Factors Study in Low-Temperature Fracture Resistance of Asphalt Concrete
Publication: Journal of Materials in Civil Engineering
Volume 22, Issue 2
Abstract
An investigation of various factors that can affect the fracture resistance of asphalt mixtures at low temperatures was conducted. The fracture resistance of 28 asphalt mixtures—which represent a combination of factors including binder type, binder modifier, aggregate type, asphalt content, and air voids—was evaluated by performing semi-circular bending fracture tests at three low temperatures. Two parameters, fracture energy and fracture toughness, were calculated from the experimental data. The statistical analysis indicated that fracture resistance is strongly dependent on temperature and significantly affected by the type of aggregate and air void content. The results of the analysis also confirmed the significance of binder grade and modifier type with relation to cracking resistance of asphalt mixtures. Asphalt content was also found to be significant for fracture energy but not a significant factor affecting fracture toughness.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research is sponsored by the Federal Highway Administration National Pooled Fund Study 776. This support is gratefully acknowledged. The results and opinions presented are those of the writers and do not necessarily reflect those of the sponsoring agencies.
References
Artamendi, I., and Khalid, H. A. (2006). “A comparison between beam and semi-circular bending fracture tests for asphalt.” Int. J. Road Materials and Pavement Design, 7, 63–180.
Asphalt Institute. (1996). SP-2 superpave mix design, Lexington, Ky.
Birgisson, B., Roque, R., and Page, G. C. (2004). “Performance-based fracture criterion for evaluation of moisture susceptibility in hot-mix asphalt.” Transportation Research Record. 1891, Transportation Research Board, Washington, D.C., 55–61.
Dongre, R., Sharma, M. G., and Anderson, D. A. (1989). “Development of fracture criterion for asphalt mixes at low temperatures.” Transportation Research Record. 1228, Transportation Research Board, Washington, D.C., 94–105.
Huang, B., Zhang, Z., Kingery, W., and Zuo, G. (2004). “Fatigue crack characteristics of HMA mixtures containing RAP.” Proc., 5th Int. Conf. on Cracking in Pavements, RILEM, Cachon, Cedex, France, 631–638.
Ioannides, A. M. (1997). “Fracture mechanics in pavement engineering—The specimen-size effect.” Transportation Research Record. 1568, Transportation Research Board, Washington, D.C., 10–16.
Jackson, N. M., and Vinson, T. S. (1996). “Analysis of thermal fatigue distress of asphalt concrete pavements.” Transportation Research Record. 1545, Transportation Research Board, Washington, D.C., 43–49.
Jacobs, M. M. J., Hopman, P. C., and Molenaar, A. A. A. (1996). “Application of fracture mechanics principles to analyze cracking in asphalt concrete.” Electron. J. Assoc. Asph. Paving Technol., 65, 1–28.
Jung, D., and Vinson, T. S. (1993). “Low temperature cracking resistance of asphalt concrete mixtures.” Electron. J. Assoc. Asph. Paving Technol., 62, 54–92.
Kim, K. W., and Hussein, H. M. (2005). “Effect of differential thermal contraction on fracture toughness of asphalt materials at low temperatures.” Electron. J. Assoc. Asph. Paving Technol., 64, 474–499.
Lee, K. W., Soupharath, N., Shukla, A., Fraanco, C. A., and Manning, F. J. (1999). “Rheological and mechanical properties of blended asphalts containing recycled asphalt pavement binders.” Electron. J. Assoc. Asph. Paving Technol., 68, 89–128.
Li, X., and Marasteanu, M. O. (2004). “Evaluation of the low temperature fracture resistance of asphalt mixtures using the semi circular bend test.” Electron. J. Assoc. Asph. Paving Technol., 73, 401–426.
Li, X. -J., and Marasteanu, M. O. (2006). “Investigation of low temperature cracking in asphalt mixtures by acoustic emission.” Int. J. Road Materials and Pavement Design, 7(4), 491–512.
Lim, I. L., Johnston, I. W., Choi, S. K., and Boland, J. N. (1994). “Fracture testing of a soft rock with semi-circular specimens under three point bending. Part 1—Mode I.” Int. J. Rock Mech. Min. Sci. Geomech. Abstr., 31, 199–212.
Marasteanu, M. O., Dai, S. -T., Labuz, J. F., and Li, X. (2002). “Determining the low-temperature fracture toughness of asphalt mixtures.” Transportation Research Record. 1789, Transportation Research Board, Washington, D.C., 191–199.
Moavenzadeh, F. (1967). “Asphalt fracture.” Electron. J. Assoc. Asph. Paving Technol., 36, 51–79.
Mobasher, B., Mamlouk, M., and Lin, H. (1997). “Evaluation of crack propagation properties of asphalt mixtures.” J. Transp. Eng., 123(5), 405–413.
Molenaar, A. A. A., Scarpas, A., Liu, X., and Erkens, S. M. J. G. (2002). “Semi-circular bending test: Simple but useful?” Electron. J. Assoc. Asph. Paving Technol., 71, 795–815.
RILEM Technical Committee 50-FMC. (1985). “Determination of the fracture energy of mortar and concrete by means of three-point bend tests on notched beams.” Mater. Struct., 18(106), 285–290.
Sulaiman, S. J., and Stock, A. F. (1995). “The use of fracture mechanics for the evaluation of asphalt mixes.” Electron. J. Assoc. Asph. Paving Technol., 64, 500–533.
Wagoner, M. P., Buttlar, W. G., and Paulino, G. H. (2005a). “Investigation of the fracture resistance of hot-mix asphalt concrete using a disk-shaped compact tension test.” Transportation Research Record. 1929, Transportation Research Board, Washington, D.C., 183–192.
Wagoner, M. P., Buttlar, W. G., and Paulino, G. H. (2005b). “Development of a single-edge notched beam test for asphalt concrete mixtures.” J. Test. Eval., 33(6), 452–460.
Wagoner, M. P., Buttlar, W. G., and Paulino, G. H. (2005c). “Disk-shaped compact tension test for asphalt concrete fracture.” Soc. Experimental Mechanics, 45(3), 270–277.
Wu, Z., Mohammad, L. N., Wang, L. B., and Mull, M. (2005). “Fracture resistance characterization of superpave mixtures using a semi-circular.” J. ASTM Int., 2(3), 1–15.
Zhang, Z., Roque, R., Birgisson, B., and Sangpetngam, B. (2001). “Identification and verification of a suitable crack growth law.” Electron. J. Assoc. Asph. Paving Technol., 70, 206–241.
Zubeck, H. K., and Vinson, T. S. (1996). “Prediction of low-temperature cracking of asphalt concrete mixtures with thermal stress restrained specimen test results.” Transportation Research Record. 1545, Transportation Research Board, Washington, D.C., 50–58.
Zubeck, H. K., Zeng, H. -Y., Vinson, T. S., and Janoo, V. C. (1996). “Field validation of thermal stress restrained specimen test: Six case histories.” Transportation Research Record. 1545, Transportation Research Board, Washington, D.C., 67–74.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Feb 12, 2007
Accepted: Oct 5, 2009
Published online: Jan 15, 2010
Published in print: Feb 2010
Notes
Note. Associate Editor: Shin-Che Huang
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.