Influence of Pump Intake Location on Well Efficiency
Publication: Journal of Hydrologic Engineering
Volume 8, Issue 4
Abstract
We tested the influence of pump intake location on well efficiency using three intake locations—one above the screen, as recommended by current well design guidelines, and two in the screen. Testing was done in a semicircular physical model of a well with a screen, casing, and gravel pack. The experiments used three screen slot sizes, two sand sizes, and average screen entrance velocities from 0.18 to 0.55 m/s. For the finer sand, experimental results indicated that placing the pump intake at both positions in the screen increased well efficiency; the lowest intake position was generally the most efficient. For the coarser sand, the lowest intake position was also the most efficient; the intake position above the screen and the higher intake position in the screen produced similar, and lower, well efficiencies. These results indicate that the common practice of placing the pump intake above the screen may lead to less efficient well designs. The physical model also showed that the hydraulic head distribution along the length of the screen is not uniform, but has the lowest head values near the pump intake, suggesting that flow concentrates in this region. The low head values near the intake decreased as the screen slot size decreased or as the flow rate increased.
Get full access to this article
View all available purchase options and get full access to this article.
References
Bear, J. (1988). Dynamics of fluids in porous media, Dover, New York.
Bekker, K. F. (2001). “Flow through well screens as a function of pump intake location.” MS thesis, Univ. of North Dakota, Grand Forks, N.D.
Bouwer, H. (1978). Groundwater hydrology, McGraw-Hill, New York.
Clark, L., and Turner, P. A.(1983). “Experiments to assess the hydraulic efficiency of well screens.” Ground Water, 21(3), 270–281.
Cooley, R. L., and Cunningham, A. B.(1979). “Consideration of total energy loss in theory of flow to wells.” J. Hydrol., 43(1/4), 161–184.
de Lara, G. C.(1955). “Discussion of ‘Effect of well screens on flow into wells’ by Petersen J. S., Rohwer, C., and Albertson, M. L.” Trans., Am. Soc. Civ. Eng.,120, 598–601.
Driscoll, F. G. (1986). Groundwater and wells, Johnson Division, St. Paul, Minn.
Garg, S. P., and Lal, J.(1971). “Rational design of well screens.” J. Irrig. Drain. Div.,97(1), 131–147.
Kaleris, V. (1989). “Inflow into monitoring wells with long screens.” Contaminant transport in groundwater, Proc., Int. Symp. on Contaminant Transport in Groundwater, H. E. Kobus and W. Kinzelbach, eds., Balkema, Rotterdam, The Netherlands, 41–50.
Korom, S. F., Bekker, K., and Helweg, O. J. (1999). “Using physical models in well design and operation: An example with pump intake location.” 1999 Int. Water Resources Engineering Conf. (CD-Rom), ASCE, Reston, Va.
National Ground Water Association. (2002). “FAQs and ground water facts.” 〈http://www.ngwa.org/public/faqs.html〉 (Jan. 8, 2003).
Petersen, J. S., Rohwer, C., and Albertson, M. L.(1955). “Effect of well screens on flow into wells.” Trans., Am. Soc. Civ. Eng., 120, 563–585.
Roscoe Moss Company. (1990). Handbook of ground water development, Wiley, New York.
Soliman, M. M.(1965). “Boundary flow considerations in the design of wells.” J. Irrig. Drain. Div.,91(1), 159–177.
Surfer for Windows Version 6 user’s guide. (1997). Golden Software, Golden, Colo.
Von Hofe, F., and Helweg, O. J.(1998). “Modeling well hydrodynamics.” J. Hydraul. Eng., 124(12), 1198–1202.
Von Hofe, F. P. (1998). “Optimal well design.” PhD dissertation, Univ. of Memphis, Memphis, Tenn.
Williams, D. E. (1981). The well/aquifer model: Initial test results, Roscoe Moss, Los Angeles.
Williams, D. E.(1995). “Modern techniques in well design.” J. Am. Water Works Assoc., 77(9), 68–74.
Information & Authors
Information
Published In
Journal of Hydrologic Engineering
Volume 8 • Issue 4 • July 2003
Pages: 197 - 203
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: Jul 10, 2001
Accepted: Nov 26, 2002
Published online: Jun 13, 2003
Published in print: Jul 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.