Repeatability in Crack Data Collection on Flexible Pavements: Comparison between Surveys Using Video Cameras, Laser Cameras, and a Simplified Manual Survey
Publication: Journal of Transportation Engineering
Volume 131, Issue 7
Abstract
Crack data can be collected using manual or automatic surveys. Traditionally, manual methods are used, and they are still the most common. Changing into automatic systems will enhance the efficiency of data collection as well as the objectivity. In this study the repeatability of an automatic crack data collection system using video images was evaluated. Ten repetitive measurements were made on a 10-km-long road section. Cracking was measured using six laser cameras attached to the same vehicle. The results from the two methods were compared. Simultaneously, a simplified manual windshield survey was conducted by three different persons, and the repeatability obtained was used for comparison with the repeatability established using the image and laser method, respectively. The correlation between repeated measurements using the two automatic systems was high, while the repeatability for the manual, subjective method was low. Suitable measures for crack characterization are discussed.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgment
The financial support provided by the Swedish National Road Administration, through the Centre for Research and Education in Operation and Maintenance of Infrastructure, is gratefully acknowledged.
References
Arnberg, P. W. , Burke, M. W. , Magnusson, G., Oberholtzer, R., Råhs, K., and Sjögren, L. (1991). “The laser RST: Current status.” Rep. 372A:6, Swedish Road and Transport Research Institute (VTI), Linköpine, Sweden, 161–203.
Burke, M. W. , Arnberg, P. W. , and Råhs, K. (1991). “PAVUE: A real-time pavement distress analyzer.” Rep. 372A:6, Swedish Road and Transport Research Institute (VTI), Linköping, Sweden, 161–203.
European Commission Directorate General Transport. (1997a). “Long term performance of road pavements—final report of the action.” COST 324, Brussels, Belgium.
European Commission Directorate General Transport. (1997b). “New pavement monitoring equipment and methods—final report of the action.” COST 325, Brussels, Belgium.
Goodman, S. N. (2001). “Assessing variability of surface distress surveys in Canadian Long-Term Pavement Performance Program.” Transp. Res. Rec. 1764, Transportation Research Board, Washington, D.C.
Göransson, N.-G., and Wågberg, L.-G. (2002). “Long-term pavement performance (LTPP) study of Swedish in-service pavement test sections, status report 2002-02.” VTI Notat 3-2002, Swedish Road and Transport Research Institute (VTI), Linköping, Sweden (in Swedish).
Lang, J., and Potucek, J. (2001). “Pavement management systems in Sweden.” Proc., 5th Int. Conf. on Managing Pavements, University of Washington, Seattle.
N. D. Lea International. (1995). “Modeling road deterioration and maintenance effects in HDM-4.” Final Rep. RETA 5549–REG, Prepared for Highway Development and Management Research, Asian Development Bank, Vancouver, Canada.
Offrell, P. (1998). “Cracking of flexible pavements—a literature study.” Rep. TRITA-IP-AR 98-62, Royal Institute of Technology, Infrastructure, and Planning, Stockholm, Sweden (in Swedish).
Offrell, P. (2003). “Methods for measurements and analyses of cracks in flexible pavements—doctoral thesis.” Rep. TRITA-VT-FR 03:01, Royal Institute of Technology, Stockholm, Sweden.
Rada, G. R., Bhandari, R. K., Elkins, G. E., and Bellinger, W. Y. (1997). “Assessment of LTPP manual distress data variability.” Proc., Transport Research Board 76th Annual Meeting, Transportation Research Board, Washington, D.C., Preprint No. 970402.
Sami, N. (1997). “Florida DOT pavement condition survey, 1996-97. Phase I: Proof testing of IMS data.” Cracking Data Evaluation Rep., IMS Infrastructure Management Services, Rolling Meadows, Ill.
Sjögren, L. (1995). “The Laser RST PAVUE system, a pavement image acquisition and analysis system.” Proc., 20th World Road Congress, World Road Association, Cedex, France.
Sjögren, L. (2002). “State of the art: Automatic crack measurement of road surfaces.” VTI Notat 24-2002, Swedish Road and Transport Research Institute (VTI), Linköping, Sweden.
Strategic Highway Research Program (SHRP). (1993). “Distress identification manual for the Long-Term Pavement Performance Project.” Rep. SHRP-P-338, Washington, D.C.
Swedish National Road Administration (SNRA). (2000). “Road surface measurements: Experiences from comparative measurements 1996–2000.” Publication 2000, Borlänge, Sweden, 65
Swedish National Road Administration (SNRA). (2002). “Upphandling av vägytemätningar för perioden 2002-2004.” Publication 2000, Borlänge, Sweden, 65 (in Swedish).
Wang, K. C. P. (1998). “Automated systems for pavement surface distress survey: A historical perspective on design and implementation.” Proc., Transport Research Board 77th Annual Meeting, Transportation Research Board, Washington, D.C., Preprint.
Wang, K. C. P., and Li, X. (1999). “Use of digital cameras for pavement surface distress survey.” Transp. Res. Rec. 1675, Transportation Research Board, Washington, D.C., 91–97.
Information & Authors
Information
Published In
Copyright
© 2005 ASCE.
History
Received: May 13, 2003
Accepted: Aug 24, 2004
Published online: Jul 1, 2005
Published in print: Jul 2005
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.