Validation of Perspective-View Concept for Estimating Road Horizontal Curvature
Publication: Journal of Transportation Engineering
Volume 135, Issue 2
Abstract
In three-dimensional (3D) alignments, some road geometric parameters, such as vertical curve type (crest or sag), can cause drivers to have visual illusions in perceiving the horizontal curvature that may result in erroneous decisions. Road curvature estimation is usually made based on the perspective-view (PV) information. It is hypothesized that drivers can estimate road curvature visually based on the openness magnitude of the inside edge lines which appear to the drivers as parabolas or hyperbolas. This paper further develops the PV concept and validates it using the published results of driver perceptions of 3D alignments. The analysis shows that there are statistically good relationships between the ratio of the 3D perspective radii of the crest (or sag) and flat horizontal curves, and driver perceptions. Preliminary criteria for the design of 3D alignments based on driver perceptions are presented. The PV method provides a means of incorporating driver perception into geometric design, and therefore should be of interest to highway designers and researchers.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers acknowledge the support from the National Natural Science Foundation of China (NSFC) (Grant No. 50478082) and the Natural Sciences and Engineering Research Council of Canada (NSERC). The writers also thank the anonymous reviewers for their thorough and most helpful comments.
References
American Association of State Highway and Transportation Officials (AASHTO). (2004). A policy on geometric design of highways and streets, Washington, D.C.
Appelt, V. (2000). “New approaches to the assessment of the spatial alignment of rural roads—Apparent radii and visual distortion.” Proc., 2nd Int. Symp. on Highway Geometric Design, Transportation Research Board (TRB), Washington, D.C., 620–631.
Bidulka, S., Sayed, T., and Hassan, Y. (2002). “Influence of vertical alignment on horizontal curve perception. Phase I: Examining the hypothesis.” Transportation Research Record. 1796, Transportation Research Board, Washington, D.C., 12–23.
Dabbour, E., Easa, S. M., and Abd El Halim, A. O. (2004). “Radius requirements for reverse horizontal curves on three-dimensional alignments.” J. Transp. Eng., 130(5), 610–620.
Easa, S. M., and He, W. (2006). “Modeling driver visual demand on three-dimensional highway alignments.” J. Transp. Eng., 132(5), 357–365.
Easa, S. M., Strauss, T. R., Hassan, Y., and Souleryette, R. R. (2002). “Three-dimensional transportation analysis: Planning and design.”J. Transp. Eng., 128(3), 250–258.
Fildes, B. N., and Triggs, T. J. (1985). “The effect of changes in curve geometry on magnitude estimates of road-like perspective curvature.” Percept. Psychophys., 37(3), 218–224.
Gibreel, G. M., Easa, S. M., and El-Dimeery, I. A. (2001). “Prediction of operating speed on three-dimensional highway alignments.” J. Transp. Eng., 127(1), 21–30.
Hasan, M., Sayed, T., and Hassan, Y. (2005). “Influence of vertical alignment on horizontal curve perception: Effect of spirals and position of vertical curve.” Can. J. Civ. Eng., 32(1), 204–212.
Hassan, Y., and Easa, S. M. (1998). “Design of sag vertical curves in three-dimensional alignments.” J. Transp. Eng., 124(1), 52–58.
Hassan, Y., and Easa, S. M. (2003). “Effect of vertical alignment on driver perception of horizontal curves.” J. Transp. Eng., 129(4), 399–407.
Hassan, Y., Sayed, T., and Bidulka, S. (2002). “Influence of vertical alignment on horizontal curve perception. Phase II: Modeling perceived radius.” Transportation Research Record. 1796, Transportation Research Board, Washington, D.C., 24–34.
Ismail, K., and Sayed, T. (2007). “New algorithm for calculating 3D available sight distance.” J. Transp. Eng., 133(10), 572–581.
Lamm, R., Psarianos, B., and Mailaender, T. (1999). Highway design and traffic safety engineering handbook, McGraw-Hill, New York.
Land, M., and Horwood, J. (1995). “Which parts of the road guide steering?” Nature (London), 377(6547), 339–340.
Land, M. F. (1998). “The visual control of steering.” Vision and action, L. R. Harris and M. Jenkin, eds., Cambridge University Press, Cambridge, Mass., 163–180.
Land, M. F., and Lee, D. N. (1994). “Where we look when we steer.” Nature (London), 369(6483), 742–744.
Serafin, C. (1993). Preliminary examination of driver eye fixations on rural roads: Insight into safety driving behavior, Transportation Research Institute, Univ. of Michigan, Ann Arbor, Mich.
Smith, B. L., and Lamm, R. (1994). “Coordination of horizontal and vertical alignment with regard to highway esthetics.” Transportation Research Record. 1445, Transportation Research Board, Washington, D.C., 73–85.
Taiganidis, I., and Kanellaidis, G. (1999). “Approximate perspective design of roads.” J. Transp. Eng., 125(4), 314–323.
ten Brummelaar, T. (1983). “The reversal point in the perspective road picture.” Aust. Road Res., 13(2), 123–127.
Transportation Association of Canada (TAC). (1999). Geometric design guide for Canadian roads, Ottawa.
Zakowska, L. (1999). “Road curve evaluation based on road view perception study.” Transportation Research Record. 1689, Transportation Research Board, Washington D.C., 68–72.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Mar 21, 2007
Accepted: Jul 3, 2008
Published online: Feb 1, 2009
Published in print: Feb 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.