive strength. The results indicate that the multitude of changes in the properties and behavior of cement-treated marine clay can be explained by interaction of four underlying microstructural mechanisms. These mechanisms are the production of hydrated lime by the hydration reaction which causes flocculation of the illite clay particles, preferential attack of the calcium ions on kaolinite rather than on illite in the pozzolanic reaction, surface deposition and shallow infilling by cementitious products on clay clusters, as well as the presence of water trapped within the clay clusters.
Get full access to this article
View all available purchase options and get full access to this article.
References
Asano, J., Ban, K., Azuma, K., and Takahashi, K. (1996). “Deep mixing method of soil stabilization using coal ash.” Proc., 2nd Int. Conf. on Ground Improvement Geosystems, Grouting and Deep Mixing, 393–398.
Balasubramaniam, A. S., Kamruzzaman, A. H. M., Uddin, K., Lin, D. G., Phienwij, N., and Bergado, D. T. (1998). “Chemical stabilization of Bangkok clay with cement, lime and flyash additives.” 13th Southeast Asian Geotechnical Conf., 253–258.
Balasubramaniam, A. S., Lin, D. G., Sharma, S. S., Kamruzzaman, A. H. M., Uddin, K., and Bergado, D. T. (1999). “Behavior of soft Bangkok clay treated with additives.” 11th Asian Regional Conf. on Soil Mechanics and Geotechnical Engineering, 11–14.
Bergado, D. T., Anderson, L. R., Miura, N., and Balasubramaniam, A. S. (1996). Soft ground improvement in lowland and other environments, ASCE, New York.
Berube, M. A., Choquette, M., and Locat, J.(1990). “Effects of lime on common soil and rock forming minerals.” Appl. Clay Sci., 5, 145–163.
Brandl, H. (1981). “Alteration of soil parameters by stabilization with lime.” Proc., 10th Int. Conf. on Soil Mechanics and Foundation Engineering, 3, 587–594.
Broderic, G. P., and Daniel, D. E.(1990). “Stabilizing compacted clays against chemical attack.” J. Geotech. Eng., 116(10), 1549–1567.
Brown, G. (1961). The x-ray identification and crystal structures of clay mineral, Mineralogical Society (Clay Minerals Group), London.
BS 1377. (1990). British Standard Methods of Test for Soils for Civil Engineering Purposes, Part 2, British Standards Institution, London.
Burland, J. B.(1990). “On the compressibility and shear strength of natural soils.” Geotechnique, 40(3), 329–378.
Carli, F., and Motta, A. (1985). “Particle size distribution of reference materials by microcomputerized mercury porosimetry.” Manual of Porosimeter, 2000 Series, Carlo Erba Instruments, 7.2–7.8.
Chew, S. H., Lee, F. H., and Lee, Y. (1997). “Jet grouting in Singapore marine clay.” Proc., 3rd Asian Young Geotechnology Engineering Conf., 231–238.
Clayton, C. R. I., Khatrush, S. A., Bica, A. V. D., and Siddique, A.(1989). “The use of Hall effect semiconductors in geotechnical instrumentation.” Geotech. Test. J., 12(1), 69–76.
Cokca, E.(2001). “Use of class C fly ashes for the stabilization of an expansive soil.” J. Geotech. Geoenviron. Eng., 127(7), 568–573.
Delage, P., and Lefebvre, G.(1984). “Study of the structure of a sensitive Champlain clay and of its evolution during consolidation.” Can. Geotech. J., 21, 21–35.
Eades, J. L., and Grim, R. E.(1960). “Reactions of hydrated lime with pure clay minerals in soil stabilization.” High. Res. Bull.,262, 51–63.
Endo, M. (1976). “Recent development in dredged material stabilization and deep chemical mixing in Japan.” Soils and site improvement, Life Long Learning Seminar, Univ. of California, Berkeley, Berkeley, Calif.
Futaki, M., Nakano, K., and Hagino, Y. (1996). “Design strength of soil cement columns as foundation ground for structures.” Proc., 2nd Int. Conf. on Ground Improvement Geosystems, 481–484.
Head, K. H. (1986). Manual of soil laboratory testing, 1st Ed., ELE International Ltd., Pentech, London.
Hooi, K. H., and Yong, Y. L. (1982). “Curtain grouting at Langat Dam.” Proc., 7th Southeast Asian Geotech. Conf., 571–583.
JCPDS. (1995). Index to the powder diffraction file, International Center for Diffraction Data, Swarthmore, Pa.
Kamruzzaman, A. H. M., Chew, S. H., and Lee, F. H.(2001). “Behavior of soft Singapore marine clay treated with cement.” ASCE Geotech. Special Publication, GSP,113, 472–485.
Kaushinger, J. L., Perry, E. B., and Hankour, R. (1992). “Jet grouting: State of the practice.” Proc., Conf. Geotechnical Engineering, Div., Grouting, Soil Improvement and Geosynthetics, ASCE, New York, 1, 169–181.
Kenney, T. C.(1980). “Frost heaving rate predicted from pore size distribution: Discussion.” Can. Geotech. J., 17, 332.
Kezdi. (1979). Stabilized earth roads, Development in Geotechnical Engineering, Elsevier Scientific, New York.
Kinuthia, J. M., Wild, S., and Jones, G. I.(1999). “Effects of monovalent and divalent metal sulphates on consistency and compaction of lime stabilized kaolinite.” Appl. Clay Sci., 14, 27–45.
Lacasse, S., Berre, T., and Lefebvre, G. (1985). “Block sampling of sensitive clays.” Proc., 11th Int. Conf. on Soil Mechanics and Foundation Engineering, 2, 887–892.
Lapierre, C., Leroueil, S., and Locat, J.(1990). “Mercury intrusion and permeability of Louiseville clay.” Can. Geotech. J., 27, 761–773.
Lawrence, G. P.(1978). “Stability of soil pores during mercury intrusion porosimetry.” J. Soil Sci., 29, 299–304.
Lee, S. L., and Yong, K. Y. (1991). “Grouting in substructure construction.” Proc., 9th Regional Conf. on Soil Mechanics and Foundation Engineering, 2, 41–49.
Lee, Y. (1998). “A framework for the design of jet grout piles in Singapore marine clay.” MEng thesis, National Univ. of Singapore, Singapore.
Lerouiel, S., and Vaughan, P. R.(1990). “The general and congruent effects of structure in natural soils and weak rock.” Geotechnique, 40(3), 467–488.
Liu, M. D., and Carter, J. P.(1999). “Virgin compression of structured soils.” Geotechnique, 49(1), 43–57.
Locat, J., Berube, M. A., and Choquette, M.(1990). “Laboratory investigations on the lime stabilization of sensitive clays: Shear strength development.” Can. Geotech. J., 27, 294–304.
Locat, J., Tremblay, H., and Leroueil, S.(1996). “Mechanical and hydraulic behaviour of a soft inorganic clay treated with lime.” Can. Geotech. J., 33, 654–669.
Mastersizer Micro, Ver. 2.17. (1995). Malvern Instruments Ltd., Malvern, U.K.
Mitchell, J. K. (1981). “Soil improvement state of the art report.” Proc., 10th Int. Conf. on Soil Mechanics and Foundation Engineering, 4, 509–565.
Mitchell, J. K. (1992). Fundamentals of soil behavior, 2nd Ed., Wiley, New York.
Nagaraj, T. S., Pandian, N. S., and Narasimha Raju, P. S. R.(1998). “Compressibility behaviour of soft cemented soils.” Geotechnique, 48(2), 281–287.
O’Rourke, T. D., MacGinn, A. J., Dewsnap, J., and Stewart, H. E.(1998). “Case history of an excavation stabilized by deep mixing methods.” ASCE Geotech. Special Publication, GSP,83, 41–63.
Pierce, J. W., and Siegel, F. R.(1969). “Quantification in clay mineral studies of sediments and sedimentary rocks.” J. Sediment. Petrol., 39(1), 187–193.
Porbaha, A., Shibuya, S., and Kishida, T.(2000). “State of the art in deep mixing technology. Part III: Geomaterial characterization.” Ground Improvement,4(3), 91–110.
Porosimeter 2000 Series. (1985). Manual of porosimeter 2000 series, Carlo Erba Instruments, 1.5–1.6.
Rao, S. N., and Rajasekaran, G.(1996). “Reaction products formed in lime-stabilized marine clays.” J. Geotech. Eng., 122(5), 329–336.
Santamarina, J. C., Klein, K., and Fam, M. (2001). Soils and waves, Wiley, New York.
Schaefer, V. R., Abramson, L. W., Drumheller, J. C., and Sharp, K. D., eds. (1997). “Ground improvement, ground reinforcement and ground treatment: Developments 1987 to 1997.” ASCE Geotech. Special Publication, GSP, 69.
Shen, S.-L. (1998). “Behavior of deep mixing columns in composite clay ground.” PhD thesis, Saga University, Japan.
Sivapullaiah, P. V., Sridharan, A., and Bhaskar Raju, K. V.(2000). “Role of amount and type of clay in the lime stabilization of soil.” Ground Improvement,4(1), 37–45.
Tatsuoka, F., Uchida, K., Imai, K., Ouchi, T., and Kohata, Y.(1997). “Properties of cement treated soil in Trans-Tokyo Bay Highway project.” Ground Improvement,1(1), 37–57.
Tovey, N. K., and Wong, K. Y. (1973). “The preparation of soils and other geological materials for the SEM.” Proc., Int. Symp. on Soil Structure, 59–67.
Uddin, K., Balasubramaniam, A. S., and Bergado, D. T.(1997). “Engineering behavior of cement-treated Bangkok soft clay.” Geotech. Eng., 28(1), 89–119.
Yin, J. H., and Lai, C. K.(1998). “Strength and stiffness of Hong Kong marine deposits mixed with cement.” Geotech. Eng., 29(1), 29–44.
Yong, D. M., Hayashi, K., and Chia, B. H. (1996). “Jet grouting for construction of a RC canal in soft marine clay.” Proc., 2nd Int. Conf. on Ground Improvement Geosystems, Grouting and Deep Mixing, 375–380.
Yu, Y., Pu, J., Ugai, K., and Takashi, H.(1999). “A study of the permeability of soil-cement mixture.” Soils Found., 39(5), 145–149.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: Feb 8, 2002
Accepted: Nov 25, 2003
Published online: Jun 15, 2004
Published in print: Jul 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.