Experimental Studies on Concrete Filled Steel Tubes under High Strain Rate Loading
Publication: Journal of Materials in Civil Engineering
Volume 21, Issue 10
Abstract
A split Hopkinson pressure bar equipment was used to perform high strain rate compressive tests on concrete filled steel tubes (CFT) along with benchmark plain concrete cylinders for comparison. This paper reports the results of dynamic compressive strength, ultimate strain, residual strength and the secant stiffness. The dynamic increase factor (DIF) of CFT strength upon the increase of strain rate was obtained based on the logarithm linear fitting of the test results. The DIF of the CFT specimens can be relatively well estimated with conservatism using the simple superposition of dynamic uniaxial strength of concrete and steel. The confinement stress and the confinement coefficient under high strain rate loading are also discussed based on assumptions similar to those used for the static loading cases.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research described in this paper was sponsored by the Center for Integrated Protection Research of Engineering Structures (CIPRES) of the Hunan University, under the Program for Changjiang Scholars and Innovative Research Team Project (Grant No. UNSPECIFIEDIRT0619), funded by the Ministry of Education of China, and the National Natural Science Foundation of China (Grant No. NNSFC50678065). The first writer also thanks the partial support of a travel fund provided by the National Science Foundation U.S.-China Exchange Program managed by MCEER.
References
AISC. (2005). “Specification for structural steel buildings.” Chicago.
Bischoff, P. H. and Perry, S. H. (1991). “Compressive behavior of concrete at high strain rates.” Mater. Struct., 24(6), 425–450.
CEB. (1988). “Concrete structures under impact and impulsive loading.” Bulletin d’Information, Synthesis Rep. No. 187, Beijing.
Chen, Z. Y., Luo, J. Q., and Pan, X. W. (1986). The performance of reinforced concrete structures subjected impact load, Qinghua University Press, Beijing (in Chinese).
Comite Europeen de Normalisation (CEN). (2003). “Design of composite steel and concrete structures, prEN 1994–1-1.” Eurocode 4, Brussels, Belgium.
Malvar, L. J. (1998). “Review of static and dynamic properties of steel reinforcing bars.” ACI Mater. J., 95(5), 609–616.
Prichard, S. J. and Perry, S. H. (2000). “The impact behaviour of sleeved concrete cylinders.” Struct. Eng., 78(17), 23–27.
Richart, F. E., Brantzaeg, A., and Brown, R. L. (1929). “The failure of plain and spirally reinforced concrete in compression.” Rep. No. 185, Engrg, Experiment Station, Univ. of Illinois, Urbana, Ill.
Ross, C. A., Tedesco, J. W., and Kuennen, S. T. (1995). “Effects of strain rate on concrete strength.” ACI Mater. J., 92(1), 37–47.
Ross, C. A., Thompson, P. Y., and Tedesco, J. W. (1989). “Split-Hopkinson pressure-bar tests on concrete and mortar in tension and compression.” ACI Mater. J., 86(5), 475–481.
Shan, J. H., Chen, R., Zhang, W. X., Xiao, Y., and Lu, F. Y. (2007). “Behavior of concrete filled tubes and confined concrete filled tubes under high speed impact.” Int. J. of Advances in Structural Engineering, 10(2), 209–218.
Tomii, M., and Xiao, Y. (1990). “Studies on constitutive law of confined concrete causing strain hardening and slip.” Trans. Jpn. Concr. Inst., 12, 159–166.
Tomii, M., Yoshimura, K., and Morishita, Y. (1977). “Experimental studies on concrete filled steel tubular stub columns under concentric loading.” Proc., of the Int. Colloqium on Stability of Structures under Static and Dynamic Loads, ASCE, New York, 718–741.
Viest, I. M., Colaco, J. P., Furlong, R. W., Griffis, L. G., Leon, R. T., and Wyllie, L. A., Jr., eds. (1997). Composite construction design for buildings, McGraw-Hill, New York.
Xiao, Y., and Mahin, S. (2000). “Composite and hybrid structures.” Proc., 6th ASCCS Int. Conf., Univ. of Southern California, Los Angeles.
Xiao, Y., Tomii, M., and Sakino, K. (1991). “Triaxial compressive behavior of confined concrete.” Journal of Concrete Research and Technology, Japan Concrete Institute, 2(1), 1–14 (in Japanese).
Xiao, Y., Zhang, W. X., Shan, J. H., Chen, R., Yi, W. J., and Lu, F. Y. (2005). “Impact tests of concrete filled tubes and confined concrete steel tubes.” Proc., 6th Asia-Pacific Conf. on Shock and Impact loads on Structures, Perth, Australia, 657–664.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Oct 16, 2007
Accepted: Mar 11, 2009
Published online: Sep 15, 2009
Published in print: Oct 2009
Notes
Note. Associate Editor: Kiang Hwee Tan
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.