Measured and Estimated Suction Indices for Swelling Potential Classification
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 129, Issue 7
Abstract
McKeen’s expansive soil classification methodology relies on a parameter referred to as the “total suction-water content index” for describing the slope of the soil–water characteristic curve on a semilog plot. The swelling potential of expansive soils is qualitatively classified (e.g., “low” or “high”) based on the magnitude of the total suction-water content index. This study examines the validity of using a “benchmark intercept simplification” for indirectly estimating the total suction-water content index when complete soil–water characteristic measurements are not available or economical. Suction indices estimated using the benchmark intercept simplification are compared with indices measured directly using the noncontact filter paper technique for 80 undisturbed expansive shale specimens from the Colorado Front Range Corridor. The results show that the suction-water content index is consistently overestimated using the benchmark simplification by amounts ranging from negligible to 50%, and averaging 23%. For 49 of the 80 specimens (61%), the estimated indices fall in different swelling potential categories than the measured indices. In 44 of the 49 cases (90%), the estimated indices fall in higher swelling potential categories than the measured indices. These discrepancies reflect potential errors that may arise from the use of the benchmark intercept simplification in classifying expansive soils.
Get full access to this article
View all available purchase options and get full access to this article.
References
Chen, F. H. (1988). Foundations on expansive soils, Elsevier, New York.
Holtz, W. G., and Gibbs, H. J.(1956). “Engineering properties of expansive clays.” Trans. Am. Soc. Civ. Eng., 121, 641–677.
Krosley, L. (2000). “Interrelationships among smectite and indices of swelling behavior of clays and clay shales in the Colorado Front Range Urban Corridor.” MS thesis, Colorado School of Mines, Golden, Colo.
Likos, W. J., and Lu, N. (2002). “On the filter paper technique for measurement of total suction.” Transportation Research Record 1786, Transportation Research Board, Washington, D.C., 120–128.
McKeen, R. G. (1981). “Design of airport pavements on expansive soils.” Rep. No. DOT/FAA/RD-81/25, Systems Research and Development, Federal Aviation Administration, Washington, D.C.
McKeen, R. G. (1985). “Validation of procedures for pavement design on expansive soils.” Rep. No. DOT/FAA/PM-85-15, Program Engineering and Maintenance Service, Federal Aviation Administration, Washington, D.C.
McKeen, R. G. (1992). “A model for predicting expansive soil behavior.” Proc., 7th Int. Conf. on Expansive Soils, Vol. 1, Dallas, 1–6.
McQueen, I. S., and Miller, R. F.(1974). “Approximating soil moisture characteristics from limited data: empirical evidence and tentative model.” Water Resour. Res., 10(3), 521–527.
Noe, D. C.(1997). “Heaving-bedrock hazards, mitigation, and land-use policy: Front Range Piedmont, Colorado.” Envir. Geosciences, 4(2), 48–57.
Olsen, H. W., Krosley, L., Nelson, K., Chabrillat, S., Goetz, A., and Noe, D. C. (2000). “Mineralogy-swelling potential relationships for expansive soils.” Advances in unsaturated geotechnics, C. Shackelford et al., eds., ASCE, Geotechnical Special Publication No. 99, ASCE, New York, 361–378.
Seed, H. B., Woodard, R. J., and Lundgren, R.(1962). “Prediction of swelling potential for compacted clays.” J. Soil Mech., Found. Div., Am. Soc. Civ. Eng., 88(SM3), 53–87.
Thompson, R. W. (1997). “Evaluation protocol for repair of residences damaged by expansive soils.” Unsaturated soil engineering practice, ASCE Geotechnical Special Publication No. 68, ASCE, New York, 255–276.
Thompson, R. W., and McKeen, R. G. (1995). “Heave prediction using soil suction—a case history.” Soil suction applications in geotechnical engineering practice, ASCE Geotechnical Special Publication No. 48, ASCE, New York, 1–13.
Information & Authors
Information
Published In
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: May 21, 2002
Accepted: Sep 11, 2002
Published online: Jun 13, 2003
Published in print: Jul 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.