Experimental Verification of CRS Consolidation Theory
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 123, Issue 5
Abstract
The paper presents and analyzes results from nine constant rate of strain (CRS) consolidation tests on resedimented Boston blue clay (BBC) using a specially instrumented, computer-automated hydraulic consolidation device. Specimens were loaded using one of three vertical strain rates (0.1, 1, and 3%/h), and pore pressures were measured at three points through the specimen height and at the base. The CRS results were compared to the end of primary states in four incrementally loaded (IL) oedometer tests performed using standard procedures. At the two faster CRS rates, excess pore pressures (Δu) developed and two methods were used to compute vertical effective stress nonlinear CRS theory of Wissa et al. that depends in part on Δu measured only at the base; and direct integration of the measured Δu distribution through the specimen (the “isochrone method”). The results show that at the two faster rates, the CRS tests based on nonlinear CRS theory are consistent with those obtained using the isochrone method; results from CRS tests at all three rates compare well with the IL test results, despite base Δu values exceeding 70% of applied vertical stress in the 3%/h CRS tests. The CRS behavior of resedimented BBC is virtually independent of strain rate across the range tested; the value of preconsolidation pressure is rate independent as is the virgin compressibility. At levels at and above CRS tests loaded at 1 and 3%/h yielded coefficients of consolidation and hydraulic conductivity values that agreed well with IL test values. The paper supports the validity of nonlinear CRS theory and suggests that less structured clays such as those tested may have less rate dependence during consolidation than soils with strong interparticle bonding and structure.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Armour, D. W. Jr., and Drnevich, V. P. (1986). “Improved techniques for the constant-rate-of-strain consolidation test.”Consolidation of soils: testing and evaluation, ASTM Spec. Tech. Publ. no. 892, R. N. Yong and F. C. Townsend, eds., ASTM, Philadelphia, 170–183.
2.
Bjerrum, L.(1967). “Engineering geology of Norwegian normally consolidated marine clays as related to the settlements of buildings.”Geotechnique, 17, 83–118.
3.
Crawford, C. B.(1964). “Interpretation of the consolidation test.”J. Soil Mech. and Found. Div., ASCE, 90(5), 87–102.
4.
Gorman, C. T., Hopkins, T. C., Deen, R. C., and Drnevich, V. P.(1978). “Constant-rate-of-strain and controlled-gradient consolidation testing.”Geotech. Testing J., 1(1), 3–15.
5.
Hamilton, J. J., and Crawford, C. B. (1959). “Improved determination of preconsolidation pressure of a sensitive clay.”Papers on Soils, ASTM Spec. Tech. Publ. no. 254, ASTM, Philadelphia, 254–270.
6.
Jamiolkowski, M., Ladd, C. C., Germaine, J. T., and Lancellotta, R.(1985). “New developments in field and laboratory testing of soils.”Proc., 11th Int. Conf. on Soil Mech. and Found. Engrg., A. A. Balkema, Rotterdam, The Netherlands, 1, 57–154.
7.
Kabbaj, M., Tavenas, F., and Leroueil, S.(1988). “In situ and laboratory stress-strain relationships.”Geotechnique, 38(1), 83–100.
8.
Ladd, C. C., Foott, R., Ishihara, K., Schlosser, F., and Poulos, H. G. (1977). “Stress-deformation and strength characteristics.”Proc., 9th Int. Conf. on Soil Mech. and Found. Engrg., 421–494.
9.
Lambe, T. W., and Whitman, R. V. (1969). Soil mechanics. John Wiley & Sons, Inc., New York, N.Y.
10.
Leroueil, S., Kabbaj, M., Tavenas, F., and Bouchard, R.(1985). “Stress-strain-strain rate relation for the compressibility of sensitive natural clay.”Geotechnique, 35(2), 159–180.
11.
Leroueil, S., Samson, L., and Bozozuk, M.(1983a). “Laboratory and field determination of preconsolidation pressure at Gloucester.”Can. Geotech. J., 20, 477–490.
12.
Leroueil, S., Tavenas, F., Samson, L., and Morin, P.(1983b). “Preconsolidation pressure of Champlain clays. part II. laboratory determination.”Can. Geotech. J., 20, 803–816.
13.
Mesri, G., and Choi, Y. K.(1985). “The uniqueness of the end-of-primary (EOP) void ratio—effective stress relationship.”Proc., 11th Int. Conf. on Soil Mech. and Found. Engrg., A. A. Balkema, Rotterdam, The Netherlands, 1, 587–590.
14.
Rowe, P. W., and Barden, L.(1966). “A new consolidation cell.”Geotechnique, 16(2), 162–170.
15.
Seah, T. H. (1990). “Anisotropy of Boston blue clay,” ScD thesis, Massachusetts Inst. of Technol., Cambridge, Mass.
16.
Sheahan, T. C., Ladd, C. C., and Germaine, J. T.(1996). “Rate-dependent undrained shear behavior of saturated clay.”J. Geotech. Engrg., ASCE, 122(2), 99–108.
17.
Sheahan, T. C., and Watters, P. J.(1996). “Using an automated Rowe cell for constant rate of strain consolidation testing.”Geotech. Testing J., 19(4), 354–363.
18.
Smith, R. E., and Wahls, H. E.(1969). “Consolidation under constant rates of strain.”J. Soil Mech. and Found. Div., ASCE, 95(2), 519–539.
19.
Suklje, L. (1957). “The analysis of the consolidation process by the isotaches method.”Proc., 4th Int. Conf. on Soil Mech. and Found. Engrg., 200–206.
20.
Taylor, D. W. (1942). “Research on the consolidation of clays.”Serial 82, Dept. of Civ. Engrg., Massachusetts Inst. of Technol., Cambridge, Mass.
21.
Vaid, Y. P., Robertson, P. K., and Campanella, R. G.(1979). “Strain rate behavior of Saint-Jean-Vianney clay.”Can. Geotech. J., 16(1), 34–42.
22.
Watters, P. J. (1994). “Development and use of a computer automated hydraulic consolidation cell to investigate strain rate effects in consolidation,” MS thesis, Northeastern Univ., Boston.
23.
Wissa, A. E. Z., Christian, J. T., Davis, E. H., and Heiberg, S.(1971). “Consolidation testing at constant rate of strain.”J. Soil Mech. and Found. Div., ASCE, 97(10), 1393–1413.
Information & Authors
Information
Published In
Copyright
Copyright © 1997 American Society of Civil Engineers.
History
Published online: May 1, 1997
Published in print: May 1997
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.