Engineering Properties of Grouted Sands
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 130, Issue 3
Abstract
A comparison of the behavior of uncemented and grouted sands is presented. Four sands (Fontainebleau sand and three types of alluvial deposits of the Seine River) were tested. Specimens of grouted sands were prepared in the laboratory by injection of very fine cement or mineral grouts. An initial series of unconfined uniaxial compression tests and tensile tests was performed to highlight the effect of some key factors (mainly the cement-to-water ratio of the grout and the relative density of the granular skeleton) on the strength of the grouted sands. Subsequent triaxial tests showed that when a soil is impregnated by either a very fine cement grout or a mineral grout, both stiffness (secant stiffness or small-strain stiffness) and strength of the soil improve. Similar trends were observed for the behavior of both uncemented and grouted sands. The behavior of grouted sands can be roughly reproduced by applying a linear elastic, perfectly plastic model with a nonassociated Mohr–Coulomb yield criterion whose parameters can be easily determined. Finally, preliminary recommendations are proposed relative to improvements ratios of the parameters of this simple constitutive model that is still commonly used in geotechnical engineering.
Get full access to this article
View all available purchase options and get full access to this article.
References
Airey, D. W.(1993). “Triaxial testing of naturally cemented carbonate soil.” J. Geotech. Eng., 119(9), 1379–1398.
Allison, R. J. (1988). “A nondestructive method of determining rock strength.” Earth surface processes and landforms, Vol. 13, Wiley, New York, 1–8.
Baig, S., Picornell, M., and Nazarian, S.(1997). “Low strain shear moduli of cemented sands.” J. Geotech. Geoenviron. Eng., 123(6), 540–545.
Baligh, M. M.(1976). “Cavity expansion in sand with curved envelopes.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 102(11), 1131–1146.
Benhamou, O. (1994). “Comportement rhéologique des coulis de liants hydrauliques ultrafins destinés à l’injection.” PhD thesis, Ecole de Géologie de l’Ingénieur, Ecole Nationale Supérieure des Mines de Paris (in French).
Bishop, A. W.(1966). “The strength of soils as engineering materials.” Geotechnique, 16(2), 91–128.
Bouvard-Lecoanet, A., Colombet, G., and Esteulle, F. (1992). Ouvrages souterrains: Conception-réalisation-entretien, 2nd Ed., Presses de l’E.N.P.C. (in French).
Cambefort, H. (1967). L’injection des sols, Eyrolles (in French).
Clough, G. W., and Sitar, B.(1981). “Cemented sands under static loading.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 107(6), 799–817.
Dano, C., and Derache, N. (2001). “Grout injection in the laboratory.” Proc., Landmarks in Earth Reinforcement, Int. Symp. on Earth Reinforcement, Fukuoka, Japon, 21–26.
Dupas, J. M., and Pecker, A.(1979). “Static and dynamic properties of sand-cement.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 105(3), 419–436.
Gouvenot, D.(1995). “Silacsol: plus qu’un coulis, un nouveau procédé d’injection des sols.” Tunnels Ouvrages Souterrains, 127, 17–25 (in French).
Hoek, E., and Brown, E. T.(1980). “Empirical strength criterion for rock masses.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 106(9), 1013–1035.
Huang, J. T., and Airey, D. W.(1998). “Properties of artificially cemented carbonate sand.” J. Geotech. Geoenviron. Eng., 124(6), 492–499.
Kaga, M., and Yonekura, R.(1991). “Estimation of strength of silicate-grouted sand.” Soils Found., 31(3), 43–59.
Kutzner, C. (1996). Grouting of rock and soil, Balkema, Rotterdam, The Netherlands.
Perret, S., Khayat, K. H., and Ballivy, G.(2000). “The effect of degree of saturation of sand on groutability—Experimental simulation.” Ground Improvement, 4(4), 13–22.
Réunion Internationale des Laboratoires d’Essais et de Recherches sur les Matériaux (RILEM). (1983). “Recommandations pour l’emploi de la méthode de fréquence de résonance dans le contro⁁le des éprouvettes de béton.” GrindoSonic user manual, France.
Saxena, S. K., and Lastrico, R. M.(1978). “Static properties of lightly cemented sand.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 104(12), 1449–1464.
Schillinger, L., Vulliet, L., Bouchelaghem, F., Leroy, D., Laloui, L., and Descoeudres, F. (2000). “Injection of micro-cement in fine-grained soil: theory, modelling and laboratory testing.” Darmstädter geotechnik-kolloquium, Technischen Univ. Darmstad, Darmstadt, Germany 157–175.
Schwarz, L. G., and Krizek, R. J.(1994). “Effect of preparation technique on permeability and strength of cement-grouted sand.” Geotech. Test. J., 17(4), 434–443.
Shibuya, S., Tatsuoka, F., Teachavorasinskun, S., Kong, X. J., Abe, F., Kim, Y. S., and Park, C. S.(1992). “Elastic deformation properties ofgeomaterials.” Soils Found., 32(3), 26–46.
Spinner, S., and Tefft, W. E. (1961). “A method for determining mechanical resonance frequencies and for calculating elastic moduli from these frequencies.” American Society Testing Material Proc., 61, 1221–1238.
Tailliez, S. (1998). “Etude expérimentale du comportement mécanique des sols granulaires injectés.” PhD thesis, Ecole Centrale de Paris, Paris (in French).
Valette, D. (1992). Internal Rep., Bouygues Society.
Zebovitz, S., Krizek, R. J., and Atmatzidis, D. X.(1989). “Injection of fine sands with very fine cement grout.” J. Geotech. Eng., 115(12), 1717–1733.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: Dec 6, 2000
Accepted: Jul 25, 2003
Published online: Feb 19, 2004
Published in print: Mar 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.