Performance of Roof Tiles under Simulated Hurricane Impact
Publication: Journal of Architectural Engineering
Volume 15, Issue 1
Abstract
Widespread damage to tile roofs over the last few years, even for weaker hurricanes, has raised concerns regarding construction practices and codes. An experimental study was carried out for clay and concrete roof tiles with adhesive- and mortar-set attachments using a “Wall of Wind” apparatus. The estimated peak gust wind speeds achieved in the simulations were 31.5 and (70.5 and ), as defined by the ASCE 7 Standard. Tests were conducted for winds from the 0° direction and subsequently, unless the roofs suffered significant damage, from the 50° direction. The research objectives were to assess roof-tile performance and observe failure modes in simulated hurricane conditions, and obtain wind pressure data allowing comparisons of measured pressures with pressures for components and cladding specified in the ASCE 7-05 Standard. Comparisons of pressure time histories for different tile systems showed that the external pressure on a tile is strongly influenced by the surface geometry of the tile. The concrete tile roof with mortar set showed the best performance among all tested roofs. Workmanship was found to be a major factor to roof-tile performance. Test results also suggested that the ASCE 7-05 pressure coefficient values are conservative for assessing wind loads acting on individual tiles.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study was supported by the Florida Department of Community Affairs through the International Hurricane Research Center. Tests were conducted using the mobile Wall of Wind funded by the Florida Division of Emergency Management. The findings and opinions presented in this paper are those of the writers and not necessarily the views of the sponsoring agencies.
References
Amano, T., Fujii, K., and Tazaki, S. (1988). “Wind loads on permeable roof-blocks in roof insulation systems.” J. Wind. Eng. Ind. Aerodyn., 29(1–3), 39–48.
ASCE. (2005). “Minimum Design Loads for Buildings and Other Structures.” ASCE/SEI 7-05, Reston, Va.
Bienkiewicz, B., and Sun, Y. (1992). “Wind-tunnel study of wind loading on loose-laid roofing systems.” J. Wind. Eng. Ind. Aerodyn., 43(1–3), 1817–1828.
Bienkiewicz, B., and Sun, Y. (1997). “Wind loading and resistance of loose-laid roof paver systems.” J. Wind. Eng. Ind. Aerodyn., 72(1), 401–410.
Blessing, C. M. (2007). “Mitigation of roof uplift through vortex suppression techniques.” MS thesis, Florida International University, Miami.
Florida Building Commission (FBC). (2004). Florida building code, Tallahassee, Fla.
Florida Roofing, Sheet Metal and Air Conditioning Association, Inc. (FRSA). (2005). Concrete and clay roof tile installation manual, 4th Ed., FRSA/TRI 07320, Winter Park, Fla.
Gerhardt, H. J., Kramer, C., and Bofah, K. K. (1990). “Wind loading on loosely laid pavers and insulation boards for flat roofs.” J. Wind. Eng. Ind. Aerodyn., 36, 309–318.
Hazelwood, R. A. (1980). “Principles of wind loading on tiled roofs and their application in the British Standard BS5534.” J. Wind. Eng. Ind. Aerodyn., 6(1–2), 113–124.
Hazelwood, R. A. (1981). “The interaction of the two principal wind forces on roof tiles.” J. Wind. Eng. Ind. Aerodyn., 8(1–2), 39–48.
Kawair, H., and Nishimura, H. (2003). “Field measurement on wind force on roof tiles.” Proc., 11th Int. Conf. on Wind Engineering, International Association for Wind Engineering and American Association for Wind Engineering, Texas Tech University, Lubbock, Tex., 599–606.
Kramer, C., and Gerhardt, H. J. (1983). “Wind loads on permeable roofing systems.” J. Wind. Eng. Ind. Aerodyn., 13(1–3), 347–358.
Leatherman, S. P., Gan Chowdhury, A., and Robertson, C. J. (2007). “Wall of wind full-scale, destructive testing of coastal houses and hurricane damage mitigation.” J. Coastal Res., 23(5), 1211–1217.
Levitan, M. L., Mehta, K. C., Vann, W. P., and Holmes, J. D. (1991). “Field measurements of pressures on the Texas Tech building.” J. Wind. Eng. Ind. Aerodyn., 38(2–3), 227–234.
Mehta, K. C., Levitan, M. L., Iverson, R. E., and McDonald, J. R. (1992). “Roof corner pressures measured in the field on a low building.” J. Wind. Eng. Ind. Aerodyn., 41–44(1–3), 181–192.
Miami-Dade County Building Code Compliance Office (MDC-BCCO). (2006). Post Hurricane Wilma progress assessment. Miami, 1–22.
Mirmiran, A., Abishdid, C., Wang, T. L., Huang, P., Jiménez, D. L., and Younes, C. (2007). “Performance of tile roofs under hurricane impact—Phase 2.” Rep. No. SCL-070801, Dept. of Civil and Environmental Engineering, Florida International University, Miami.
Morisaki, Y., Saito, T., Honda, A., and Saito, K. (1994). “Study on aerostatic force acting on roof tiles.” Jpn. J. Wind Eng., 58, 19–31.
Sadek, F., and Simiu, E. (2002). “Peak non-Gaussian wind effects for database-assisted low-rise building design.” J. Eng. Mech., 128(5), 530–539.
Simiu, E., Vickery, P., and Kareem, A. (2007). “Relation between Saffir–Simpson hurricane scale wind speeds and peak gust speeds over open terrain.” J. Struct. Eng., 133(7), 1043–1045.
Yu, B. (2007). “Surface mean flow and turbulence structure in tropical cyclone winds.” Ph.D. dissertation, Florida International University, Miami.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Nov 21, 2007
Accepted: Sep 26, 2008
Published online: Mar 1, 2009
Published in print: Mar 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.