Behavior of Plate Load Tests on Soil Layers Improved with Cement and Fiber
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 129, Issue 1
Abstract
The load-settlement response from three plate load tests (300 mm diameter, 25.4 mm thick) carried out directly on a homogeneous residual soil stratum, as well as on a layered system formed by two different top layers (300 mm thick)—sand-cement and sand-cement fiber—overlaying the residual soil stratum, is discussed in this technical note. The utilization of a cemented top layer increased bearing capacity, reduced displacement at failure, and changed soil behavior to a noticeable brittle behavior. After maximum load, the bearing capacity dropped towards approximately the same value found for the plate test carried out directly on the residual soil. The addition of fiber to the cemented top layer maintained roughly the same bearing capacity but changed the postfailure behavior to a ductile behavior. A punching failure mechanism was observed in the field for the load test bearing on the sand-cement top layer, with tension cracks being formed from the bottom to the top of the layer. A completely distinct mechanism was observed in the case of the sand-cement-fiber top layer, the failure occurring through the formation of a thick shear band around the border of the plate, which allowed the stresses to spread through a larger area over the residual soil stratum.
Get full access to this article
View all available purchase options and get full access to this article.
References
ASTM D1194-94. (Reapproved 1998). “Standard test method for bearing capacity of soil for static load and spread footings.” American Society for Testing and Materials, Philadelphia.
Clayton, C. R. I., and Khatrush, S. A.(1986). “A new device for measuring local axial strain on triaxial specimens.” Geotechnique, 25, 657–670.
Clayton, C. R. I., Khatrush, S. A., Bica, A. V. D., and Siddique, A.(1989). “The use of Hall effect semiconductor in geotechnical instrumentation.” Geotech. Test. J., 12, 69–76.
Consoli, N. C., Schnaid, F., and Milititsky, J.(1998). “Interpretation of plate load tests on residual soil site.” J. Geotech. Geoenviron. Eng., 124(9), 857–867.
Consoli, N. C., Schnaid, F., Milititsky, J., and Vendruscolo, M. A. (1997). “Design of shallow foundations on structured and compacted soils based on plate loading tests and finite element analysis.” Proc., 14th Int. Conf. on Soil Mechanics and Foundation Engineering, Hamburg, Germany, 783–784.
La Rochelle, P., Leroueil, S., Trak, B., Blais-Leroux, L., and Tavenas, F. (1988). “Observational approach to membrane and area corrections in triaxial tests.” Proc., Symp. on Advanced Triaxial Testing of Soil and Rock, ASTM, Louisville, Ky., 715–731.
Maswoswe, J. J. (1985). “Stress path method for a compacted soil during collapse due to wetting.” PhD thesis, Univ. of London.
Meyerhof, G. G., and Hanna, A. M.(1978). “Ultimate bearing capacity of foundations on layered soils under inclined load.” Can. Geotech. J., 15, 565–572.
NBR-12131. (1991). “Foundations—Static loading tests.” Brazilian Standards.
Ramires, M. C. P. (1993). “Study of the behavior of small diameter bored piles in a homogeneous residual soil layer.” MSc dissertation, Federal Univ. of Rio Grande do Sul, Porto Alegre, Brazil (in Portuguese).
Sales, L. F. P. (1998). “The behavior of shallow foundations placed on improved soil layers.” MSc dissertation, Federal Univ. of Rio Grande do Sul, Porto Alegre, Brazil (in Portuguese).
Stefanoff, G., Jellev, J., Tsankova, N., Karachorov, P., and Slavov, P. (1983). “Stress and strain state of a cement-less cushion.” Proc., VIII European Conf. of Soil Mechanics and Foundation Engineering, Helsinki, 811–816.
Tessari, M. A. (1998). “The use of coal bottom ash improved with cement as a base for shallow foundations.” MSc dissertation, Federal Univ. of Rio Grande do Sul, Porto Alegre, Brazil (in Portuguese).
Thomé, A. (1999). “Behavior of spread footings bearing on lime stabilized layers.” PhD thesis, Federal Univ. of Rio Grande do Sul, Porto Alegre, Brazil (in Portuguese).
Vendruscolo, M. A. (1996). “Field and numerical analysis of shallow foundations bearing on improved soil layers.” MSc dissertation, Federal Univ. of Rio Grande do Sul, Porto Alegre, Brazil (in Portuguese).
Vésic, A. S. (1975). “Bearing capacity of shallow foundations.” Foundation engineering handbook, H. F. Winterkorn and H. Fang, eds., Van Nostrand Reinhold, New York, Chap. 3, 121–147.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 129 • Issue 1 • January 2003
Pages: 96 - 101
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: Nov 7, 2000
Accepted: May 28, 2002
Published online: Dec 13, 2002
Published in print: Jan 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.