Strength and Durability of Roller-Compacted HVFA Concrete Pavements
Publication: Practice Periodical on Structural Design and Construction
Volume 6, Issue 4
Abstract
This investigation was conducted to collect state-of-the-art information on the strength and durability of roller-compacted concrete (RCC) for pavement construction made with and without supplementary cementitious materials, and to describe the construction experience gained in two pavement projects (Projects I and II) recently completed in Wisconsin. Project I deals with performance of conventional high-volume fly ash (HVFA) concrete pavement having a roller-compacted, no-fines permeable base course containing fly ash obtained from an SO2 control technology (dry desulphuring process), and Project II deals with RCC pavement (RCCP) containing 30% ASTM Class C fly ash. Past studies have shown that mechanical behavior of RCCP is similar to that of conventional paving concrete. However, nonair-entrained RCC is susceptible to freezing and thawing (F and T) damage if critically saturated when subjected to freezing actions. Laboratory testing of specimens derived from the pavements showed excellent results for conventional HVFA pavement, and satisfactory performance of the RCCP except for F and T resistance. Specimens from the RCCP performed poorly in laboratory freezing and thawing testing according to ASTM C 666, Procedure A. However, they showed adequate performance for up to 210 cycles of F and T when tested in accordance with ASTM C 666, Procedure B.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
American Concrete Institute (ACI). ( 1996). “State-of-the-art report on roller-compacted concrete pavements.” ACI 325.10R-95, Manual of concrete practice, Vol. 2, Detroit.
2.
American Concrete Institute (ACI) Committee 309. ( 1998). “Compaction of roller-compacted concrete.” ACI 309.5R-XX—Final draft 6, Detroit.
3.
Banthia, N., Pigeon, M., Marchand, J., and Biosvert, J. (1992). “Permeability of roller compacted concrete.”J. Mat. in Civ. Engrg., ASCE, 4(1), 27–40.
4.
Bland, A. E., Kissel, R. K., and Ross, G. G. ( 1991). “Utilization of CFBC ashes in roller compacted concrete applications.” Proc., 11th Int. Conf. on Fluidized Bed Combustion, Vol. 2, ASME, New York, 857–863.
5.
Brendel, G. F., and Kelly, J. M. ( 1991). “Fly ash in roller compacted concrete pavement.” Energy in the 90's, B. F. Hobbs, ed., ASCE, New York, 333–338.
6.
Brett, D. M. ( 1988). “RCC pavements in Tasmania, Australia.” Proc., Roller Compacted Concrete II, ASCE, New York, 369–379.
7.
Cannon, R. W. ( 1993). “Air-entrained roller compact concrete.” Concrete Int., 15(5), 49–54.
8.
Chikada, T., and Matsushita, H. ( 1991). “Properties of roller compacted concrete using portland blast furnace slag cement.” J. Soc. Mat. Sci., Kyoto-Shi, Japan, 40(456), 1228–1234.
9.
Department of the Army and the Air Force. ( 1987). “Standard practice for concrete pavements.” Departments of the Army and the Air Force technical manual, Army TM 5-822-7, Air Force AFM 88-6, Chapter 8, Appendix D, D-1–D-15.
10.
Dolen, T. P. ( 1996). “Freeze-thaw durability of roller-compacted concrete.” Spring Convention, ACI, Detroit, 1–6.
11.
Gagne, R. ( 1999). “Proportioning for non-air-entrained RCCP.” Concrete Int., 21(5), 37–41.
12.
Ghafoori, N., and Cai, Z. ( 1995a). “Laboratory-made roller compacted concretes containing dry bottom ash. Part I: Mechanical properties.” ACI Mat. J., 95(2), 121–130.
13.
Ghafoori, N., and Cai, Z. ( 1995b). “Laboratory-made roller compacted concretes containing dry bottom ash. Part II: Long-term durability.” ACI Mat. J., 95(2), 244–251.
14.
Ghafoori, N., and Zhang, Z. ( 1995). “Sulfate resistance of roller compacted concrete.” ACI Mat. J., 95(4), 347–355.
15.
Hess, J. R. ( 1988). “RCC storage pads at Tooele Army Depot, Utah.” Roller Compacted Concrete II, K. D. Hansen and L. K. Guice, eds., ASCE, New York, 394–409.
16.
Jofre, C., Fernandez, R., Josa, A., and Molina, F. ( 1988). “Spanish experience with RCC pavements.” Proc., Roller Compacted Concrete II, ASCE, New York, 467–483.
17.
Larson, J. L. ( 1986). “Roller-compacted concrete pavement design practices for intermodal freight terminals at the Port of Tacoma.” State-of-the-Art Rep. 4, Facing the challenge—The intermodal terminal of the future, Transp. Res. Board, National Research Council, Washington, D.C., 22–29.
18.
Liu, T. C. ( 1991). “Performance of roller compacted concrete—Corps of Engineers' experience.” ACI Spec. Publ. SP-126, Durability of concrete, 2nd Int. CANMET/ACI Conf., Vol. 11, American Concrete Institute, Detroit, 155–167.
19.
Marchand, J., Boisvert, L., Tremblay, S., Maltais, J., and Pigeon, M. ( 1998). “Air entrainment in no-slump mixes.” ACI Concrete Int., 20(4), 38–44.
20.
Marchand, J., Gagne, R., Ouellet, E., and Lepage, S. ( 1997). “Mixture proportioning of roller compacted concrete—A review.” Adv. in Concrete Technol., V. M.
21.
Naik, T. R., and Ramme, B. R. ( 1997). “Roller-compacted no-fines concrete for road base course.” Proc., 3rd CANMET/ACI Int. Symp. on Adv. in Concrete Technol., American Concrete Institute, Detroit, 201–220.
22.
Palmer, W. D. ( 1987). “Roller compacted concrete shows paving potential.” Roads and Bridges, September, 40–43.
23.
Pigeon, M., and Malhotra, V. M. (1995). “Frost resistance of roller-compacted high-volume fly ash concrete.”J. Mat. in Civ. Engrg., ASCE, 7(4), 208–211.
24.
Pigeon, M., and Marchand, J. ( 1996). “Frost resistance of roller-compacted concrete.” Concrete Int., 18(7), 22–26.
25.
Piggott, R. W., and Serne, R. A. ( 1995). “Roller compacted concrete—A permanent pavement for today and the future.” 2nd CANMET/ACI Int. Symp. on Adv. in Concrete Technol., Supplementary Papers, American Concrete Institute, Detroit, 115–128.
26.
Pittman, D. W. ( 1988). “RCC pavement construction and quality control.” Roller-Compacted Concrete II, K. D. Hansen and L. K. Guice, eds., ASCE, New York, 438–451.
27.
Portland Cement Association (PCA). ( 1994). 10(1), Skokie, Ill.
28.
Portland Cement Association (PCA). ( 1987). “Structural design of roller-compacted concrete for industrial pavements.” Concrete Information, Skokie, Ill.
29.
Prusinski, J. ( 1997). “Roller-compacted concrete carries a heavy load.” Roads and Bridges, July, 68–69.
30.
Ragan, S. A. ( 1988). “Proportioning RCC pavement mixtures.” Roller Compacted Concrete II, K. D. Hansen and L. K. Guice, eds., ASCE, New York, 380–393.
31.
Reagan, S. A., Pittman, D. W., and Grogan, W. P. ( 1990). “An investigation of the frost resistance of air-entrained and nonair-entrained roller-compacted concrete (RCC) for pavement applications.” Tech. Rep. No. GL-90-18, Final Rep., U.S. Army Corps of Engineers, Washington, D.C., 1-1–B-36.
32.
Rindal, D. B., and Horrigmoe, G. ( 1993). “High-quality roller compacted concrete pavements.” Utilization of high-strength concrete, Vol. 2, I. Holand and E. Sellevold, eds., Norwegian Concrete Association, Oslo, 913–920.
33.
Rollings, R. S. ( 1988). “Design of roller compacted concrete pavements.” Roller Compacted Concrete II, K. D. Hansen and L. K. Guice, eds., ASCE, New York, 454–466.
34.
Schweizer, E., and Raba, G. W. ( 1988). “Roller compacted concrete with marginal aggregates.” Roller Compacted Concrete II, K. D. Hansen and L. K. Guice, eds., ASCE, New York, 419–428.
35.
Serne, R. A. Trends in the use of roller compacted concrete pavements in Canada, Canadian Portland Cement Association, Edmonton, Alberta, Canada, 1–26.
36.
Tayabji, S. D., and Okamoto, P. A. ( 1987). “Engineering properties of roller-compacted concrete.” Transp. Res. Rec. 1136, Transportation Research Board, Washington, D.C., 33–45.
37.
U.S. Army Corps of Engineers (USACE). ( 1992). “Roller-compacted concrete.” Engineer manual EM 1110-2-2006, Washington, D.C., 1-1–E-37.
38.
Withrow, H. ( 1988). “Compaction parameters of roller compactee concrete.” Roller Compacted Concrete II, K. D. Hansen and L. K. Guice, eds., ASCE, New York, 123–135.
Information & Authors
Information
Published In
History
Received: Mar 7, 2001
Published online: Nov 1, 2001
Published in print: Nov 2001
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.