Stress Transfer and Deformation Mechanisms around a Diaphragm Wall Panel
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 124, Issue 7
Abstract
Practicing engineers and researchers are becoming aware of the importance of ground movements and stress changes in the ground that may occur during the construction of a diaphragm wall type of retaining walls. In this paper, the construction sequence of a typical diaphragm wall panel in stiff clay is fully simulated using a three-dimensional finite difference program. Computed results are compared with some reported results of centrifuge model tests and relevant case histories. It has been found that the influence zone due to the diaphragm wall panel installation falls within a normal distance of approximately one panel depth, D, from the face of the panel, 1/3D below from the toe and 1/3L from the edge and along the length of the panel (L). Significant horizontal stress reduction behind the center of the panel is attributed to both the downward load transfer and the horizontal arching mechanisms. A settlement bowl appears behind the panel. The maximum settlement occurs at a distance of about 0.2D behind the wall and settlements beyond the influence zone are found to be insignificant.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Atkinson, J. H., and Sällfors, G.(1991). “Experimental determination of stress-strain-time characteristics in laboratory and in-situ tests.”Proc., 10th Eur. Conf. Soil Mech. and Found. Engrg., A. A. Balkema, Rotterdam, The Netherlands, 3, 915–956.
2.
Butcher, A. P., and Powell, J. J. M.(1995). “The effects of geological history on the dynamic stiffness in soils.”Proc., 11th Eur. Conf. Soil Mech. and Found. Engrg., Copenhagen, 1, 27–36.
3.
Clough, G. W., and O'Rourke, T. D. (1990). “Construction induced movements of in-situ walls.”Design and performance of an earth retaining structure, Geotech. Spec. Publ. No. 25, ASCE, New York, N.Y., 439–470.
4.
Dasari, G. R. (1996). “Modeling the variation of soil stiffness during sequential construction,” PhD thesis, University of Cambridge, Cambridge, U.K.
5.
Farmer, I. W., and Attewell, P. B.(1973). “Ground movements caused by a bentonite-supported excavation in London clay.”Geotechnique, 23(4), 577–581.
6.
Fast lagrangian analysis of continua (FLAC-3D), version 1.1, user's manuals. (1996). Itasca Consulting Group, Inc., Minnesota.
7.
Gunn, M. J., Satkunananthan, A., and Clayton, C. R. I. (1993). “Finite element modeling of installation effects.”Retaining structures, Thomas Telford Ltd., London, England, 46–55.
8.
Humpheson, C., Fitzpatrick, A. J., and Anderson, J. M. D.(1987). “Discussions on the basements and substructure for the new headquarters of the Hong Kong and Shanghai Banking Corporation, Hong Kong.”Proc., Inst. Civ. Engrg. Part 1, 82, 831–858.
9.
Lings, M. L., Nash, D. F. T., Ng, C. W. W., and Boyce, M. D.(1991). “Observed behaviour of a deep excavation in Gault clay: A preliminary appraisal.”Proc., 10th Eur. Conf. Soil Mech. and Found. Engrg., A. A. Balkema, Rotterdam, The Netherlands, 2, 467–470.
10.
Lings, M. L., Ng, C. W. W., and Nash, D. F. T.(1994). “The lateral pressure of wet concrete in diaphragm wall panels cast under bentonite.”Proc., Inst. Civ. Engrg. Geotech. Engrg., 107, 163–172.
11.
Ng, C. W. W. (1992). “An evaluation of soil-structure interaction associated with a multi-propped excavation,” PhD thesis, University of Bristol, Bristol, U.K.
12.
Ng, C. W. W., Bolton, M. D., and Dasari, G. R.(1995a). “The small strain stiffness of a carbonate stiff clay.”Soils and Found., Tokyo, Japan, 35(4), 109–114.
13.
Ng, C. W. W., Ling, M. L., Simpson, B., and Nash, D. F. T.(1995b). “An approximate analysis of the three-dimensional effects of diaphragm wall installation.”Geotechnique, 45(3), 497–507.
14.
Powell, J. J. M., and Butcher, A. P.(1991). “Assessment of ground stiffness from field and laboratory tests.”Proc., 10th Eur. Conf. Soil Mech. and Found. Engrg., Florence, A. A. Balkema, Rotterdam, The Netherlands, 1, 153–156.
15.
Powrie, W., and Kantartzi, C.(1996). “Ground response during diaphragm wall installation in clay: Centrifuge model tests.”Geotechnique, 46(4), 725–739.
16.
Powrie, W., and Li, E. S. F.(1991). “Finite element analyses of an in situ wall propped at formation level.”Geotechnique, 41(4), 499–514.
17.
Symons, I. F., and Carder, D. R. (1993). “Stress changes in stiff clay caused by the installation of embedded retaining walls.”Retaining structures, Thomas Telford Ltd., London, England, 227–236.
18.
Tatsuoka, F., and Kohata, Y.(1994). “Stiffness of hard soils and soft rocks in engineering application.”Proc., Int. Symp. on Pre-failure Deformation Characteristics of Geomaterials, Hokkaido, Japan, A. A. Balkema, Rotterdam, The Netherlands, 2, 947–1063.
19.
Tedd, P., Chard, B. M., Charles, J. A., and Symons, I. F.(1984). “Behavior of a propped embedded retaining wall in stiff clay at Bell Common Tunnel.”Geotechnique, 34(4), 513–532.
20.
Terzaghi, K., and Peck, R. B. (1967). Soil mechanics in engineering practice, 2nd Ed. John Wiley and Sons, Inc., New York, N.Y.
21.
Thompson, P. (1991). “A review of retaining wall behavior in overconsolidated clay during early stages of construction,” MPhil thesis, University of London, London, U.K.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 124 • Issue 7 • July 1998
Pages: 638 - 648
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: Jul 1, 1998
Published in print: Jul 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.