Validated Analysis of Wheeling Suspension Bridge
Publication: Journal of Bridge Engineering
Volume 4, Issue 1
Abstract
The historic Wheeling suspension bridge over the Ohio River is one of the 57 long-span suspension bridges in operation in the United States. The bridge was designed and constructed in 1849 by Charles Ellet, Jr., who rightfully may be considered the father of the modern American suspension bridge. Despite the fact that the bridge was not designed to carry today's live loads, the bridge has served as a vital link across the Ohio River for nearly a century and a half. This paper represents the first comprehensive structural analysis using modern computer techniques and in situ nondestructive testing evaluation of this bridge. Static analysis showed that deflections and stresses caused by present-day loading conditions are within allowable limits. Rating factors demonstrated that none of the structural members are overstressed by the posted live load. Seismic analysis to the American Association of State Highway and Transportation Officials loads showed little damage, which was confined to floor beams at the east tower. Analysis using historic earthquakes showed localized damage of floor beams and diagonal floor ties at the east tower and top chords of the stiffening truss at midspan. The methodology developed could be applied to a wide range of cable suspension bridges.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Abdel-Ghaffer, A. M. ( 1982). “Vertical seismic behavior of suspension bridges.” Int. J. Earthquake Engrg. and Struct. Dynamics, 11(1), 1–19.
2.
Abdel-Ghaffer, A. M. (1983). “Lateral earthquake response of suspension bridges.”J. Struct. Engrg., ASCE, 109(3), 664–675.
3.
Abdel-Ghaffer, A. M., and Rubin, L. I. (1982). “Suspension bridge response to multiple-support excitations.”J. Engrg. Mech. Div., ASCE, 108(2), 419–435.
4.
American Association of State Highway and Transportation Officials (AASHTO) ( 1992). “Standard Specifications for Highway Bridges.” American Association of State Highway and Transportation Officials, Washington, D.C.
5.
Bleich, F., McCullough C. B., Rosecrams, R., and Vincent, G. S. ( 1950). The mathematical theory of vibration in suspension bridges . U.S. Government Printing Office, Washington, D.C.
6.
Castellani, A. (1987). “Safety margins of suspension bridges under seismic conditions.”J. Struct. Engrg., ASCE, 113(7), 1600–1616.
7.
Department of the Army, the Navy, and the Air Force, TM5-809-10-1. ( 1986). Technical manual: Seismic design guidelines for essential buildings . Department of the Army, the Navy, and the Air Force, Washington, D.C.
8.
Department of Highways. ( 1981). “Wheeling suspension bridge.” Contractors Proposal, Department of Highways, Charleston, W. Va.
9.
Dumanoglu, A. A., Brownjohn, J. M. W., and Severn, R. T. ( 1992). “Seismic analysis of the Fatih Sultan Mehmat (second bosporus) suspension bridge.” J. Earthquake Engrg. and Struct. Dynamics, 21, 881–906.
10.
Federal Highway Administration (FHwA). ( 1987). “Seismic design and retrofit manual for highway bridges.” Rep. No. FHwA-IP-87-6, Office of Implementation, HRT-10, Federal Highway Administration, McLean, Va.
11.
Gade, R. H., Bosch, H. R., and Podolny Jr., W. (1976). “Recent aerodynamic studies of long-span bridges.”J. Struct. Div., ASCE, 102(7), 1299–1315.
12.
Gimsing, J. N. ( 1982). Cable supported bridges: Concept and design . Wiley, New York.
13.
Kemp, E. L. ( 1975). “Ellet's contribution to the development of suspension bridges.” Engrg. Issues—J. Profl. Act., ASCE 99(3), 391–412.
14.
King, H. M., McColloch J. S., and Spyrakos, C. C. ( 1993). “An earthquake hazard assessment for West Virginia.” Final Rep., West Virginia Geological and Economic Survey, W. Va.
15.
Kumarasena, T., Scanlan, R. H., and Ehsan, F. (1991). “Wind-induced motions of Deer Isle Bridge.”J. Struct. Engrg., ASCE, 117(11), 3356–3374.
16.
Lichtenstein, A. G. & Associates ( 1992). “Final bridge inspection report.” Langhorne, Pa.
17.
Nader, R. T. ( 1993). “Testing and enhancement of the axial load monitor for axially loaded bridge members of general profiles,” MS thesis, Coll. of Engrg., West Virginia University, Morgantown, W. Va.
18.
Okamoto, S. ( 1983). Introduction to earthquake engineering . University of Tokyo Press, Tokyo.
19.
Seim, C., Ingham, T., and Rodriguez, S. ( 1993). “Seismic performance and retrofit of the Golden Gate Bridge.” Spatial/Lattice/Tension Struct., ASCE Struct. Congr. XII, American Society of Civil Engineers, New York, 762–771.
20.
Siros, K. ( 1992). “Assessment of stresses in axially loaded structural members,” MS thesis, Coll. of Engrg., West Virginia University, Morgantown, W. Va.
21.
Spyrakos, C. C. ( 1992). “Seismic behavior of bridge piers including soil-structure interaction.” Com. and Struct., 43(2), 373–384.
22.
Spyrakos, C. C. ( 1994). Finite element modeling in engineering practice . First Print, West Virginia University Press, West Virginia University, Morgantown, W. Va., Second Print, Algor Press, Pittsburgh, Pa.
23.
Steinman ( 1929). A practical treatise on suspension bridges, 2nd Ed., Wiley, New York.
24.
Tsien, L. H. ( 1949). “A simplified method of analyzing suspension bridges.” Trans. ASCE, 114.
25.
Ulstrup, C. C. (1993). “Rating and preliminary analysis of suspension bridges.”J. Struct. Engrg., ASCE, 119(9), 2653–2679.
26.
Venkatareddy, R. ( 1995). “Validated analysis of historic bridges,” MS thesis, Coll. of Engrg., West Virginia University, Morgantown, W. Va.
27.
West, H. H., Suhoski, J. E., and Geschwindner Jr., L. F. (1984). “Natural frequencies and modes of suspension bridges.”J. Struct. Engrg., ASCE, 110(10), 2471–2486.
28.
Wilson, J. C., and Gravelle, W. ( 1991). “Modeling of a cable-stayed bridge for dynamic analysis.” J. Earthquake Engrg. and Struct. Dynamics, 20, 707–721.
Information & Authors
Information
Published In
History
Received: Jul 12, 1995
Published online: Feb 1, 1999
Published in print: Feb 1999
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.