Comparison of Load Restriction Timings Determined Using FHwA Guidelines and Frost Tubes
Publication: Journal of Cold Regions Engineering
Volume 10, Issue 1
Abstract
The Federal Highway Administration (FHwA) method and frost-tube measurements are used in Wisconsin to determine the timing and duration of spring load restrictions. In both methods, depth of freeze or thaw is used to determine when to apply load restrictions and to determine their duration. Average daily air temperatures are used in the FHwA method to predict the start and end of freeze and/or thaw. Frost tubes are used to directly determine depth of freeze and/or thaw. An analysis is conducted to compare these two methods using air-temperature data (for the FHwA method) and frost-tube data obtained in Wisconsin. The analysis shows that differences exist between predicted (FHwA method) and measured (frost tubes) freeze and thaw conditions. The FHwA method is early (unconservative) in predicting the start of freeze and late (unconservative) in predicting the start of thaw. However, the method is late (conservative) when used to predict the end of thaw. A case history is also presented to compare the two methods.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Barcomb, J. (1989). “Use of thermistors for spring road management.”Transp. Res. Rec. 1252, Trans. Res. Board, Nat. Res. Council, Washington, D.C., 12–20.
2.
Goering, D., and Zarling, J. (1985). TDHC finite element program user's manual . Univ. of Alaska, Fairbanks, Alaska.
3.
Mahoney, J. P., Lary, J A., Sharma, J., and Jackson, N. C. (1985). “Investigation of seasonal load restrictions in Washington State.”Transp. Res. Rec. 1043, Transp. Res. Board, Nat. Res. Council, Washington, D.C., 58–67.
4.
Mahoney, J. P., Rutherford, M. S., and Hicks, R. G. (1987). “Guidelines for spring highway use restrictions.”Rep., FHWA-TS-87-209, Federal Hwy. Admin., McLean, Va.
5.
Martinelli, T. J. (1977). “The use of frost depth indicators in Wisconsin highways.”Summary Rep., Res. Unit, Mat. Section, Div. of Hwy., Wisconsin Dept. of Transp., Madison, Wis.
6.
McBane, J. A., and Hanek, G. (1986). “Determination of the critical thaw-weakened period in asphalt pavement structures.”Transp. Res. Rec. 1089, Transp. Res. Board, Nat. Res. Council, Washington, D.C., 138–146.
7.
Rutherford, M. S., and Mahoney, J. P. (1986). “A thermal analysis of pavement thawing.”Proc., Fourth Int. Conf. on Cold Regions Engrg., ASCE, New York, N.Y.
8.
Rwebangira, T., Rutherford, M. S., Mahoney, J. P., and Hicks, R. G. (1987). “Development of spring load restrictions for local roads.”Transp. Res. Rec. 1128, Transp. Res. Board, Nat. Res. Council, Washington, D.C., 42–52.
9.
Yesiller, N., Benson, C. H., and Bosscher, P. J. (1995). “Method development for determining the effect of thermal cycles and moisture conditions on pavement structure.”Interim Rep., WisDOT, Wisconsin Dept. of Transp., Madison, Wis.
Information & Authors
Information
Published In
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Mar 1, 1996
Published in print: Mar 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.