Compressive Behavior of Concrete Confined by Carbon Fiber Composite Jackets
Publication: Journal of Materials in Civil Engineering
Volume 12, Issue 2
Abstract
This paper describes axial compression test results of 27 concrete cylinders confined by carbon fiber reinforced polymer composite jackets. The experimental parameters include plain concrete compressive strength and the thickness of the composite jacket. It is found that the carbon fiber composite jacketing can significantly increase the compressive strength and ductility of concrete. The test results indicate that concrete strength and confinement modulus, defined as the ratio of transverse confinement stress and transverse strain, are the most influential factors affecting the stress-strain behavior of confined concrete. The failure of the confined concrete was dominated by the rupture of the jacket at an average strain much smaller than the ultimate strain obtained from tension tests of flat coupons. In order to describe the main mechanical features of the confined concrete, a simple bilinear stress-strain model is suggested based on the theory of elasticity and minimum number of empirical equations determined from the tests. The simple model is shown to compare well with test results from previous studies by other researchers.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bazant, Z. P., Bishop, F. C., and Chang, T. P. (1986). “Confined compression tests of cement paste and concrete up to 300 ksi.” ACI J., 83(July-August), 553–560.
2.
Hosotani, M., Kawashima, K., and Hoshikuma, J. (1996). “Seismic retrofit of reinforced concrete bridge piers by carbon fiber sheets.” Proc., 3rd U.S.-Japan Workshop on Seismic Retrofit of Bridges, Tech. Memo. of PWRI, No. 3481, Public Works Res. Inst., Ministry of Construction, Tsukuba Science City, Japan.
3.
Karbhari, V. M., and Gao, Y. (1997). “Composite jacketed concrete under uniaxial compression—verification of simple design equations.”J. Mat. in Civ. Engrg., ASCE, 9(4), 185–193.
4.
Matsuda, T., Sato, H., Fujiwara, H., and Higashira, N. (1990). “Effect of carbon fiber reinforcement as a strengthening measure for reinforced concrete bridge piers.” Proc., 1st U.S.-Japan Workshop on Seismic Retrofit of Bridges, Public Works Res. Inst., Ministry of Construction, Tsukuba Science City, Japan.
5.
Mirmiran, A., and Shahawy, M. (1997). “Behavior of concrete columns confined by fiber composites.”J. Struct. Engrg., ASCE, 123(5), 583–590.
6.
Picher, F., Rochette, P., and Labossiere, P. (1996). “Confinement of concrete cylinders with CFRP.” Proc., 1st Int. Conf. on Compos. in Infrastructure, H. Saadatmanesh and M. R. Ehsani, eds., University of Arizona, Tucson, Ariz., 829–841.
7.
Priestley, M. J. N., and Seible, F. (1991). “Seismic assessment and retrofit of bridges.” Struct. Sys. Res. Proj., Rep. No. SSRP-91/03, M. J. N. Priestley and F. Seible, eds., University of California at San Diego, San Diego, Calif.
8.
Richart, F. E., Brantzaeg, A., and Brown, R. L. ( 1929). “The failure of plain and spirally reinforced concrete in compression.” Bull. No. 185, Engrg. Experiment Station, University of Illinois, Urbana, Ill.
9.
Saadatmanesh, H., Ehsani, M. R., and Li, M. W. (1994). “Strength and ductility of concrete columns externally reinforced with fiber composite straps.” ACI Struct. J., 91(4), 434.
10.
Seible, F., and Priestley, M. J. N. (1993). “Retrofit of rectangular flexural columns with composite fiber jackets.” Proc., 2nd Annu. Seismic Res. Workshop, California Department of Transportation, Sacramento, Calif.
11.
Seible, F., Hegemier, G. A., and Innamorato, D. (1995). “Developments in bridge column jacketing using advance composites.” Proc., Nat. Seismic Conf. on Bridges and Highways, Federal Highway Administration and California Department of Transportation, San Diego, Calif.
12.
Standards and literature references for composite materials. (1990). 2nd Ed., ASTM, West Conshohocken, Pa.
13.
Xiao, Y. ( 1989). “Experimental study and analytical modeling of triaxial behavior of confined concrete,” PhD thesis, Kyushu University, Japan.
14.
Xiao, Y., and Ma, R. (1997). “Seismic retrofit of RC circular columns using prefabricated composite jacketing.”J. Struct. Engrg., ASCE, 123(10), 1357–1364.
15.
Xiao, Y., Martin, G. R., Yin, Z., and Ma, R. (1996). “Seismic retrofit of existing reinforced concrete bridge columns using a prefabricated composite jacketing system.” Proc., 1st Int. Conf. on Compos. in Infrastructure, 903–916.
16.
Xiao, Y., Tomii, M., and Sakino, K. (1991). “Triaxial compressive behavior of confined concrete.” Concrete Res. and Technol., Japan, 2(1), 1–14.
Information & Authors
Information
Published In
History
Received: Sep 14, 1998
Published online: May 1, 2000
Published in print: May 2000
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.