Cost of Driving Comfort and Convenience for Two‐Lane Highways
Publication: Journal of Transportation Engineering
Volume 115, Issue 3
Abstract
Described in this paper is the development and calibration of a proposed model for estimating the cost of comfort and convenience related to driving on two‐lane highways. The starting point for the model presented here was an earlier study which showed that the traditional cost factors and variables, when employed with the 1985 Highway Capacity Manual's revised data and procedures for two‐lane highways, could underestimate the user cost and reflect inappropriately the deterioration of user service with an increase in the volume of traffic. Based on several past studies, the proposed model for the cost of comfort and convenience considers such factors as the relative importance of driving comfort as perceived by road users, the unsatisfied overtaking demand, “percent time delay” curves, the type of road use, volume‐to‐capacity ratio, the desired highway speed, and vehicle classification. The paper describes and discusses in detail the concept and estimation of the model parameters. The model parameters are estimated by considering the shape of generally accepted cost versus volume‐to‐capacity ratio curves and the current practice of planning and design of highways.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
AASHTO. (1960). Road user benefit analysis for highway improvement. American Association of State Highway Officials, Washington, D.C.
2.
Alberta Transportation. (1978). Travel profile study. Alberta Transportation, Edmonton, Canada.
3.
Ferrari, P., et al. (1984). “A behavioral approach to the measurement of motorway circulation comfort and safety.” Transp. Res., 18A(1), 43–59.
4.
Highway Research Board. (1965). “Highway capacity manual.” Special Report 87, Highway Research Board, Washington, D.C.
5.
Kilburn, P. (1985). Alberta road user costs—1985. Systems Planning Branch, Alberta Transportation, Edmonton, Alberta, Canada.
6.
Lingras, P. J. (1986). “The new highway capacity manual and economic analysis for rural roads,” thesis presented to University of Regina, at Regina, Saskatchewan, Canada, in partial fulfillment of the requirements for the degree of Master of Science.
7.
Ministry of Transportation and Communications. (1986). Truck climbing lanes and passing lanes. Highway Design Office, Ministry of Transportation and Communications, Ontario, Canada.
8.
Normann, O. K. (1942). “Results of highway capacity studies.” Public Roads, 23(4), 57–81.
9.
Oglesby, C. H., and Hicks, R. G. (1982). Highway engineering. John Wiley and Sons, New York, N.Y.
10.
Sharma, S. C., Lingras, P. J., and Werner, A. (1987). “Highway economic analysis experiences with the 1985 highway capacity manual.” Transportation Research Record 1112, Transportation Research Board, Washington, D.C.
11.
Sharma, S. C., Tayebali, A., and Werner, A. (1985). “Cost effective and useroriented sizing of rural roads.” Transportation Research Record 1009, Transportation Research Board, Washington, D.C., 15–23.
12.
Tayebali, A. A. (1985). “Road use considerations in sizing of rural roads,” thesis presented to the University of Regina, at Regina, Saskatchewan, Canada, in partial fulfillment of the requirements for the degree of Master of Science.
13.
Transportation Research Board. (1985). “Highway Capacity Manual.” Special Report 209, Washington, D.C.
14.
Verron, H. (1986). “Users' reactions to specific combinations of policy measures.” Behavioural research for transport policy, VNU Science Press, Utrecht, The Netherlands.
15.
Werner, A., and Morall, J. F. (1984). “Unified traffic flow theory model for two lane rural highways.” Trans. Forum, 1(3), Roads and Transportation Association of Canada, Ottawa, 79–87.
16.
Williams, A. S. (1983). 1983 user costs. Operational Planning Branch, Alberta Transportation, Edmonton, Alberta, Canada.
Information & Authors
Information
Published In
Copyright
Copyright © 1989 ASCE.
History
Published online: May 1, 1989
Published in print: May 1989
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.