Drainability Characteristics of Granular Pavement Base Material
Publication: Journal of Transportation Engineering
Volume 123, Issue 5
Abstract
A study was undertaken to determine the drainability characteristics of several types of unbound granular materials that are used in pavement bases. From the literature, testing concerns were identified and analyzed. Hydraulic conductivity and effective porosity were determined for aggregates from two sources of crushed stone and two sources of gravel. For each material two open gradations were tested in a rigid wall permeameter. One dense gradation of each material, at two levels of compaction, was tested in a flexible wall permeameter as well. Efforts were made to reduce possible flow along the sides of the rigid wall permeameter and to eliminate problems with air bubbles. The average hydraulic conductivities for the open and dense-graded materials were 3.6 × 10−1 and 3.0 × 10−4 cm/s (1,021 and 0.85 ft/d), respectively. The effective porosities for the open and dense-graded materials were 68 and 27% of the nominal porosities, respectively. Four regression equations representing a wide range of hydraulic conductivity were developed to estimate hydraulic conductivity based on the results of this study and others reported in the literature.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Barber, E. S., and Sawyer, C. L. (1952). “Highway subdrainage.”Proc., Highway Research Board, Washington, D.C., 643–666.
2.
Chapuis, R. P., and Baass, K.(1989). “Granular soils in rigid wall permeameters: method for determining the degree of saturation.”Can. Geotech. J., Ottawa, Canada, 26, 71–79.
3.
Chu, T. Y., Davidson, D. T., and Wickstrom, A. E. (1955). “Permeability tests for sands.”Permeability of Soils, ASTM Special Technical Publication No. 163, ASTM, West Conshohocken, Pa., 43–55.
4.
Crovetti, J. A., and Dempsey, B. J. (1991). “Pavement subbases.”Final Rep., Proj. IHR-525, Univ. of Illinois at Urbana-Champaign, Urbana, Ill.
5.
Highlands, K. L., and Hoffman, G. L. (1988). “Subbase permeability and pavement performance.”Transp. Res. Rec. No. 1159, Transportation Research Board, Washington, D.C., 7–20.
6.
Jones, C. W. (1955). “The permeability and settlement of laboratory specimens of sand and sand-gravel mixtures.”Symp. on Permeability of Soils, ASTM Special Technical Publication No. 163, ASTM, West Conshohocken, Pa., 68–79.
7.
Karlsdotter, J. (1991). “Optimization of coarse particles in a filter soil,” MS thesis, Univ. of Missouri-Rolla, Mo.
8.
Kozlov, G. S. (1984). “Implementation of internal road drainage design and application.”Transp. Res. Rec. No. 993, Transportation Research Board, Washington, D.C., 35–46.
9.
Lane, K. S., and Washburn, D. E. (1946). “Capillarity tests by capillarimeter and by soil filled tubes.”Proc., Highway Research Board, Washington, D.C., 460–473.
10.
Loudon, A. G.(1953). “The computation of permeability from simple soil tests.”Géotechnique, London, England, 3, 165–183.
11.
Moulton, L. K. (1980). Highway subdrainage design manual; Rep. No. FHWA-TS-80-224. Federal Highway Administration (FHWA), McLean, Va.
12.
Moynahan, T. J. Jr., and Sternberg, Y. M. (1974). “An investigation of the vertical and horizontal hydraulic conductivities of dense base course aggregates.”Final Rep. Maryland Hwy. Drain. Study.
13.
Richardson, D. N., and Kremer, P. A. (1994). “Determination of AASHTO layer coefficients, vol. II: unbound granular bases and cement treated bases.”MCHRP Rep., Study 90-5, Univ. of Missouri-Rolla, Mo.
14.
Richardson, D. N., Lambert, J. K., and Kremer, P. A. (1994). “Determination of AASHTO layer coefficients, vol. I: bituminous materials.”MCHRP Final Rep., Study 90-5, Univ. of Missouri-Rolla, Mo.
15.
Richardson, D. N., Morrison, W. J., Kremer, P. A., and Hubbard, K. M. (1996). “Determination of AASHTO drainage coefficients.”MCHRP Final Rep., Study 90-4, Univ. of Missouri-Rolla, Mo.
16.
Sherard, J. L., Dunningan, L. P., and Talbot, J. R.(1984). “Basic properties of standard gravel filters.”J. Geotech. Engrg., ASCE, 110(6), 684–700.
17.
Smith, T. W., Cedergren, H. R., and Reyner, C. A. (1964). “Permeable materials for highway drainage.”Hwy. Res. Rec. No. 68, Highway Research Board, Washington, D.C., 1–16.
18.
“Standard method of test for permeability of granular soils (constant head), T 215-90.” (1990). Standard specifications for transportation materials and methods of sampling and testing, 15th Ed., American Association of State Highway and Transportation Officials (AASHTO), Washington, D.C., 554–558.
19.
Standard test method for measurement of hydraulic conductivity of saturated porous materials using a flexible wall permeameter; D5084-90. (1990). ASTM, West Conshohocken, Pa., Vol. 04.08, 1070–1077.
20.
Standard test method for particle shape, texture, and uncompacted void content of fine aggregate. (1991). National Aggregate Association (NAA), Silver Spring, Md.
21.
Strohm, W. E., Nettles, E. H., and Calhoun, C. C. (1967). “Study of drainage characteristics of base course materials.”Hwy. Res. Rec. No. 203, Highway Research Board, Washington, D.C., 8–28.
22.
Test method for index of aggregate particle shape and texture; D3398-87. (1987). ASTM, West Conshohocken, Pa., Vol. 05.03, 393–396.
23.
Yemington, E. G. (1955). “A low-head permeameter for testing granular materials.”Permeability of soils, ASTM Special Technical Publication No. 163, ASCE, West Conshohocken, Pa., 37–42.
Information & Authors
Information
Published In
Copyright
Copyright © 1997 American Society of Civil Engineers.
History
Published online: Sep 1, 1997
Published in print: Sep 1997
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.