Viscoelastoplastic Continuum Damage Model Application to Thermal Cracking of Asphalt Concrete
Publication: Journal of Materials in Civil Engineering
Volume 17, Issue 4
Abstract
A viscoelastoplastic continuum damage (VEPCD) model has recently been developed and validated under the auspices of the National Cooperative Highway Research Program 9-19 project, entitled “Advanced Mixture Characterization for Superpave Support and Performance Models Management.” The VEPCD model is able to characterize the viscoelastic and viscoplastic responses of asphalt concrete (AC) in addition to microcracking. The primary objective of this paper is to validate the model under thermal loading conditions that are distinctively different from the mechanical loading conditions used in model development and calibration. Viscoplastic (VP) behavior is a typical response in AC at high temperatures; however, based on the superposition principle, it is the slow strain rate observed in thermal cracking that triggers the VP response. Measured responses and fracture parameters from thermal strain restrained specimen tensile (TSRST) strength tests were compared with those predicted using the VEPCD model, the viscoelastic continuum damage model, and the linear viscoelastic model. The comparison confirmed: (1) the ability of the VEPCD model to accurately characterize the tensile behavior of asphalt concrete under thermally induced loading; and (2) a decrease in accuracy as the complexity of the model decreases.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This material is based upon work supported by the National Science Foundation (NSF) under Grant No. 9812741 and the NCHRP 9-19 project. Any opinions, findings, and conclusions or recommendations expressed in this material are those of the writers and do not necessarily reflect the views of the NSF. The project is sponsored by the AASHTO, in cooperation with the FHWA, and was conducted under the NCHRP, which is administered by the Transportation Research Board of the National Research Council. The writers gratefully acknowledge this support.
References
Bahia, H., Zeng, M., and Nam, K. (2000). “Consideration of strain at failure and strength in prediction of pavement thermal cracking.” J. Asphalt Paving Technology, 69, 497-539.
Chehab, G. R., Kim, Y. R., Schapery, R. A., Witczack, M., and Bonaquist, R. (2002). “Time-temperature superposition principle for asphalt concrete mixtures with growing damage in tension state.” J. Asphalt Paving Technology, 71, 559-593.
Chehab, G. R., Kim, Y. R., Schapery, R. A., Witczack, M., and Bonaquist, R. (2003). “Characterization of asphalt concrete in uniaxial tension using a viscoelastoplastic model.” J. Asphalt Paving Technology, 72, 315-355.
Daniel, J. S., and Kim, Y. R. (2002). “Development of a simplified fatigue test and analysis procedure using a viscoelastic continuum damage model.” J. Asphalt Paving Technology, 71, 619-650.
Fabb, T. R. J. (1974). “The influence of mix composition, binder properties, and cooling rate on AC at low temperature.” Proc., AAPT Conf., Association of Asphalt Paving Technologists, St. Paul, Minn., 43, 285-331.
Fwa, T. F., Low, B. F., and Tan, S. A. (1995). “Laboratory determination of the thermal properties of asphalt mixtures by transient heat conduction method.” Transportation Research Record. 1492, Transportation Research Board, Washington, D.C.
Jung, D. H., and Vinson, T. S. (1994). “Prediction of low temperature cracking: Test selection.” Rep. SHRP-A-400, Strategic Highway Research Program, Washington, D.C.
Kim, Y. R., Lee, H. J., and Little, D. N. (1997). “Fatigue characterization of asphalt concrete using viscoelasticity and continuum damage theory.” J. Asphalt Paving Technology, 66, 520-569.
Park, S. W., Kim Y. R., and Schapery, R. A. (1996). “A viscoelastic continuum damage model and its application to uniaxial behavior of asphalt concrete.” Mech. Mater., 24(4), 241-255.
Schapery, R. A. (1981). “On viscoelastic deformation and failure behavior of composite materials with distributed flaws.” Advances in aerospace structures and materials, American Society of Mechanical Engineers, New York, 5-20.
Schapery, R. A. (1999). “Nonlinear viscoelastic and viscoplastic constitutive equations with growing damage.” Int. J. Fracture, 97, 33-66.
Schapery, R. A., and Park, S. A. (1999). “Methods of interconversion between linear viscoelastic material functions. Part II: An approximate analytical method.” Int. J. Solids Struct., 36, 1677-1699.
Strategic Highway Research Program (SHRP). (1993). “Development and validation of performance prediction models and specifications for asphalt binders and paving mixes.” Rep. SHRP-A-357, Washington, D.C.
Superpave Models Team. (2002a). NCHRP 9-19 task F—advanced material characterization models subtask F6—evaluation tests—TSRST, Dept. of Civil Engineering, Arizona State Univ., Tucson, Ariz.
Superpave Models Team. (2002b). NCHRP 9-19 task F—advanced material characterization models subtask F6—thermal coefficient tests, Dept. of Civil Engineering, Arizona State Univ., Tucson, Ariz.
Uzan, J. (1996). “Asphalt concrete characterization for pavement performance prediction.” J. Asphalt Paving Technology, 65, 573-607.
Zubeck, H. K., and Vinson, T. S. (1996). “Prediction of low-temperature cracking of asphalt concrete mixtures with TSRST results.” Transportation Research Record. 1545, Transportation Research Board, Washington, D.C.
Information & Authors
Information
Published In
Copyright
© 2005 ASCE.
History
Received: Dec 8, 2003
Accepted: May 4, 2004
Published online: Aug 1, 2005
Published in print: Aug 2005
Notes
Note. Associate Editor: Mary Stroup-Gardiner
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.