Correlation of Resilient and Seismic Modulus Test Results
Publication: Journal of Materials in Civil Engineering
Volume 19, Issue 12
Abstract
The most common test to evaluate the representative modulus and nonlinear behavior of base and subgrade materials is the resilient modulus test. Due to the comprehensive nature of the method, the preparation and testing of one specimen may take up to . For field quality control, a more rapid method of determining the in-place modulus is desirable. One way to achieve this goal is through in situ seismic methods. However, since the seismic tests provide small-strain moduli whereas the resilient modulus tests measure moduli at higher strains, some additional considerations must be taken into account to relate these two moduli. This paper presents some possibilities for relating these tests in a rational manner.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was funded by the Texas Department of Transportation. The support of Mark McDaniel and Mike Arellano of that organization is greatly appreciated.
References
Anderson, D. G. (1974). “Dynamic modulus of cohesive soils.” Ph.D. dissertation, Univ. of Michigan, Ann Arbor, Mich.
Barksdale, R. D., Alba, J., Khosla, P. N., Kim, R., Lambe, P. C., and Rahman, M. S. (1997). “Laboratory determination of resilient modulus for flexible pavement design.” NCHRP Web Document 14, Federal Highway Administration, Washington, D.C.
Boudreau, R. L. (2003). “Repeatability of resilient modulus test procedure.” ASTM STP 1437, ASTM, West Conshohocken, Pa., 30–40.
Daleiden, J. F., Killingsworth, B. M., Simpson, A. L., and Zamora, R. A. (1994). “Analysis of procedures for establishing in situ subgrade moduli.” Transportation Research Record. 1462, Transportation Research Board, Washington, D.C., 102–107.
Horhota, D. J. (1996). “Evaluation of SASW test method for Florida Department of Transportation applications.” Ph.D. thesis, Univ. of Florida, Gainesville, Fla.
Ishibashi, I., and Zhang, X. (1993). “Unified dynamic shear moduli and damping ratios of sand and clay.” Soils Found., 33(1), 182–191.
Kramer, S. L. (1996). Geotechnical earthquake engineering, Prentice-Hall, Upper Saddle River, N.J.
Nazarian, S., Yuan, D., and Arellano, M. (2002). “Quality management of base and subgrade materials with seismic methods.” Transportation Research Record. 1786, Transportation Research Board, Washington, D.C., 3–10.
Nazarian, S., Yuan, D., and Tandon, V. (1999). “Structural field testing of flexible pavement layers with seismic methods for quality control.” Transportation Research Record. 1654, Transportation Research Board, Washington, D.C., 50–60.
Nazarian, S., Yuan, D., and Williams, R. R. (2003). “A simple method for determining modulus of base and subgrade materials.” ASTM STP 1437, ASTM, West Conshohocken, Pa., 152–164.
Ramberg, W., and Osgood, W. R. (1943). “Description of stress-strain curves by the three parameters.” Technical Note No. 902, National Advisory Committee for Aeronautics, Washington, D.C.
Richart, F. E., Jr., Woods, R. D., and Hall, Jr., J. R. (1970). Vibrations of soils and foundations, Prentice-Hall, Englewood Cliffs, N.J.
Richter, C. A., and Schwartz, C. W. (2003). “Modeling stress- and moisture-induced variations in pavement layer moduli.” Transportation Research Record. 1860, Transportation Research Board, Washington, D.C., 33–40.
Rodhe, G. T., and Scullion, T. (1990). “MODULUS 4.0: Expansion and validation of the MODULUS backcalculation system.” Research Rep. No. 1123-3, Texas Transportation Institute, Texas A&M Univ., College Station, Tex.
Von Quintus, H., and Killingsworth, B. (1998). “Analysis relating to pavement material characterizations and their effects on pavement performance.” Rep. No. FHWA-RD-97-085, Federal Highway Administration, Washington, D.C.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Jun 6, 2006
Accepted: Oct 4, 2006
Published online: Dec 1, 2007
Published in print: Dec 2007
Notes
Note. Associate Editor: Manoochehr Zoghi
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.