Centrifuge Modeling of Unstable Infiltration and Solute Transport
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 125, Issue 7
Abstract
Unstable flow can result in the formation of fingers during infiltration into dry soil. Centrifuge modeling is a potentially useful tool to study the relationship between finger size, spacing, and velocity. It can also be used to investigate solute transport in such fingers. Physical properties of the fingers are obtained for three tests conducted at elevated acceleration levels. A fourth test was conducted at 1g. The physical parameters compare well with theoretical predictions. To assess solute transport in fingers, a known concentration of solute was introduced after the fingers had formed. The resulting breakthrough curves were analyzed using the two-region model as well as the advection dispersion equation with appropriate initial and boundary conditions. Although the two-region model is physically more plausible, it was found to match the extensive tailing observed in the breakthrough curves only marginally better than the advection-dispersion equation.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Arulanandan, K., Thompson, P. Y., Kutter, B. L., Meegoda, N. J., Muraleetharan, K. K., and Yogachandran, C. (1988). “Centrifuge modelling of transport processes for pollutants in soils.”J. Geotech. Engrg., ASCE, 114, 185–205.
2.
Bajracharya, K., and Barry, D. A. (1997). “Nonequilibrium solute transport parameters and their physical significance: Numerical and experimental results.” J. Contam. Hydro., 24, 185–204.
3.
Barry, D. A., Parlange, J.-Y., Haverkamp, R., and Ross, P. J. (1995). “Infiltration under ponded conditions: 4. An explicit predictive infiltration formula.” Soil Sci., 160, 8–17.
4.
Bear, J., and Verruijt, A. (1987). Modelling groundwater flow and pollution. Reidel, Dordrecht, The Netherlands.
5.
Brooks, R. H., and Corey, A. T. ( 1964). “Hydraulic properties of porous media.” Hydro. Paper 3, Colorado State University, Fort Collins, Colo.
6.
Cooke, A. B., and Mitchell, R. J. (1991). “Physical modelling of a dissolved contaminant in an unsaturated sand.” Can. Geotech. J., Ottawa, 28, 829–833.
7.
Culligan-Hensley, P. J., and Savvidou, C. ( 1995). “Environmental geomechanics and transport processes.” Geotechnical centrifuge technology, R. N. Taylor, ed., Blackie Academic, London, 196–263.
8.
Culligan, P. J., and Barry, D. A. (1998). “Similitude requirements for modelling NAPL movement with a geotechnical centrifuge.” Proc., Inst. Civ. Eng. Geotech. Engrg., 131, 180–186.
9.
Culligan, P. J., Barry, D. A., and Parlange, J.-Y. (1997). “Scaling unstable infiltration in the vadose zone.” Can. Geotech. J., Ottawa, 34, 466–470.
10.
Culligan, P. J., C. Savvidou, C., and Barry, D. A. (1996). “Centrifuge modelling of contaminant transport processes.”Electronic J. Geotech. Engrg., 〈http://geotech.civen.okstate.edu/ejge/Ppr9606, 09606/index.htm〉.
11.
De Smedt, F., and Wierenga, P. J. (1984). “Solute transfer through columns of glass beads.” Water Resour. Res., 20, 225–232.
12.
Diment, G. A., and Watson, K. K. (1985). “Stability analysis of water movement in unsaturated porous materials: 3. Experimental studies.” Water Resour. Res., 21, 979–984.
13.
Diment, G. A., Watson, K. K., and Blennerhassett, P. J. (1982). “Stability analysis of water movement in unsaturated porous materials: 1. Theoretical considerations.” Water Resour. Res., 18, 1248–1254.
14.
Glass, R. J., Cann, S., King, J., Bailey, N., Parlange, J.-Y., and Steenhuis, T. S. (1990). “Wetting front instability in unsaturated porous media: A three-dimensional study in initially dry sand.” Transp. Porous Media, 5, 247–268.
15.
Glass, R. J., Parlange, J.-Y., and Steenhuis, T. S. (1989a). “Wetting front instability, 1. Theoretical discussion and dimensional analysis.” Water Resour. Res., 25, 1187–1194.
16.
Glass, R. J., Parlange, J.-Y., and Steenhuis, T. S. (1989b). “Wetting front instability. 2. Experimental determination of relationships between system behaviour in initially dry porous media.” Water Resour. Res., 25, 1195–1207.
17.
Griffioen, J. W., Barry, D. A., and Parlange, J.-Y. (1998). “Interpretation of two region model parameters.” Water Resour. Res., 34, 373–384.
18.
Hensley, P. J., and Schofield, A. N. (1987). “Accelerated physical modelling of hazardous-waste transport.” Géotechnique, London, 41, 447–465.
19.
Hill, D. E., and Parlange, J.-Y. (1972). “Wetting front instability in layered soils.” Soil Sci. Soc. Am. Proc., 36, 697–702.
20.
Illangasekare, T. H., ZnidarCi, D., Al-Sheridda, M., and Reible, D. D. ( 1991). “Multi-phase flow in porous media.” Centrifuge '91, H.-Y. Ko and F. G. McLean, eds., Balkema, Rotterdam, The Netherlands, 517–523.
21.
Li, L. ( 1993). “Physical modelling of nonreactive chemical transport in locally stratified soils,” MS thesis, Department of Environmental Engineering, University of Western Australia, Nedlands, Western Australia.
22.
Li, L., Barry, D. A., and Stone, K. J. L. (1994a). “Centrifugal modelling of non-sorbing, nonequilibrium solute transport in a locally inhomogeneous soil.” Can Geotech. J., Ottawa, 31, 471–477.
23.
Li, L., Barry, D. A., Culligan-Hensley, P. J., and Bajracharya, K. (1994b). “Mass transfer in soils with local stratification of hydraulic conductivity.” Water Resour. Res., 30, 2891–2900.
24.
Liu, Y., Steenhuis, T. S., and Parlange, J.-Y. (1994). “Closed-form solution for finger width in sandy soils at different water contents.” Water Resour. Res., 30, 949–952.
25.
Nkedi-Kizza, P., Biggar, J. W., Selim, H. M., Van Genuchten, M. T., Wierenga, P. J., Davidson, J. M., and Nielsen, D. R. (1984). “On the equivalence of two conceptual models for describing ion exchange during transport through an aggregated oxisol.” Water Resour. Res., 20, 1123–1130.
26.
Parker, J. C., and Valocchi, A. J. (1986). “Constraints on the validity of equilibrium and first-order kinetic transport models in structure soils.” Water Resour. Res., 22, 399–407.
27.
Parker, J. C., and Van Genuchten, M. T. (1984). “Determining transport parameters from laboratory and field tracer experiments.” Va. Agric. Exp. Stn., Bull. 84-3, Virginia Polytechnic Institute and State University, Blacksburg, Va.
28.
Parlange, J.-Y., and Hill, D. E. (1976). “Theoretical analysis of wetting front instability in soils.” Soil Sci., 122, 236–239.
29.
Philip, J. R. (1969). “Theory of infiltration.” Adv. Hydroscience, 5, 215–296.
30.
Rao, P. S. C., Rolston, D. E., Jessup, R. E., and Davidson, J. M. (1980). “Solute transport in aggregated porous media: Theoretical and experimental evaluation.” Soil Sci. Soc. Am. J., 44, 1139–1146.
31.
Ripple, C. D., James, R. V., and Rubin, J. (1973). “Radial particle-size segregation during packing of particulates into cylindrical containers.” Powder Technol., 8, 165–175.
32.
Savvidou, C., and Culligan, P. J. (1998). “The application of centrifuge modelling to geo-environmental problems.” Proc., Inst. Civ. Eng., Geotech. Engrg., 131, 152–162.
33.
Schofield, A. N. (1980). “Cambridge geotechnical centrifuge operations.” Géotechnique, London, 30, 227–268.
34.
Selker, J., Leclerq, P., Parlange, J.-Y., and Steenhuis, T. S. (1992). “Fingered flow in two dimensions, 1. Measurement of matric potential.” Water Resour. Res., 28, 2513–2521.
35.
Toride, N., Leij, F. J., and Van Genuchten, M. T. (1995). “The CXTFIT code for estimating transport parameters from laboratory or field tracer experiments version 2.0.” Res. Rep. No. 137, U.S. Salinity Laboratory, Agricultural Research Service, U.S. Department of Agriculture, Riverside, Calif.
36.
Van Genuchten, M. T., and Parker, J. C. (1984). “Boundary conditions for displacement experiments through short laboratory soil columns.” Soil Sci. Soc. Am. J., 48, 703–708.
37.
Van Genuchten, M. T., and Wierenga, P. J. (1976). “Mass transfer in sorbing porous media: I. Analytical solutions.” Soil Sci. Soc. Am. J., 40, 473–480.
Information & Authors
Information
Published In
History
Published online: Jul 1, 1999
Published in print: Jul 1999
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.