Three-Dimensional Numerical Model with Free Water Surface and Mesh Deformation for Local Sediment Scour
Publication: Journal of Waterway, Port, Coastal, and Ocean Engineering
Volume 134, Issue 4
Abstract
A numerical model for local sediment scour with free surface and automatic mesh deformation is constructed and numerical results are compared with experimental results. For the turbulence closure, the two equation model is used. Two interfaces (water and air, water and sediment) in the domain are captured with different approaches. The free surface of the flow is simulated with the volume of fluid (VOF) scheme, which is an Eulerian approach. A new method for the VOF scheme is proposed to reduce the computational time while retaining relative accuracy. The behavior of the water-sediment interface (bed) is captured with a moving-mesh method, which is a Lagrangian approach. The flow field is coupled with sediment transport (both bed load and suspended load) using a quasi-steady approach. Good results have been obtained using the current model. The flow field is similar to the one observed in experiments. Scour patterns are similar to the experimental data as well. Large computational times are needed for morphological simulation and parallel computation is used to accelerate this process. The results obtained from the model are promising.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by the Coastal Geosciences Program of the Office of Naval Research, Grant No. ONRN00014-05-1-0083. The writers gratefully thank Professor B. M. Sumer for his helpful discussion and suggestions. The computational resources provided by the National Center for Supercomputing Applications (NCSA) at University of Illinois at Urbana-Champaign are gratefully acknowledged.
References
Aliabadi, A., Abedi, J., Zellars, B., Bota, K., and Johnson, A. (2003). “Simulation technique for wave generation.” Commun. Numer. Methods Eng., 19(5), 349–359.
Brørs, B. (1999). “Numerical modeling of flow and scour at pipelines.” J. Hydraul. Eng., 125(5), 511–523.
Cataño Lopera, Y. A., and García, M. H. (2006). “Burial of short cylinders induced by scour under combined waves and currents.” J. Waterway, Port, Coastal, Ocean Eng., 132(6), 439–449.
Chatterjee, S. S., and Ghosh, S. N. (1980). “Submerged horizontal jet over erodible bed.” J. Hydr. Div., 106(11), 1765–1782.
Chatterjee, S. S., Ghosh, S. N., and Chatterjee, M. (1994). “Local scour due to submerged horizontal jet.” J. Hydraul. Eng., 120(8), 973–992.
Dean, R. G., and Dalrymple, R. A. (1991). Water wave mechanics for engineers and scientists, World Scientific, River Edge, N.J.
Engelund, F., and Fredsøe, J. (1976). “A sediment transport model for straight alluvial channels.” Nord. Hydrol., 7, 293–306.
García, M. H. (1999). “Sedimentation and erosion hydraulics.” Hydraulic design handbook, Chap. 6, McGraw-Hill, Inc., New York.
García, M. H., and Parker, G. (1991). “Entrainment of bed sediment into suspension.” J. Hydraul. Eng., 117(4), 414–435.
Hirt, C. W., and Nicholls, B. D. (1981). “Volume of fluid (vof) method for dynamics of free boundaries.” J. Comput. Phys., 39(1), 201–225.
Issa, R. I. (1986). “Solution of the implicitly discretised fluid flow equations by operator-splitting.” J. Comput. Phys., 62(1), 40–65.
Jasak, H. (1996). “Error analysis and estimation for the finite volume method with application to fluid flows.” Ph.D. thesis, Imperial College of Science, Technology and Medicine, London.
Jasak, H., and Tuković, Z. (2007). “Automatic mesh motion for the unstructured finite volume method.” Transactions of Faculty of Mechanical Engineering and Naval Architecture, Univ. of Zagreb, Crotia, 30(6), 1–18.
Liang, D., Cheng, L., and Li, F. (2005). “Numerical modeling of flow and scour below a pipeline currents. Part II: Scour simulation.” Coastal Eng., 52(1), 43–62.
Liu, X., and García, M. H. (2006). “Numerical simulation of local scour with free surface and automatic mesh deformation.” Proc., EWRI World Water and Environmental Congress, ASCE, Reston, Va.
Mayer, S., Garapon, A., and Sorensen, L. S. (1998). “A fractional step method for unsteady free-surface flow with application to non-linear wave dynamics.” Int. J. Numer. Methods Fluids, 28(2), 293–315.
Mayer, S., and Madsen, P. (2000). “Simulation of breaking waves in the surf zone using a Navier–Stokes solver.” Proc., Int. Conf. in Coastal Engineering, ASCE, Reston, Va.
Olsen, N. R. B., and Melaaen, M. C. (1993). “Three-dimensional calculation of scour around cylinders.” J. Hydraul. Eng., 119(9), 1048–1054.
Olsen, N. R. B., and Melaaen, M. C. (1999). “Three-dimensional numerical flow modeling for estimation of maximum local scour depth.” J. Hydraul. Res., 36(9), 579–590.
OpenCFD. (2005). “OpenFOAM: The open source computational fluid dynamics (cfd) toolbox.” http:://www.OpenFoam.org (Dec. 10, 2006 ).
Parker, G., and García, M. H. (2006). “River, coastal and estuarine morphodynamics.” Proc., RCEM 2005, Taylor & Francis Group, London.
Patankar, S. V. (1981). Numerical heat transfer and fluid flow, McGraw-Hill, New York.
Rajaratnam, N. (1976). Turbulent jet, Elsevier Scientific, New York.
Richardson, J. E., and Panchang, V. G. (1998). “Three-dimensional simulation of scour-inducing flow at bridge piers.” J. Hydraul. Eng., 124(5), 530–540.
Rodi, W. (1993). Turbulence models and their application in hydraulics— A state of the art reviews, 3rd Ed., International Association for Hydraulic Research, Delft, Balkema, Rotterdam, The Netherlands.
Roulund, A., Sumer, B. M., Fredsøe, J., and Michelsen, J. (2005). “Numerical and experimental investigation of flow and scour around a circular pile.” J. Fluid Mech., 534, 351–401.
Sethian, J. A. (1996). Level set methods: Evolving interfaces in geometry, fluid mechanics, computer vision, and material science, Cambridge Monographs on Applied and Computational Mathematics, Cambridge University Press, Cambridge, U.K.
Smith, J. D., and McLean, S. (1977). “Spatially averaged flow over a wavy surface.” J. Geophys. Res., 83, 1735–1746.
Sumer, B. M., Christiansen, N., and Fredsøe, J. (1993). “Influence of cross section on wave scour around piles.” J. Waterway, Port, Coastal, Ocean Eng., 119(5), 477–495.
Sumer, B. M., and Fredsøe, J. (2001). “Wave scour around a large vertical circular cylinder.” J. Waterway, Port, Coastal, Ocean Eng., 127(3), 125–134.
Sumer, B. M., Fredsøe, J., and Christiansen, N. (1992). “Scour around a vertical pile in waves.” J. Waterway, Port, Coastal, Ocean Eng., 118(1), 15–31.
Ubbink, O., and Issa, R. I. (1999). “A method for capturing sharp fluid interfaces on arbitrary meshes.” J. Comput. Phys., 153, 26–50.
Van Beek, F. A., and Wind, H. G. (1990). “Numerical modeling of erosion and sedimentation around offshore pipelines.” Coastal Eng., 14, 107–128.
van Rijn, L. C. (1984). “Sediment transport. Part II: Suspended load transport.” J. Hydraul. Eng., 110(11), 1613–1641.
Weller, H. G., Tabor, G., Jasak, H., and Fureby, C. (1998). “A tensorial approach to computational continuum mechanics using object-oriented techniques.” Comput. Phys., 12(6), 620–631.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Jun 6, 2006
Accepted: Sep 4, 2007
Published online: Jul 1, 2008
Published in print: Jul 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.