Analysis of Repeated-Load Field Testing of Buried Plastic Pipes
Publication: Journal of Transportation Engineering
Volume 126, Issue 3
Abstract
This paper describes a full-scale field trial carried out on plastic pipes buried in trenches, which were repeatedly loaded by a heavy vehicle driven along an overlying haul road. The vertical deformation of the pipes was recorded throughout the test for up to 1,000 loading passes and was observed to increase rapidly during the initial loading cycles with the rate of deformation reducing markedly as further cycles of loading were applied. This indicated that the pipe/soil system became more stable by repeated stress application. Power-law curves were developed from the recorded field data and were used to predict the long-term pipe deformation from initial loading cycles. The curves showed good correlation, and the predicted values agreed closely with measured values. The two types of surround material (nominally compacted sand and gravel) were found to have little effect on the rate of accumulation of deformation.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Chua, K. M., and Lytton, R. L. (1991). “New method of time-dependent analysis for interaction of soil and large diameter flexible pipe.” Transp. Res. Rec. 1315, Transportation Research Board, Washington, D.C., 58–66.
2.
Department of Transport. ( 1990). Highway advice note HA40/89, determination of pipe and bedding combinations for drainage works. Her Majesty's Stationery Ofc., London.
3.
Department of Transport. ( 1993). Manual of contract documents for highway works, Vol. 1, Specification for highway works. Her Majesty's Stationery Ofc., London.
4.
Faragher, E. ( 1997). “Structural performance of thermoplastic drainage pipes,” MPhil thesis, Loughborough University, Loughborough, Leicestershire, U.K.
5.
Faragher, E., Rogers, C. D. F., and Fleming, P. R. (1998). “Laboratory determination of soil stiffness data for buried plastic pipes.” Transp. Res. Rec. 1624, Transportation Research Board, Washington, D.C., 231–236.
6.
Fleming, P. R., Faragher, E., and Rogers, C. D. F. (1997). “Laboratory and field testing of large-diameter plastic pipe.” Transp. Res. Rec. 1594, Transportation Research Board, Washington, D.C., 208–216.
7.
Gerbault, M. (1995). “A soil-structure interactive model.” Proc., 2nd ASCE Int. Conf. on Adv. in Underground Pipeline Engrg., ASCE, New York, 42–53.
8.
Greenwood, M. E., and Lang, C. (1990). Vertical deflection of buried flexible pipes. STP 1093, Chapter 2 (Design), ASTM, West Conshohocken, Pa., 185–213.
9.
Gumbel, J. E., O'Reilly, M. P., Lake, L. M., and Carder, D. R. (1982). “The development of a new design method for buried flexible pipe.” Proc., Europipe '82 Conf., Access Conferences Ltd., St. Albans, U.K., 87–98.
10.
Howard, A. K. (1981). “The USBR equation for predicting flexible pipe deflection.” Proc., ASCE Int. Conf. on Underground Plastic Pipe, ASCE, New York, 37–55.
11.
Marston, A., and Anderson, A. O. ( 1913). “The theory of loads on pipes in ditches and tests of cement and clay drain tile and sewer pipe.” Bull. 31, Iowa Engineering Experiment Station, Ames, Iowa.
12.
Rogers, C. D. F., Fleming, P. R., Loeppky, M. W. J., and Faragher, E. (1995). “The structural performance of profile-wall drainage pipe—Stiffness requirements contrasted with the results of laboratory and field tests.” Transp. Res. Rec. 1514, Transportation Research Board, Washington, D.C., 83–92.
13.
Saskatchewan Department of Highways and Transportation. (1982). “Structural tests on large diameter polyethylene culvert pipe.” Tech. Rep. No. 31, Saskatchewan Department of Highways and Transportation, Regina, Sask., Canada.
14.
Spangler, M. G. ( 1941). “The structural design of flexible pipe culverts.” Bull. 31, Iowa Engrg. Experiment Station, Iowa State College, Ames, Iowa.
15.
“Standard test method for determination of external loading characteristics of plastic pipe by parallel-plate loading.” (1987). D 2412-87, ASTM, West Conshohocken, Pa.
16.
“Standard for the static calculation of drainage sewers and pipelines.” (1988). A127, 2nd Ed., Geschellschaft zur Forderung der Abwassertechnische eV (German Association for Water Pollution Control) (ATV), St Augustin, Nordrhein-Westphalen, Germany.
17.
Trott, J. J., and Gaunt, J. (1976). “Experimental performance of pipelines under a major road: Performance during and after road construction.” Lab. Rep. 692, Transport and Road Research Laboratory, Crowthorne, Berkshire, U.K.
Information & Authors
Information
Published In
History
Received: May 27, 1998
Published online: May 1, 2000
Published in print: May 2000
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.