Model Validation for Bridge-Road-Vehicle Dynamic Interaction System
Publication: Journal of Bridge Engineering
Volume 8, Issue 2
Abstract
The dynamic response of highway bridges subjected to moving truckloads has been observed to be dependent on (1) dynamic characteristics of the bridge; (2) truck configuration, speed, and lane position on the bridge; and (3) road surface roughness profile of the bridge and its approach. Historically, truckloads were measured to determine the load spectra for girder bridges. However, truckload measurements are either made for a short period of time [for example, weigh-in-motion (WIM) data] or are statistically biased (for example, weigh stations) and cost prohibitive. The objective of this paper is to present results of a 3D computer-based model for the simulation of multiple trucks on girder bridges. The model is based on the grillage approach and is applied to four steel girder bridges tested under normal truck traffic. Actual truckload data collected using a discrete bridge WIM system are used in the model. The data include axle loads, truck gross weight, axle configuration, and statistical data on multiple presence (side by side or following). The results are presented as a function of the static and dynamic stresses in each girder and compared with code provisions for dynamic load factor. The study provides an alternate method for the development of live-load models for bridge design and evaluation.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. (1992). “Standard specifications for highway bridges.” Washington, D.C.
AASHTO. (1998). “LRFD specifications for highway bridges.” Washington, D.C.
Bakht. B., and Pinjarkar, G. (1989). “Dynamic testing of highway bridges.” Transportation Research Record 1223, 93–100.
Biggs, J.M., Suer, H.S., and Louw, J.M.(1956). “Vibration of single span highway bridges.” Trans., ASCE, 124, 291–318.
Billing, J.R. (1982). “Dynamic tests of bridges in Ontario, 1980 data capture, test procedure, and data processing.” Research and Development Reports, Vol. 26, Ministry of Transportation and Communication, Ontario, Canada.
Billing, J.R.(1984). “Dynamic loading and testing of bridges in Ontario.” Can. J. Civ. Eng., 11(4), 883–843.
Cantieni, R. (1983). “Dynamic load tests on highway bridges in Switzerland: 60 years experience of EMPA.” Tech. Rep. 211, Swiss Federal Laboratory for Materials Testing and Research, Dubendorf, Switzerland.
Fancher, H., Ervin, R., MacAdam, C., and Winkler. (1980). “Measurement and representation of the mechanical properties of truck leaf springs.” Tech. Paper Series 800905, Society of Automotive Engineers, Warrendale, Pa.
Honda, H., Kobori, T., and Yamada, Y. (1986). “Dynamic factor of highway steel girder bridges.” Proc., Int. Association of Bridge and Structural Engineering, P-98/86, 57–75.
Liu, M. (1996). “A 3-D dynamic model for bridge-road-vehicle system.” Master’s thesis, Bradley Univ., Peoria, Ill.
Nassif, H.H. (1993). “Live load spectra for girder bridges.” PhD dissertation, Dept. of Civil and Environmental Engineering, Univ. of Michigan.
Nassif, H.H., Liu, M., and Ertekin, A. (2001). “Development of dynamic load model using computer simulation.” Proc., Int. Conf. on Statistics, Safety and Reliability, (in press).
Nassif, H.H., and Nowak, A.S. (1995). “Dynamic load spectra for Girder Bridges.” Journal of the Transportation Research Board, No. 1476, Transportation Research Board, National Research Council, Washington, D.C., 69–83.
O’Connor, C., and Chan, T.H.T.(1988). “Dynamic wheel loads from bridges strains.” J. Struct. Eng., 114(8), 1703–1723.
O’Connor, C., and Pritchard, R.W.(1985). “Impact studies on small composite girder bridge.” J. Struct. Eng., 111(3), 641–653.
Ontario Ministry of Transportation (MTO). (1993). Ontario highway bridge design code, 3rd Ed., Ontario, Canada.
Paultre, P., Prouix, J., and Talbot, M.(1995). “Dynamic testing procedures for highway bridges using traffic loads.” J. Struct. Eng., 121(2), 362–376.
Swiss Association for Standardization (SNV). (1989). “Actions on structures.” SIA 160, Swiss Society of Engineers and Architects, Zurich, Switzerland.
Ugur, H.E. (1995). “Girder Distribution Factors For Skew Steel Girder bridges.” master’s thesis, Bradley Univ., Peoria, Ill.
Yang, Y.-B., Liao, S.-S., and Lin, B.-H.(1995). “Impact formulas for vehicles moving over simple and continuous beams.” J. Struct. Eng., 121(11), 1644–1650.
Yang, Y.-B., and Lin, B.-H.(1995). “Vehicle-bridge interaction analysis by dynamic condensation method.” J. Struct. Eng., 121(11), 1636–1643.
Information & Authors
Information
Published In
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: Feb 8, 2002
Accepted: May 16, 2002
Published online: Feb 14, 2003
Published in print: Mar 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.