Optimization of Nonlinear Ultrasound Results to Determine Dynamic Properties of Concrete
Publication: Journal of Materials in Civil Engineering
Volume 20, Issue 11
Abstract
This paper presents the development of a new algorithm to identify dynamic properties of concrete by comparing simulated and experimental results of nonlinear ultrasound testing. Prismatic concrete specimens with different water-cement (w/c) ratios, 0.45, 0.60, and 0.75, were prepared. The specimens were damaged progressively by loading them in compression up to 20, 40, 60, and 80% of the ultimate strength. After each load step, the load was released, and the specimens were tested for the fundamental, second-, and third-harmonic frequencies. An algorithm was developed to determine the dynamic properties of the specimen through the progression of damage. The proposed algorithm used ABAQUS to simulate the dynamic response of the specimens. A MATLAB program was used to update the material properties by minimizing the sum of squared differences between the measured and simulated harmonic frequencies. Excellent agreement was obtained between the reconstructed elastic modulus values and values obtained by testing the prisms according to ASTM C 215. Damping ratios provided by the reconstruction were observed to increase with increasing damage and with increasing w/c ratio.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers would like to thank Matt Cramer for his help with the experimental work and Zhenghua Cheng for his help in the design of the MATLAB program.
References
ABAQUS, Inc. (2004). ABAQUS user’s manual, theory manual, and example manual, version 6.5.
ASTM. (2001a). Standard test method for fundamental transverse, longitudinal, and torsional frequencies of concrete specimen, C 215–01, Vol. 04.02, West Conshohocken, Pa.
ASTM. (2001b). Standard test method for pulse velocity through concrete, C 597–01, Vol. 04.02, West Conshohocken, Pa.
Cole, D. G., and Spooner, D. C. (1965). “The damping capacity of concrete.” Proc., Int. Conf. on the Structures of Concrete, Cement and Concrete Association, London, 217–225.
Delores, M. E. (1997). Engineering problem solving with MATLAB, 2nd Ed., Prentice-Hall, Upper Saddle River, N.J.
Jeary, A. P. (1997). “Damping in structures.” Int. J. Energy Res., 72, 345–355.
Lagarias, J. C., Reeds, J. A., Wright, M. H., and Wright, P. E. (1998). “Convergence properties of the Nelder-Mead simplex method in low dimensions.” SIAM J. Optim., 9(1), 112–147.
Mathworks. (2006). “MATLAB function reference: fminsearch.” The Math Works, Inc., ⟨http://www.mathworks.com/access/helpdesk/help/techdoc/ref/fminsearch.html⟩ (Feb. 24, 2006).
Mindess, S., Young, J. F., and Darwin, D. (2003). Concrete, 2nd Ed., Pearson Education, Upper Saddle River, N.J.
Modena, C., Sonda, D., and Zonta, D. (1999). “Damage localization in reinforced concrete structures by using damping measurements.” Key Eng. Mater., 167–168, 132–141.
Moser, F., Jacobs, L. J., and Qu, J. (1999). “Modeling elastic wave propagation in waveguides with the finite element method.” NDT & E Int., 32(4), 225–234.
Newtson, C. M., and Eberhard, M. O. (2000). “Nondestructive evaluation using numerical simulation of impact response.” ACI Mater. J., 97(3), 343–350.
Radakovic, Z. (1997). “Ultrasonic assessment of damage in concrete under axial loads.” Ph.D. dissertation, Univ. of Colorado at Boulder, Boulder, Colo.
Stauffer, J. D. (2004). “Nonlinear ultrasonic nondestructive test method for the detection of early damage in concrete.” Master’s thesis, New Mexico State Univ., has Cruces, N.M.
Stauffer, J. D., Woodward, C. B., and White, K. R. (2005). “Nonlinear ultrasonic testing with resonant and pulse velocity parameters for early damage in concrete.” ACI Mater. J., 102(2), 118–121.
Van Den Abeele, K., Johnson, P. A., and Sutin, A. M. (2000). “Nonlinear elastic wave spectroscopy (NEWS) techniques to discern material damage. Part I: Nonlinear wave modulation spectroscopy (NWMS).” Res. Nondestruct. Eval., 12(1), 17–30.
Zheng, Y., Maev, R. G., and Solodov, I. Y. (1999). “Nonlinear acoustic applications for material characterization: a review.” Can. J. Phys., 77, 927–967.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Feb 9, 2007
Accepted: Mar 10, 2008
Published online: Nov 1, 2008
Published in print: Nov 2008
Notes
Note. Associate Editor: John S. Popovics
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.