Aging and Low-Temperature Cracking of Asphalt Concrete Mixture
Publication: Journal of Cold Regions Engineering
Volume 10, Issue 3
Abstract
Low-temperature cracking in asphalt concrete (AC) pavement is influenced by several factors broadly categorized as material, environmental, and pavement-structure geometry. Among the environmental factors affecting low-temperature cracking is pavement age. The older the pavement, the greater the incidence of thermal cracking. While some preliminary work has been done to investigate the significance of aging on the low-temperature cracking resistance of an AC mixture, a comprehensive research program has not been conducted. In recognition of this situation, a laboratory research program was undertaken to investigate the effect of aging temperature, duration of aging, and asphalt cement type on the thermal-cracking characteristics of AC mixtures. The thermal-stress–restrained specimen test (TSRST) was used to characterize the low-temperature cracking resistance of the asphalt aggregate mixtures used in the research program. Based on the results of this investigation, it was noted that the aging temperature strongly influences changes that occur in cold-temperature fracture properties of AC mixtures. Further, at low temperatures, say 50°C, aging appears to “quench” at some point so that further aging time does not significantly change low-temperature cracking behavior. At high temperatures, say 85°C, aging appears to continue so that further aging time significantly changes low-temperature cracking behavior. Asphalt cements with a high proportion of nonpolar components are not as susceptible to oxidative aging as other asphalts. However, a high proportion of nonpolar components makes asphalt cement relatively susceptible to thermal cracking because of the structuring that occurs at low temperatures. The air-voids content, within a reasonable range associated with in-service AC mixtures, does not influence the aging characteristics of AC mixtures. The Strategic Highway Research Program long-term aging procedure adequately reflects the field in service aging conditions, which pavements are subjected to in many cold regions.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Anderson, K. O., and Leung, S. C. (1987). “Applications of a method for evaluation of low temperature tensile properties of asphalt concrete.”Proc., Paving in Cold Areas Mini-Workshop, Research and Development Branch, Ontario Ministry of Transportation and Communication (MTC), Ottawa, Ontario, Canada, 335–336.
2.
Arand, W. (1987). “Influence of bitumen hardness on the fatigue behavior of asphalt pavements of different thickness due to bearing capacity of subbase, traffic loading, and temperature.”Proc., 6th Int. Conf. on Struct. Behavior of Asphalt Pavements, Univ. of Michigan, Ann Arbor, Mich., 65–71.
3.
Bell, C. A., Wieder, A., and Fellin, M. J. (1994a). “Laboratory aging of asphalt-aggregate mixtures: field validation.”Strategic Hwy. Res. Program, Report SHRP-A-390, National Research Council, Washington, D.C.
4.
Bell, C. A., AbWahab, Y., Cristi, M. E., and Sosnovske, D. (1994b). “Selection of laboratory aging procedures for asphalt-aggregate mixtures.”Rep. No. SHRP-A-383, Strategic Highway Research Program, National Research Council, Washington, D.C.
5.
Bell, C. A., and Kliewer, J. E. (1995). “Evaluating aging of asphalt mixes.”Proc., ASCE Transp. Congr.—Civ. Engrs. Key to the Worlds Infrastructure, ASCE, New York, N.Y., 664–675.
6.
Benson, P. E. (1976). “Low temperature transverse cracking of asphalt concrete pavements in central and west Texas.”Rep. TTI-2-9-72-175-2F, Texas Transportation Institute, Texas A&M Univ., College Station, Tex.
7.
Branthaver, J. F., et al. (1993). “Binder characterization and evaluation.”Rep. No. SHRP-A-368, Strategic Highway Research Program, National Research Council, Washington, D.C.
8.
Busby, E. O., and Rader, L. F. (1972). “Flexural stiffness properties of asphalt concrete at low temperatures.”Proc., Assn. of Asphalt Paving Technologists, AAPT, 41, Ann Arbor, Mich., 163–187.
9.
Christison, J. T., Murray, D. W., and Anderson, K. O. (1972). “Stress prediction and low-temperature fracture susceptibility of asphaltic concrete pavements.”Proc., Assn. of Asphalt Paving Technologists, AAPT, 41, Ann Arbor, Mich., 494–523.
10.
Dow, A. W. (1903). “Asphalt experiments at Washington.”Engrg. News Rec., 47(18).
11.
D4123-82: Standard test method for resilient modulus of bituminous mixtures. (1983). ASTM, Philadelphia, Pa.
12.
Esch, D. C., and Franklin, D. (1989). “Asphalt pavement crack control at Fairbanks International Airfield.”Proc., 5th Int. Conf. on Cold Regions Engrg., ASCE, New York, N.Y., 59–69.
13.
Fabb, T. R. J.(1974). “The influence of mix composition, binder properties and cooling rate on asphalt cracking at low-temperature.”Proc., Assn. of Asphalt Paving Technologists, AAPT, 43, 285–331.
14.
Haas, R. (1973). “A method for designing asphalt pavements to minimize low-temperature shrinkage cracking.”RR-73-1, Asphalt Institute, Lexington, Ky.
15.
Heukelom, W., and Klomp, A. (1964). “Road design and dynamic loading.”Proc., Assn. of Asphalt Paving Technologists, AAPT, 33, Ann Arbor, Mich., 92–125.
16.
Hills, J. F., and Brien, D. (1966). “The fracture of bitumen and asphalt mixes by temperature induced stresses.”Proc., Assn. of Asphalt Paving Technologists, AAPT, 35, Ann Arbor, Mich., 292–309.
17.
Janoo, V. C. (1989). “Use of low viscosity asphalts in cold regions.”Proc., 5th Int. Conf. on Cold Regions Engrg., ASCE, New York, N.Y., 70–80.
18.
Jones, D. R. (1992). “An asphalt primer: understanding how the origin and composition of paving-grade asphalt cements affect their performance.”Strategic Hwy. Res. Program, Asphalt Res. Program Tech. Memorandum No. 4, National Research Council, Washington, D.C.
19.
Jung, D. H., and Vinson, T. S. (1993a). “Low temperature cracking resistance of asphalt concrete mixtures.”Proc., Assn. of Asphalt Paving Technologists, AAPT, 62, Minneapolis, Minn., 54–87.
20.
Jung, D. H., and Vinson, T. S. (1993b). “Thermal stress restrained specimen test to evaluate low-temperature cracking of asphalt-aggregate mixtures.”Transp. Res. Rec. No. 1417, Transportation Research Board, National Research Council, Washington, D.C., 12–20.
21.
Jung, D. H., and Vinson, T. S. (1994a). “Low-temperature cracking: binder validation.”Strategic Hwy. Res. Program, Report SHRP-A-399, National Research Council, Washington, D.C.
22.
Jung, D. H., and Vinson, T. S. (1994b). “Low-temperature cracking: test selection.”Strategic Hwy. Res. Program, Rep. SHRP-A-401, National Research Council, Washington, D.C.
23.
Kallas, B. F. (1982). “Low-temperature mechanical properties of asphalt concrete.”Asphalt Inst. Res. Rep., No. RR-82-3, Asphalt Institute, Lexington, Ky.
24.
Kanerva, H. K., and Nurmi, T. (1991). “Effects of asphalt properties on low temperature cracking of asphalt pavements.”Proc., ASTO Conf., Asfaltti paallysteiden Tutkimusohjelma, ASTO, Espo, Finland.
25.
Kanerva, H. K., Vinson, T. S., and Zeng, H. (1994). “Low-temperature cracking: field validation of the thermal stress restrained specimen test.”Strategic Hwy. Res. Program, Rep. SHRP-A-401, National Research Council, Washington, D.C.
26.
Kliewer, J. E., Bell, C. A., and Sosnovske, D. A. (1994). “Investigation of the relationship between field performance and laboratory aging properties of asphalt mixtures.”Engrg. Properties of Asphalt Mixtures and the Relationship to Perf., ASTM STP 1265, Philadelphia, Pa.
27.
Monismith, C. L., Secor, G. A., and Secor, K. E. (1965). “Temperature induced stresses and deformations in AC.”Proc., Assn. of Asphalt Paving Technologists, AAPT, 34, Ann Arbor, Mich., 248–285.
28.
Petersen, J. C. (1990). “Effects of physicochemical factors on asphalt aging.”Serviceability and Durability of Constr. Mat., Vol. 1, Proc., of the 1st Mat. Engrg. Congr., ASCE, Denver, Colo., 244–253.
29.
Petersen, J. C. (1984). “Chemical composition of asphalt as related to asphalt durability: State of the art.”Transp. Res. Rec. 999:13–30, Transportation Research Board, Washington, D.C.
30.
Robertson, R. E. (1991). “Chemical properties of asphalts and their relationship to pavement performance.”Strategic Hwy. Res. Program, Rep. SHRP-A/UWP-91-510, National Research Council, Washington, D.C.
31.
Traxler, R. N. (1961). “Relation between asphalt composition and hardening by volatilization and oxidation.”Proc., Assn. of Asphalt Paving Technologists, AAPT, 30, Ann Arbor, Mich., 359–377.
32.
Traxler, R. N. (1963). “Durability of asphalt cements.”Proc., Assn. of Asphalt Paving Technologists, AAPT, 32, Ann Arbor, Mich., 44–58.
33.
van der Poel. (1954). “A general system describing the viscoelastic properties of bitumens and its relation to routine test data.”J. Appl. Chem., 4(221).
34.
Vinson, T. S., Zomerman, I., Berg, R., and Tomita, H. (1986). “Survey of airport pavement distress in cold regions.”Proc., 4th Int. Cold Regions Engrg. Specialty Conf., ASCE, New York, N.Y., 41–50.
35.
Vinson, T. S., Janoo, V. C., and Haas, R. C. G. (1989). “Summary report on low temperature and thermal fatigue cracking.”Strategic Hwy. Res. Program, Rep. SHRP-A/IR-90-001, National Research Council, Washington, D.C.
Information & Authors
Information
Published In
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Sep 1, 1996
Published in print: Sep 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.