Evaluation of Plastic Damage in Concrete by Acoustic Emission
Publication: Journal of Materials in Civil Engineering
Volume 7, Issue 3
Abstract
This paper presents an experimental observation of the relation between the plastic damage and the acoustic emission (AE) events in concrete subjected to uniaxial compressive loading. To examine the effect of the degree of the initial deterioration on the plastic damage, both undamaged and damaged concrete specimens were tested. In the damaged specimens, the damage was induced using different numbers of freezing-thawing cycles to achieve different initial deterioration before loading. It is found that as the plastic damage increases the activity of AE signals increases. Moreover, it is noticed that the degree of the nonlinearity of plastic damage–AE event relationship depends significantly on the initial deterioration. The current investigation may provide a new procedure for core testing to evaluate concrete deterioration because the conventional strength and Young's modulus are less sensitive to the damage.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Chen, W. F. (1982). Plasticity in reinforced concrete . McGraw-Hill, New York, N.Y.
2.
Farahat, A. M., Kawakami, M., and Ohtsu, M.(1993). “Strain-space plasticity model for triaxial behavior of concrete.”Memoirs of the Fac. of Engrg., Kumamoto Univ., 38(3), 1–24.
3.
Farahat, A. M., Kawakami, M., and Ohtsu, M. (1994). “Strain-space plasticity model for the compressive hardening-softening behavior of concrete.”J. Constr. and Build. Mat., U.K.
4.
Green, A. T. (1970). “Stress wave emission and fracture prestressed concrete reactor vessel materials.”Proc., 2nd Int. Conf. on Mat. Technol.; Vol. 1, Am. Soc. of Mech. Engrg. (ASME), New York, N.Y. 635–649.
5.
Golis, M. J., McMaster, R. C., Toth, L., and Coopert, G. (1966). “The development of ultrasonic nondestructive testing instrumentation to measure pavement thickness.”Rep. No. 208-3, Engrg. Experiment Station, Ohio State Univ., Columbus, Ohio.
6.
Kobayashi, A. S., Hawkins, N. M., Chan, Y. L. A., and Lin, I. J. (1980). “A feasibility study of detecting reinforced-bar debonding by acoustic emission technique.”Experimental Mech., 20(Sept.), 301–309.
7.
L'Hermite, R. G. (1960). “Volume change of concrete.”Proc., 4th Int. Symp. on Chemistry of Cement; Vol. 3; NBS Monograph No. 43, NBS, Washington, D.C., 659–694.
8.
McCable, W. M., Koerner, R. B., and Lord, J. A. E. (1976). “Acoustic emission behavior of concrete laboratory specimens.”J. Am. Concrete Inst., 73(Jul.), 367–371.
9.
Mizuno, E., and Hatanaka, S.(1992). “Compressive softening model for concrete.”J. Engrg. Mech., ASCE, 118(8), 1546–1563.
10.
Niwa, Y., Kobayashi, S., and Ohtsu, M. (1977). “Studies of acoustic emisson of concrete structures.”Proc., Japan Soc. of Civ. Engrs., Tokyo, Japan, (261), 101–112 (in Japanese).
11.
Niwa, Y., Kobayashi, S., and Ohtsu, M. (1978). “Studies of source location by acoustic emission.”Proc., Japan Soc. of Civ. Engrs., Tokyo, Japan, (276), 135–147 (in Japanese).
12.
Niwa, Y., Kobayashi, S., and Ohtsu, M. (1980). “Frequency analysis of acoustic emission.”Proc., 23rd Conf. of Japan Congress in Mat. Res., Japan Soc. of Mat. Sci. (JSMS), Kyoto, Japan, 347–351.
13.
Niwa, Y., Kobayashi, S., and Ohtsu, M. (1981). “Source mechanisms of acoustic emission.”Proc., Japan Soc. of Civ. Engrs., Tokyo, Japan, (314), 127–136 (in Japanese).
14.
Ohtsu, M.(1982a). “Source mechanism and waveform analysis of acoustic emission in concrete.”J. Acoustic Emission, 1(2), 103–112.
15.
Ohtsu, M. (1982b). “Acoustic emission characteristics in concrete and fundamental mechanisms,” PhD thesis, Kyoto Univ., Kyoto, Japan.
16.
Ohtsu, M. (1985). “Radiation pattern of acoustic emission.”DRIC-T-7599, Defense Res. Information Ctr., London, England.
17.
Ohtsu, M., and Ono, K.(1984). “A generalized theory of acoustic emission and Green's function in a half space.”J. Acoustic Emission, 3(1), 27–40.
18.
Ohtsu, M., and Fukunaga, Y. (1986). “Investigation on crack propagation and K I values in concrete members.”Memoirs of the Fac. of Engrg., Kumamoto Univ., 31(1), 1–13.
19.
Ohtsu, M., and Ono, K. (1986). “Crack orientations and moment tensor solutions in acoustic emission.”Progress in acoustic emission III, K. Yamaguchi et al., eds., Japan Soc. for Non-Destructive Inspection (JSNDI), Tokyo, Japan, 771–778.
20.
Ohtsu, M.(1987). “Acoustic emission characteristics in concrete and diagnostic applications.”J. Acoustic Emission, 6(2), 99–107.
21.
Robinson, G. S. (1965). “Methods of detecting the formation and propagation of microcracks in concrete.”Proc., Int. Conf. on the Struct. of Concrete and Its Behavior Under Load, Cement and Concrete Assoc., London, England, 131–145.
22.
Rusch, H.(1959). “Physical problems in the testing of concrete.”Zement-Kalk-Gips, 12(1), 1–9.
23.
Tanabe, T., and Wu, Z. (1992). “An application of work hardening and strain softening plasticity to uniformly cracked reinforced concrete elements.”Proc., 3rd Int. Conf. on Computational Plasticity, Fundamental and Application, Pineridge Press, Swansea, United Kingdom, 1705–1716.
24.
Thornton, H. T., Jr., and Alexander, A. M. (1987). “Development of nondestructive testing systems for in-situ evaluation of concrete structures.”Tech. Rep. REMR-CS-10, U.S. Army Engrs. Waterways Experiment Station, Vicksburg, Miss.
25.
Wu, Z., Farahat, A. M., and Tanabe, T.(1993). “Modeling of concrete Discontinuities with Dilatancy and Surface Degradation.”J. Mat., Concrete Struct. and Pavements, 20(472), 119–129.
26.
Yokomichi, H., Ikeda, I., and Matsuoka, K. (1964). “Propagation of elastic wave due to cracking in concrete.”Cement and Concrete, No. 212, Cement Assoc. in Japan, Tokyo, Japan, 2–6 (in Japanese).
Information & Authors
Information
Published In
Copyright
Copyright © 1995 American Society of Civil Engineers.
History
Published online: Aug 1, 1995
Published in print: Aug 1995
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.