Soil Plugging and Relaxation in Pipe Pile during Earthquake Motion
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 123, Issue 10
Abstract
The objective of this paper is to investigate the effect of seismic loading of soil on the relaxation of the resistance of soil plugs in open-ended pipe piles driven into saturated sand. An experimental study was performed at small scale by driving an instrumented open-ended model pile into saturated sand in a pressure chamber by impact and vibration, performing static compression loading tests to failure, applying simulated horizontal seismic shaking to the soil, and extracting the piles and loading the plugs. During static compression loading, slippage of the plug relative to the interior surface of the pile did not occur in either the impacted or vibrated piles, although the plug in the vibrated pile developed only about 0.5–0.7 times the resistance of the plug in the impacted pile. Most relaxation in pile resistance during seismic loading occurred in outer shaft friction and not in the plugs. Static loading of the plugs after the seismic event indicated that they remained intact.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
De Beer, E. E.(1963). “The scale effect in the transposition of the results of deep-sounding tests on the ultimate bearing capacity of piles and cassion foundations.”Geotechnique, 13(1), 39–75.
2.
Kishida, H., and Isemoto, N. (1977). “Behavior of sand plugs in open-ended steel pipe piles.”Proc., 9th ICSMFE, Int. Soc. for Soil Mech. and Found. Engrg., Vol. 1, 601–604.
3.
Klos, J., and Tejchman, A. (1977). “Analysis of behavior of tubular piles in subsoil.”Proc., 9th ICSMFE, Int. Soc. for Soil Mech. and Found. Engrg., Vol. 1, 605–608.
4.
Klos, J., and Tejchman, A. (1981). “Bearing capacity calculation for pipe piles.”Proc., 10th ICSMFE, Int. Soc. for Soil Mech. and Found. Engrg., Vol. 2, 151–153.
5.
O'Neill, M. W., and Raines, R. D.(1991). “Load transfer for pipe piles in highly pressured dense sand.”J. Geotech. Engrg., ASCE, 117(8), 1208–1226.
6.
O'Neill, M. W., Vipulanandan, C., and Ochoa, M. (1990). “Response of tension piles to simulated seismic motion in saturated fine sand.”Rep. No. UHCEE 90-09, Univ. of Houston, Houston, Tex.
7.
O'Neill, M. W., Vipulanandan, C., and Ochoa, M. (1992). “Laboratory scale modeling of pullout behavior of bias-loaded tension piles during earthquakes.”Proc., 24th Offshore Technol. Conf., 55–62.
8.
Paik, K., Lee, J., and Lee, S.(1993). “Effects of soil conditions on the behavior of open-ended steel pipe pile.”J. Korean Geotech. Soc., 9(3), 23–33.
9.
Paikowsky, S. G., and Whitman, R. V.(1990). “The effects of plugging on pile performance and design.”Can. Geotech. J., 27(3), 429–440.
Information & Authors
Information
Published In
Copyright
Copyright © 1997 American Society of Civil Engineers.
History
Published online: Oct 1, 1997
Published in print: Oct 1997
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.