Utilization of Double Left-Turn Lanes with Downstream Lane Reductions
Publication: Journal of Transportation Engineering
Volume 124, Issue 3
Abstract
The capacity of left-turn movements at signalized intersections is sometimes increased by using two exclusive double left-turn lanes at the intersection followed by a reduction to a single lane after the turn is made. A typical application is the use of double left-turn lanes onto a freeway entrance ramp, where the right lane is dropped in advance of the merge area. The effectiveness of the “added” outside left-turn lane and downstream auxiliary lane depends on the amount of traffic using that lane. While equal distribution of traffic between a continuous and an auxiliary through lane would result in the greatest total capacity of this lane pair, traffic and geometric factors are usually such that this does not occur. The 1994 Highway Capacity Manual does not address intersection configurations with downstream lane reductions. This paper describes the development of a mathematical model, based on field data, which does predict auxiliary lane use for this intersection configuration.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
“A policy on geometric design of highways and streets.” (1990). The Am. Assn. of State Hwy. and Transp. Officials, Washington, D.C.
2.
“Highway capacity manual.” (1985). Special Rep. No. 209, Transp. Res. Board, Nat. Res. Council, Washington, D.C.
3.
“Highway capacity manual.” (1994). Special Rep. No. 209, Transp. Res. Board, Nat. Res. Council, Washington, D.C.
4.
Hurley, J. W. (1995). “Utilization of auxiliary through lanes at signalized intersections.”Transp. Res. Record 1484, Transp. Res. Board, Nat. Res. Council, Washington, D.C., 50–57.
5.
“Interim materials on highway capacity.” (1980). Transp. Res. Circular No. 212, Transp. Res. Board, Nat. Res. Council, Washington, D.C.
6.
Lieberman, E. B. (1980). “Determining the lateral deployment of traffic on an approach to an intersection.”Transp. Res. Rec. 772, Transp. Res. Board, Nat. Res. Council, Washington, D.C., 1–5.
7.
Neuman, T. R. (1985). “Intersection channelization design guide.”NCHRP Rep. No. 279, Transp. Res. Board, Nat. Res. Council, Washington, D.C.
8.
Stokes, R. W. (1989). “Some factors affecting signalized intersection capacity.”ITE J, Inst. of Transp. Engrs., Washington, D.C., 35–40.
9.
Zeeger, J. D. (1986). “Field validation of intersection capacity factors.” Transp. Res. Record No. 1091, Transp. Res. Board, Nat. Res. Council, Washington, D.C., 67–77.
Information & Authors
Information
Published In
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: May 1, 1998
Published in print: May 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.