Application of a Temperature Dependent Viscoplastic Hierarchical Single Surface Model for Asphalt Mixtures
Publication: Journal of Materials in Civil Engineering
Volume 16, Issue 2
Abstract
Asphalt mixtures exhibit both temperature and rate dependencies. Most current constitutive models used in design and prediction of the performance of asphalt pavements do not incorporate both characteristics into their equations. Therefore, they do not effectively reflect the actual pavement responses under traffic loads and environmental conditions. This paper presents a temperature dependent viscoplastic model that incorporated temperature and loading rate into the Hierarchical Single Surface plasticity based model. The model presented in this paper was able to reflect the nonlinear plasticity, as well as the temperature and loading rate dependencies of the asphalt mixtures. Triaxial compression, triaxial extension, and axial creep tests at three temperatures (28, 40 and 60°C) were performed to calibrate the material properties. A comparison of numerical analysis obtained from the proposed model and experimental results was conducted based on the algorithm proposed by the writers. A reasonable agreement was observed from the back calculation and the experimental results. Further studies of the applicability of this model in predicting pavement performance were recommended.
Get full access to this article
View all available purchase options and get full access to this article.
References
Ahlborn, G. (1972). “ELSYM5, computer program for determining stresses and deformations in five layer elastic system.” Univ. of California, Berkeley, Calif.
Barksdale, R. D. (1967). “Predicting performance of bituminous surfaced pavements.” Proc., 2nd Int. Conf. on the Structural Design of Asphalt Pavement, Univ. of Michigan, Ann Arbor, Mich., 321–340.
Bosscher, P. J., Bahia, H., Thomas, S., and Russell, J. S. (1998). “Relationship between pavement temperature and weather data.” Transportation Research Record 1609, Transportation Research Board, Washington, D.C.
Burmister, D. M.(1945). “The general theory of stress and displacements in layered systems.” J. Appl. Phys., 15, 126–127, 296–302.
Chia, J. H. (1994). “Constitutive modeling of thermomechanical response of materials in semiconductor devices with emphasis on interface behavior.” PhD dissertation, Univ. of Arizona, Tucson, Az.
de Jong, D. L., Peutz, M. G. F., and Korswagen, A. R. (1973). “Computer program BISAR, layered systems under normal and tangential surface loads.” External Rep. No. AMSR.0006.73, Koninkijke/Shell Laboratorium, Amsterdam, The Netherlands.
Desai, C. S.(1980). “A general basis for yield, failure and potential functions in plasticity.” Int. J. Numer. Analyt. Meth. Geomech., 4, 361–375.
Desai, C. S., Somasundaram, S., and Frantziskonis, G.(1986). “A hierarchical approach for constitutive modeling of geologic materials.” Int. J. Numer. Analyt. Meth. Geomech., 10, 225–257.
Desai, C. S., and Wathugala, G. W. (1987). “Hierarchical and unified models for solids and discontinuities (joints/interfaces).” Short Course Notes, Workshop on Implementation of Constitutive Laws for Engineering Materials, Univ. of Arizona, Tucson, Ariz., 31–124.
Desai, C. S., and Zhang, D.(1987). “Viscoplastic model for geologic materials with generalized flow rule.” Int. J. Numer. Analyt. Meth. Geomech., 11, 603–620.
Frantziskonis, G., and Desai, C. S.(1987). “Constitutive model with strain softening.” Int. J. Solids Struct., 23(6), 733–750.
Harichandran, R. S., Baladi, G. Y., and Yeh, M. (1989). “Development of a computer program for design of pavement systems consisting of bound and unbound materials.” Michigan State Univ., East Lansing, Mich.
Huang, B., Mohammad, L. N., and Wathugala, G. W.(2002). “Development of a thermo–viscoplastic constitutive model for HMA mixtures.” J. Assoc. Asphalt Paving Technol., 71, 594–618.
Huang, Y. H. (1967). “Stresses and displacements in viscoelastic layered system under circular loaded areas.” Proc., 2nd Int. Conf. on the Structural Design of Asphalt Pavement, Univ. of Michigan, Ann Arbor, Mich., 225–244.
Kenis, W. J. (1978). “Predictive design procedure.” VESYS users manual—An interim design for flexible pavements using VESYS structural subsystem, FHWA-RD-77-154, Federal Highway Administration, U.S. Department of Transportation.
Lytton, R., et al. (1993). “Development and validation of performance prediction models and specifications for asphalt binders and paving mixes.” SHRP-A-357, Strategic Highway Research Program, National Research Council, Washington, D.C.
Perzyna, P.(1966). “Fundamental problems in viscoplasticity.” Int. J. Constr. Inf. Technol., 9, 243–377.
Samtani, N. C. (1991). “Constitutive modeling and finite element analysis of slowly moving landslides using hierarchical viscoplastic material model.” PhD dissertation, Univ. of Arizona, Tuscon, Ariz.
Seibi, A. C. (1993). “Development of constitutive relations for asphalt concrete under high rates of loading.” PhD dissertation, The Pennsylvania State Univ., University Park, Pa.
Sousa, J., et al. (1993). “Permanent deformation response of asphalt aggregate mixes.” SHRP-A-415, Strategic Highway Research Program, National Research Council, Washington, D.C.
Tashman, L., Masad, E., Peterson, B., and Saleh, H.(2001). “Internal structure analysis of asphalt mixes to improve the simulation of superpave gyratory compaction to field conditions.” J. Assoc. Asphalt Paving Technol., 70, 605–645.
Wathugala, G. W. (1990). “Finite element dynamic analysis of nonlinear porous media with applications to piles in saturated clays.” PhD dissertation, Univ. of Arizona, Tuscan, Ariz., 187, 194.
Wathugala, G. W., and Desai, C. S. (1994). “Stress to strain algorithm for HiSS models.” Computer Methods and Advances in Geomechanics, Proc., 8th Int. Conf. on Computer Methods and Advances in Geomechanics, H. J. Wiriwardane and M. M. Zaman, eds., Balkema, Rotterdam, The Netherlands, 725–729.
Weismann, S. L., and Sousa, J. B.(1994). “Modeling permanent deformation of asphalt–aggregate mixes.” J. Assoc. Asphalt Paving Technol., 63, 224.
Witczak, M., Bonaquist, R., Von Quintus, H., and Kaloush, K.(2000). “Specimen geometry and aggregate size effects in uniaxial compression and constant height shear tests.” J. Assoc. Asphalt Paving Technol., 69, 733–793.
Wong, W. G., and Zhong, Y.(2000). “Flexible pavement thermal stresses with variable temperature.” J. Transp. Eng., 126(1), 46–49.
Zuo, G. (2003). “Impacts of environmental factors on flexible pavements.” PhD dissertation, The Univ. of Tennessee, Knoxville, Tenn., 16–19.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: Jun 17, 2002
Accepted: Nov 18, 2003
Published online: Mar 15, 2004
Published in print: Apr 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.