Dynamic Behavior of Steel Deck Tension-Tied Arch Bridges to Seismic Excitation
Publication: Journal of Bridge Engineering
Volume 7, Issue 1
Abstract
The dynamic responses of steel deck, tension-tied, arch bridges subjected to earthquake excitations were investigated. The 620 ft (189 m) Birmingham Bridge, located in Pittsburgh, was selected as an analytical model for the study. The bridge has a single deck tension-tied arch span and is supported by two bridge piers, which in turn are supported by the pile foundations. Due to the complex configuration of the deck system, two analytical models were considered to represent the bridge deck system. Using the normal mode method, seismic responses were calculated for two bridge models and the results were compared with each other. Three orthogonal records of the El Centro 1940 earthquake were used as input for the seismic response analysis. The modal contributions were also checked in order to obtain a reasonable representation of the response and to minimize computational cost. Displacements and stresses at the panel points of the bridge are calculated and presented in graphical form.
Get full access to this article
View all available purchase options and get full access to this article.
References
Abdel-Ghaffar, A. M., and Rubin, L. I.(1982). “Suspension bridge response to multiple-support excitations.” J. Eng. Mech. Div., 108(2), 419–435.
Abdel-Ghaffar, A. M., and Rubin, L. I.(1983). “Vertical seismic behavior of suspension bridges.” Earthquake Eng. Struct. Dyn., 11(1), 1–19.
ASCE. (1986). Seismic analysis of safety-related nuclear structures and commentary on standard for seismic analysis of safety related nuclear structures, New York.
AASHTO. (1965). Standard specifications for highway bridges, adopted by the American Association of State Highway and Transportation Officials, Washington, D.C.
Bielak, J.(1976). “Modal analysis for building-soil interaction.” J. Eng. Mech. Div., 102(5), 771–786.
Dusseau, R. A., and Wen, R. K. (1982). “Seismic responses of two deck arch bridges.” Proc., ASCE Annual Convention, New York, Preprint 82-010.
El Sharnouby, B., and Novak, M.(1984). “Dynamic experiments with group of piles.” J. Geotech. Eng. Div., 110(6), 719–737.
Fleming, J. F., and Egeseli, E. A.(1980). “Dynamic behavior of cable-stayed bridge.” Earthquake Eng. Struct. Dyn., 8(1), 1–16.
Hinton, E., and Owen, D. R. J. (1977). Finite element programming, Academic, London.
Imbsen, R. A., Nutt, R. V., and Penzien, J. (1978). “Seismic response of bridges-case studies.” Technical Rep. UCB/EERC-78/14, Earthquake Engineering Research Center, Univ. of California, Berkeley, Calif.
Lee, H. E., and Torkamani, M. A. M. (1998). “Dynamic response of tied arch bridges to earthquake excitations.” Research Rep. ST-3, Dept. of Civil Engineering, Univ. of Pittsburgh, Pittsburgh.
National Earthquake Hazards Reduction Program (NEHRP). (1998). Proc., NERHP Conf. and Workshop on Research on the Northridge, California Earthquake of January 17, 1994, California Universities for Research in Earthquake Engineering, Richmond, Calif.
Novak, M., and Beredugo, Y. O. (1971). “The effect of embedment on footing vibration.” Proc., 1st Canadian Conf. on Earthquake Engineering, Univ. of British Columbia, Vancouver, Canada.
Novak, M. (1974). “Dynamic stiffness and damping of piles.” Can. Geotech. J., 11(4), 574–598.
Novak, M., and El Sharnouby, B.(1984). “Evaluation of dynamic experiments on pile group.” J. Geotech. Eng., 110(6), 738–756.
Nuclear Regulatory Commission (NRC). (1976). Regulatory guide 1.92: combining modal responses and spatial components in seismic response analysis, Washington, D.C.
Poulos, H. G.(1979). “Group factors for pile-deflection estimation.” J. Geotech. Eng. Div., Am. Soc. Civil. Eng. 105(12), 1489–1509.
Prakash, S., Ed. (1992). Piles under dynamic loads, ASCE, New York.
Roesset, J. M. (1980). “Stiffness and damping coefficients of foundations.” Proc., Dynamic Response of Pile Foundations: Analytical Aspects, ASCE, New York, 1–3.
Tseng, W. S., and Penzien, J. (1973). “Analytical investigations of the seismic response of long multiple span highway bridge.” Technical Rep. EERC 73-12, Earthquake Engineering Research Center, Univ. of California, Berkeley, Calif.
Torkamani, M. A. M., and Koubaa, R. (1991). “Seismic analysis and design guidelines for highway bridges in Pennsylvania.” Research Rep. ST-5, Dept. of Civil Engineering, Univ. of Pittsburgh, Pittsburgh.
Information & Authors
Information
Published In
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Received: Jun 3, 1999
Accepted: Jan 10, 2000
Published online: Jan 1, 2002
Published in print: Jan 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.