Vehicle Flow Characteristics on Acceleration Lanes
Publication: Journal of Transportation Engineering
Volume 111, Issue 6
Abstract
The purpose of this study was to investigate flow characteristics on acceleration lanes. Four acceleration lanes in Israel, which were videotaped, provided the data. Three separate analyses were conducted: the locational distribution of merging places, acceleration characteristics of vehicles, and driver behavior during gap or lag acceptance. About 15% of the drivers tended to merge at a relatively sharp angle during the first quarter of the acceleration lane length, regardless of type. Also, light vehicles tended to merge much faster than did heavy vehicles. No great increases in speed were found to occur on the acceleration lanes. The difference in average speeds between vehicles on the through lane and vehicles at the far end of the acceleration lane was found to be somewhat higher than previously reported values. Findings lead to the conclusion that the majority of drivers do not seem to use the acceleration lane strictly for acceleration purposes; rather, the entire merging process is controlled by gap‐acceptance behavior. The importance of determining the proper location for a reference line for an analysis of rejected lags were found to decrease significantly with the placing of the reference line closer to the end of the acceleration lane. The necessity for adjusting the parameters of lag acceptance (since the driver population that rejects lags on acceleration lanes is composed of two subpopulations) is evaluated.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Ackroyd, L. W., and Madden, A. J., “Vehicle Speeds and Paths at Rural Diamond Roundabout Motorway Interchanges,” Traffic Engineering & Control, Vol. 16, No. 5, 1975, pp. 215–219.
2.
American Association of State Highway Officials (AASHO),” A Policy on Geometric Design of Rural Highways, Washington, D.C., 1965.
3.
Blumenfeld, D. E., and Weiss, G. H., “Merging from an Acceleration Lane,” Transportation Science, Vol. 5, No. 2, 1971, pp. 161–168.
4.
Blunden, W. R., Clissold, C. M., and Fisher, R. B., “Distribution of Acceptance Gaps for Crossing & Turning Maneuvers,” Proceedings, Australian Road Research Board, Vol. 1, Part 1, Melbourne, Australia, 1962, pp. 188–205.
5.
Drew, D. R., “Gap Acceptance Characteristics for Ramp‐Freeway Surveillance and Control,” HRB Record 157, 1967, pp. 108–135.
6.
Drew, D. R., Traffic Flow Theory & Control, McGraw‐Hill, New York, N.Y., 1968.
7.
Fukutome, I., and Moskowitz, K., “Traffic Behavior and On‐Ramp Design,” HRB Bulletin 235, 1960, pp. 38–72.
8.
Huberman, M., “The Development and Evaluation of a Technique for Measuring Vehicle Accelerations on Highway Entrance Ramps,” RTAC Forum, Vol. 4, No. 2, 1982, pp. 90–96.
9.
Jouzy, N. C., and Michael, H. L., “Use and Design of Acceleration and Deceleration Lanes in Indiana,” HRB Record 9, 1963, pp. 25–51.
10.
Livneh, M., Polus, A., and Factor, J., “Analysis of Vehicle Flow Characteristics on Acceleration Lanes,” Transportation Research Institute, Research Report 84‐40, Technion, Israel Institute of Technology, Haifa, Israel, June, 1984.
11.
Major, N. G., and Buckley, D. J., “Entry to a Traffic Stream,” Proceedings, Australian Road Research Board, Vol. 1, Part 1, Melbourne, Australia, 1962, pp. 206–228.
12.
Miller, A. J., “Nine Estimators of Gap‐Acceptance Parameters,” Traffic Flow and Transportation, Proceedings, Fifth International Symposium on the Theory of Traffic Flow and Transportation, June, 1971, pp. 215–235.
13.
Raff, M. S., “A Volume Warrant for Urban Stop Signs,” The ENO Foundation for Highway & Traffic Control, Saugatuck, Conn., 1950.
Information & Authors
Information
Published In
Copyright
Copyright © 1985 ASCE.
History
Published online: Nov 1, 1985
Published in print: Nov 1985
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.