Microstructural Development in High‐Volume Fly‐Ash Cement System
Publication: Journal of Materials in Civil Engineering
Volume 6, Issue 1
Abstract
The writers present the results of research findings on the micro‐structural development in a high‐volume fly‐ash (HVFA) cement system containing 60% fly ash by weight of binder. Although the one‐day strength of HVFA mortar is low compared to plain cement mortar, from three‐day onward the strength starts to increase. Corresponding to the development of microstructure, the strength increases significantly at later ages and reaches 78% of the control specimen at 180 days. The literature survey reveals that hydration of fly‐ash aluminate phases produces hydrates similar to those in cement. To reveal the fly‐ash hydration process more vividly, a special type of cement containing very low and alkalies was used with a class F fly ash. In order to precisely determine the role of high‐volume replacement in a cementitious system, a comparative study of plain cement and HVFA paste was carried out. The mechanism of fly‐ash hydration in this system is discussed and a correlation between its microstructure/strength development established. Better dispersion of cement grains, smaller crystals, and formation of more gel phases largely account for the strengthening effect. The effect of fly‐ash replacement on neat water‐to‐cement ratio, initial pore content, crystallization, and dissolution of fly‐ash glass phase are discussed. Comparison of experimental results determined by x‐ray diffraction (XRDA) analysis, strength measurement, and thermogravimetry/differential thermal analysis (TG/DTA) is also presented.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Berry, E. E., Hemmings, R. T., and Cornelius, B. J. (1990). “Mechanisms of hydration reactions in high volume fly ash pastes and mortars.” Cem. Concr. Compos., 12(4), 253–261.
2.
Brunauer, S., and Greenberg, S. A. (1960). “The hydration of tricalcium silicate and β‐dicalcium silicate at room temperature.” Proc. 4th Int. Symp. Chem. Cem., Washington, D.C., I, 135–165.
3.
Cabrera, J. G., and Plowman, C. (1980). “The influence of pulverized fuel ash on the early and long term strength of concrete.” Proc. 7th Int. Congress Chem. Cem., Paris, III, IV/84–92.
4.
Copeland, L. E., and Kantro, D. L. (1968). “Hydration of portland cement.” Proc. 5th Int. Symp. Chem. Cem., Tokyo, Japan, II, 387–421.
5.
Czernin, W. (1960). “A few unsolved problems of cement hydration.” Proc. 4th Int. Symp. Chem. Cem., Washington, D.C., II, 725–729.
6.
Dhir, R. K. (1986). “Pulverized‐fuel ash.” Cement Replacement Materials, R. N. Swamy, ed., Surrey Univ. Press.
7.
Diamond, S. (1972). “Identification of hydrated cement constituents using a scanning electron microscope‐energy dispersive X‐ray spectrometer combination.” Cem. Concr. Res., 2(4), 617–632.
8.
Diamond, S. (1989). “Minimal pozzolanic reaction in one year old fly ash pastes: An SEM evaluation.” Proc. 11th Int. Conf. Cem. Microscopy, New Orleans, 263–274.
9.
Diamond, S., Ravina, D., and Lovell, J. (1980). “The occurrence of duplex films on flyash surfaces.” Cem. Concr. Res., 10(2), 297–300.
10.
Feldman, R. F., Carette, G. G., and Malhotra, V. M. (1990). “Studies on mechanism of development of physical and mechanical properties of high‐volume fly ash‐cement pastes.” Cem. Concr. Compos., 12(4), 245–251.
11.
Fraay, A. L. A., Bijen, J. M., and de Haan, Y. M. (1989). “The reaction of fly ash in concrete—A critical examination.” Cem. Concr. Res., 19(2), 235–246.
12.
Ghose, A., and Pratt, P. L. (1981). “Studies of the hydration reactions and micro‐structure of cement‐fly ash pastes.” Effects of Fly Ash Incorporation in Cement Concrete, MRS Symp. N, Boston, S. Diamond, ed., 82–91.
13.
Grandet, J., and Ollivier, J. P. (1980). “Nouvelle méthode d'étude des interfaces ciment‐granulats.” Proc. 7th Int. Congress Chem. Cem., Paris, France, III, VII/85–89 (in French).
14.
Grudemo, Å. (1960). “The microstructure of hardened cement paste.” Proc. 4th Int. Symp. Chem. Cem., Washington, D.C., II, 615–647.
15.
Grutzeck, M. W., Roy, D. M., and Scheetz, B. E. (1981). “Hydration mechanisms of high‐lime fly ash in portland cement composites.” Effects of Fly Ash Incorporation in Cement Concrete, MRS Symp. N, Boston, S. Diamond, ed., 92–101.
16.
Helmuth, R. A. (1986). “Water reducing properties of fly ash in cement pastes, mortars and concretes: causes and test methods.” Proc. 3rd Int. Conf. Fly Ash, Slag, Silica Fume and Natural Pozzolnas in Concrete, Madrid, Spain, ACI SP‐91, 723–740.
17.
Luke, K., and Glasser, F. P. (1986). “Chemical changes occurring during the early hydration of PFA‐OPC mixtures.” MRS. Symp. Proc., 65, 173–180.
18.
Malhotra, V. M. (1986). “High volume fly ash concrete for structural applications.” CANMET Seminar on Nova Scotia Fly Ashes, Canada Ctr. for Mineral and Energy Tech. (CANMET).
19.
Massazza, F. (1974). “Chemistry of pozzolanic additions and mixed cements.” 6th Int. Congress Chem. Cem., Moscow, USSR.
20.
Mehta, P. K. (1989). “Pozzolanic and cementitious by‐products in concrete—Another look.” Proc. 3rd Int. Conf. Fly Ash, Slag, Silica Fume and Natural Pozzolnas in Concrete, Trondheim, Norway, 1–43.
21.
Nägele, E., and Schneider, U. (1989). “The zeta‐potential of blast furnace slag and fly ash.” Cem. Concr. Res., 19(5), 811–820.
22.
Neville, A. M. (1973). Properties of Concrete, 2nd Ed., Pitman Publishing, London, U.K.
23.
Oyefesobi, S. O., and Roy, D. M. (1977). “Effect of admixtures on hot‐pressed cements.” Cem. Concr. Res., 7(2), 165–172.
24.
Richartz, W. (1968). “Electron microscopic investigations about the relations between structure and strength of hardened cement paste.” Proc. 5th Int. Symp. Chem. Cem., Tokyo, Japan, III, 119–128.
25.
Roy, D. M. (1989). “Fly ash and silica fume chemistry and hydration.” Proc. 3rd Int. Conf. Fly Ash, Slag, Silica Fume and Natural Pozzolnas in Concrete, 1, 119–138.
26.
Swamy, R. N., and Mahmud, H. B. (1986). “Mix proportions and strength characteristics of concrete containing 50 percent low‐calcium fly ash.” Proc. 2nd Int. Conf. Fly Ash, Slag, Silica Fume and Natural Pozzolnas in Concrete, 413–432.
27.
Takemoto, K., and Uchikawa, H. (1980). “Hydration of pozzolanic cement.” Proc. 7th Int. Cong. Chem. Cem., 2/1–29.
28.
Tenoutasse, N., and Marion, A. M. (1986). “Characterization of Belgian fly ashes and their behavior in cement paste.” Proc. 2nd Int. Conf. Fly Ash, Slag, Silica Fume and Natural Pozzolnas in Concrete, 51–76.
29.
Thorvaldson, T., Birss, F. W., and McCurdy, K. G. (1960). “Calcium exchange in systems of .” Proc. 4th Int. Symp. Chem. Cem., Washington, D.C., 315–320.
30.
Villanueva, H. R., and Carrasquillo, R. L. (1990). “The effect of fly ash on temperature and rise hydration in portland cement concrete.” PMFSEL 90‐1, The Univ. of Texas at Austin, Austin, Tex.
31.
Wei, F., Grutzek, M. W., and Roy, D. M. (1985). “The retarding effect of fly ash upon the hydration of cement pastes: The first 24 hours.” Cem. Conc. Res., 15(1), 174–184.
32.
Xu, A. (1990). “The structure and some physical properties of cement mortar with fly ash.” P‐90:9, Chalmers Univ. of Tech., Göteborg, Sweden.
33.
Xu, A., and Sarkar, S. L. (1991). “Microstructural study of gypsum activated fly ash hydration in cement paste.” Cem. Concr. Res., 21(6), 1137–1147.
Information & Authors
Information
Published In
Journal of Materials in Civil Engineering
Volume 6 • Issue 1 • February 1994
Pages: 117 - 136
Copyright
Copyright © 1994 American Society of Civil Engineers.
History
Received: Nov 17, 1992
Published online: Feb 1, 1994
Published in print: Feb 1994
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.