Simulation of Mixed Traffic Flow on Two-Lane Roads
Publication: Journal of Transportation Engineering
Volume 134, Issue 9
Abstract
Data were collected at several locations of two-lane roads in different parts of India and were analyzed to study the speed, placement, arrival, acceleration, and overtaking characteristics of different types of vehicles. A computer program is developed to simulate the traffic flow on a two-lane highway incorporating all these characteristics. The simulation program is coded in Visual Basic language and has also been animated. A number of simulation runs were performed to determine the capacity of a two-lane road and to study the effect of traffic mix on capacity and speed. The passenger car unit (PCU) for an individual category of vehicles is calculated and the effect of directional split on capacity is evaluated. Capacity of a two-lane road under an all cars situation is estimated as . It increases to 5,600 vehicle per hour (vph) in case of all two-wheelers and reduces to 580 vph in case of all tractors situation. The capacity also reduces as the directional split moves away from an even split of and this reduction is linear. It is further observed that the capacity of a two-lane road decreases as the proportion of three-wheeler, tractor, or heavy vehicle increases in the traffic stream. But, in the case of two-wheelers the capacity was found to increase with their own proportion. This is attributed to the small size of two-wheelers and their maneuverability.
Get full access to this article
View all available purchase options and get full access to this article.
References
Aycin, M. F., and Benekohal, R. F. (2000). “Comparison of car-following models for simulation.” Transportation Research Record. 1678, Transportation Research Board, National Research Council, Washington, D.C., 116–127.
Benekohal, R. F., and Treiterer, J. (1988). “CARSIM: Car-following model for simulation of traffic in normal and stop-and-go conditions.” Transportation Research Record. 1194, Transportation Research Board, National Research Council, Washington, D.C., 99–111.
Brannolte, U. (1984). “SIMLA-2—A microscopic simulation model of traffic flow on two-lane rural roads.” Proc., 12th ARRB Conf., Hobart, Tasmania, Vol. 12(5), 88–92.
Chakraborty, P., Agrawal, S., and Vasishtha, K. (2004). “Microscopic modeling of driver behavior in uninterrupted traffic flow.” J. Transp. Eng., 130(4), 438–451.
Chandra, S. (2004). “Effect of road roughness on capacity of two-lane roads.” J. Transp. Eng., 130(3), 360–364.
Dabbour, E., Easa, S. M., and Halim, A. O. A. E. (2004). “Radius requirements for reverse horizontal curves on three-dimensional alignments.” J. Transp. Eng., 130(5), 610–620.
Easa, S. M. (2003). “Distributing superelevation to maximize highway design consistency.” J. Transp. Eng., 129(2), 127–133.
Easa, S. M., and He, W. (2006). “Modeling driver visual demand on three-dimensional highway alignments.” J. Transp. Eng., 132(5), 357–365.
Elefteriadou, L., Torbic, D., and Webster, N. (1997). “Development of passenger car equivalents for freeways, two-lane highways, and arterials.” Transportation Research Record. 1572, Transportation Research Board, National Research Council, Washington, D.C., 51–58.
Hassan, Y., and Easa, S. M. (1998a). “Design considerations of sight distance red zones on crest curves.” J. Transp. Eng., 124(4), 343–352.
Hassan, Y., and Easa, S. M. (1998b). “Sight distance red zones on combined horizontal and sag vertical curves.” Can. J. Civ. Eng., 25(4), 621–630.
Hassan, Y., and Easa, S. M. (2000). “Modeling of required preview sight distance.” J. Transp. Eng., 126(1), 13–20.
Hassan, Y., Easa, S. M., and Halim, A. O. (1996). “Passing sight distance on two-lane highways: Review and revision.” Transp. Res., Part A: Policy Pract., 30(6), 453–467.
The Indian Roads Congress (IRC). (1990). “Guidelines for capacity of roads on rural areas.” IRC: 64-1990, New Delhi, India.
Kumar, V. M., and Rao, S. K. (1996). “Simulation modeling of traffic operations on two-lane highways.” Highway Research Bulletin No. 54, Indian Roads Congress, New Delhi, 211–237.
Marwah, B. R., and Ramaseshan, S. (1978). “Interaction between vehicles in mixed traffic flow using simulation.” Highway Research Bulletin No. 8, Indian Roads Congress, New Delhi, 1–16.
Palaniswamy, S. P., Gynnerstedt, G., and Phull, Y. R. (1985). “Indo-Swedish road traffic simulation model: Generalized traffic system simulator.” Transportation Research Record. 1005, Transportation Research Board, National Research Council, Washington, D.C., 72–80.
Ramanayya, T. V. (1980). “Simulation studies on traffic capacity of road system for Indian conditions.” Ph.D. thesis, Regional Engineering College, Warangal, India.
Robinson, G. K. (1980). “A model for simulating traffic on rural roads.” ARRB, technical manual, ATM No. 10, Australia.
Stock, W. A., and May, A. D. (1976). “Capacity evaluation of two-lane, two-way highways by simulation modeling.” Transportation Research Record. 615, Transportation Research Board, National Research Council, Washington, D.C., 20–27.
Transportation Research Board (TRB). (2000). “Highway capacity manual.” Special Report No. 209, Washington, D.C.
Wang, Y., and Cartmell, M. P. (1998). “New model for passing sight distance on two-lane highways.” J. Transp. Eng., 124(6), 536–545.
Wu, S., and Heinmach, C. (1981). “Simulation of highway traffic on two-lane, two-way rural highways.” Transportation Research Record. 806, Transportation Research Board, National Research Council, Washington, D.C., 21–28.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Aug 15, 2006
Accepted: Feb 4, 2008
Published online: Sep 1, 2008
Published in print: Sep 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.