Microstructural and Phase Characteristics of Phosphogypsum-Cement Mixtures
Publication: Journal of Materials in Civil Engineering
Volume 8, Issue 1
Abstract
The effects of the tricalcium aluminate (C 3 A) content of the stabilizing cement [Type II (1.3% C 3 A) cement and Type III cement (9.3% C 3 A)], curing time (seven to 90 days), proportion of PG (5–60%), grain size, and impurities in phosphogypsum (PG) (PG compared to gypsum) on the microstructural (by scanning electron microscopy) and phase properties of gypsum/PG and cement mixtures, a potential road-base material, were studied (by derivative thermogravimetry). Morphologically, two types of ettringite (well-defined crystals, >2 μm in lengths and ill-defined crystals, below 1 μm in length) were present in the cement and gypsum/PG mixtures. The impurities in PG retarded the initial hydration of cement in direct proportion to its amount in the mixtures. However, gypsum/PG increased the degree of hydration of cement in the mixtures in the long term. The reacted gypsum/PG produced a large amount of ettringite (within two months) compared to cement only. The amount of carbonation was uniformly low.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bensted, J. (1979). “Early behavior of portland cement containing chemical by-product gypsum.”World Cement Technol., Vol 10, 404–410.
2.
Bensted, J.(1980). “Early behaviour of portland cement containing boro-, citro- and desulphogypsum.”Cement and Concrete Res., 10(2), 165–171.
3.
Bensted, J.(1981). “Early behaviour of portland cement containing tartaro- and titanogypsum.”Cement and Concrete Res., 11(2), 219–226.
4.
Bensted, J. (1983). “Hydration of portland cement.”Advances in cement technology, S. N. Ghosh, ed., Pergamon Press, Inc., Oxford, England, 307–347.
5.
Berry, E. E., Hemmings, R. T., and Cornelius, B. J. (1991). “Commercialization potential of AFBC concrete: Part 2 Volume 2: mechanistic basis for cementing action.”EPRI Rep., Electric Power Res. Inst. (EERI), Palo Alto, Calif.
6.
Chang, W. F., and Mantell, M. I. (1990). Engineering properties and construction applications of phosphogypsum, University of Miami Press, Coral Gables, Fla.
7.
Cohen, M. D.(1983). “Theories of expansion in sulfoaluminate-type expansive cements: schools of thought.”Cement and Concrete Res., 13(6), 809–818.
8.
Cohen, M., and Mather, B. (1991). “Sulfate attack on concrete—research needs.”ACI Mat. J., (Jan.–Feb.), 62–69.
9.
Frigione, G. (1983). “Gypsum in cement.”Advances in cement technology, S. N. Ghosh, ed., Pergamon Press, Inc., Oxford, England, 485–535.
10.
Fukuhara, M., Goto, S., Asaga, K., Daimon, M., and Kondo, R. (1981). “Mechanics and kinetics of C 4 AF hydration with gypsum.”Cement and Concrete Res., 11(3), 407–414.
11.
Gabrisová, J., Havlica, A., and Sahu, S.(1991). “Stability of calcium sulphoaluminate hydrates in water solutions with various pH values.”Cement and Concrete Res., 21(6), 1023–1027.
12.
Jennings, H. M. (1983). “The developing microstructure in portland cement.”Advances in cement technology, S. N. Ghosh, ed., Pergamon Press, Inc., Oxford, England, 349–396.
13.
Kalousek, G. L. (1965). “Analyzing SO 3 -bearing phases in hydrating cements.”Mat. Res. and Standards, (June), 292–304.
14.
Kalvakaalva, R. (1995). “Microstructure and phase characteristics of phosphogypsum and portland cement mixtures,” MS thesis, Louisiana State Univ., Baton Rouge, La.
15.
Lea, F. M. (1971). The chemistry of cement and concrete . Chemical Publishing Co., Inc., New York, N.Y.
16.
May, A., and Sweeney, J. W. (1982). “Assessment of environmental impacts associated with phosphogypsum of Florida.”Rep. of Investigation 8639, Bureau of Mines, U.S. Dept. of Interior, Washington, D.C.
17.
Mehta, P. K.(1976). “Scanning electron micrograph studies of ettringite formation.”Cement and Concrete Res., 5(1), 169–182.
18.
Nishikawa, T., Suzuki, K., and Ito, S.(1992). “Decomposition of synthesized ettringite by carbonation.”Cement and Concrete Res., 22(1), 6–14.
19.
Odler, I., and Abdul-Maula, S.(1984). “Possibilities of quantitative determination of the Aft-(ettringite) and AFm (monosulfate) phases in hydrated cement pastes.”Cement and Concrete Res., 14(1), 133–141.
20.
Odler, I., and Gasser, M.(1988). “Mechanism of sulfate expansion in hydrated portland cement.”J. Am. Ceramic Soc., 71(11), 1109–1120.
21.
Ogawa, K., and Roy, D. M.(1981). “CAS hydration, ettringite formation, and its expansion mechanisms. I: expansion; ettringite stability.”Cement and Concrete Res., 11(5), 741–750.
22.
Ölmez, H., and Erdem, E.(1989). “The effects of phosphogypsum on the setting and mechanical properties of portland and trass cement.”Cement and Concrete Res., 19(3), 377–384.
23.
Ouyang, C., Nanni, A., and Chang, W. F. (1986). “Durability of portland cement mortar containing PG.”Proc., 2nd Int. Symp. on PG, 187–191.
24.
Ouyang, C., Nanni, A., and Chang, W. F.(1988). “Internal and external sources of sulfate ions in portland cement mortar: two types of chemical attack.”Cement and Concrete Res., 18(5), 699–709.
25.
Peakfit. (1991). Jandel Scientific. San Rafael, Calif.
26.
Ramachandran, V. S. (1969). Applications of differential thermal analysis in cement chemistry . Chemical Publishing Co., Inc., New York, N.Y.
27.
Roy, A., Byerly, G. R., and Seals, R. K.(1994). “By-product of sulfur recovery from phosphogypsum as concrete aggregate.”J. Mat. in Civ. Engrg., ASCE, 6(4), 439–452.
28.
Samarai, M. A.(1976). “The disintegration of concrete containing sulphate-contaminated aggregates.”Mag. of Concrete Res., 28(96), 130–142.
29.
Tabikh, A. A., and Miller, F. M.(1971). “The nature of phosphogypsum impurities and their influence on cement hydration.”Cement and Concrete Res., 1(6), 663–678.
30.
Taylor, H. F. W. (1990). Cement chemistry, Academic Press, London, England.
31.
U.S. Environmental Protection Agency. (EPA). (1991). “Final regulatory determination for special wastes from mineral processing (mining waste exclusion).”40 CFR Part 261, Federal Register, Washington, D.C., 27300–27330.
32.
Verbeck, G. J. (1958). “Carbonation of hydrated portland cement.”Spec. Publ., No. 205, ASTM, Philadelphia, Pa., 17–36
Information & Authors
Information
Published In
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Feb 1, 1996
Published in print: Feb 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.