Stochastic Assessment of Timing and Efficiency of Maintenance for Corroding RC Structures
Publication: Journal of Structural Engineering
Volume 135, Issue 8
Abstract
Reinforced concrete (RC) structures in a chloride environment are exposed to a particularly aggressive form of deterioration. Managing the maintenance and repair of structures subjected to these conditions is an important issue facing asset owners and operators. In the present paper, the criterion for repair is the extent of corrosion induced cracking. Common maintenance criteria and maintenance techniques are described and these are incorporated into a two-dimensional spatial time-dependent reliability model. This allows the number, timing, and extent of maintenance actions to be predicted over the service life of RC structures. The analysis includes the effect of inspection interval, maintenance technique, repair efficiency, and repair threshold. Results are presented for a typical RC bridge deck subject to a corrosive marine environment. It was found that repair efficiency affecting time to corrosion initiation of repaired concrete is more critical to the performance of the repair than the repair efficiency that affected corrosion rate.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The support of the Australian Research Council is gratefully acknowledged.
References
Al-Harthy, A. S., and Stewart, M. G. (2006). “A review of predictive models for cracking in concrete due to reinforcement corrosion.” Research Rep. No. 258.06.06, Centre for Infrastructure Performance and Reliability, Univ. of Newcastle, Newcastle, Australia.
Australian Concrete Repair Association. (2006). “Guide to concrete repair and protection.” HB 84, Strathfield, Australia.
Bertolini, L., Elsener, B., Pedeferri, P., and Polder, R. (2004). Corrosion of steel in concrete: Prevention, diagnosis, repair, Wiley, Weinheim.
Broomfield, J. P. (1997). Corrosion of steel in concrete, St. Edmundsbury Press, Suffolk, U.K.
Building Research Establishment Report. (2003). “Residual life models for concrete repair—Assesment of the concrete repair process.”
Canisius, T. D. G., and Waleed, N. (2004). “Concrete patch repairs under propped and unpropped implementation.” Proc., Institution of Civil Engineers: Structures & Buildings, 157(582), 149–156.
Chryssanthopoulos, M. K., and Sterritt, G. (2002). “Integration of deterioration modelling and reliability assessment for reinforced concrete bridge structures.” 1st ASRANet Int. Colloquium (CD-ROM), Glasgow, Scotland.
De Brito, J., and Branco, F. (2004). “Concrete bridge management—Inspection, assessment, and evaluation.” Bridge, Maintenance, Safety, Management, Life-Cycle Performance and Cost, IABMAS’04 (CD-ROM), E. Watanable, D. M. Frangopol, and T. Utsunomiya, eds., Balkema, Rotterdam, The Netherlands.
Directoraat-Gerneraal Rijkswaterstaat. (2000). Management and maintenance system, The Netherlands (in Dutch).
Fazio, R., Mirza, M. S., McCafferty, E., Andrews, R. J., Basheer, P. A. M., and Long, A. E. (1999). “In-situ assessment of corrosion induced damage of the Dickson bridge deck.” Proc., 8th Durability of Building Materials and Components, National Research Council (Canada), Ottawa, 269–279.
Fitch, M. G., Weyers, R. E., and Johnson, S. D. (1995). “Determination of end of functional service life concrete bridge decks.” Transp. Res. Rec., 1490, 60–66.
Li, Y., Vrouwenvelder, T., Wijnants, G. H., and Walraven, J. (2004). “Spatial variability of concrete deterioration and repair strategies.” Struct. Concr., 5(3), 121–130.
Liu, Y., and Weyers, R. E. (1998). “Modelling the time-to-corrosion cracking in chloride contaminated reinforced concrete structures.” ACI Mater. J., 96(6), 675–681.
Malioka, V., and Faber, M. H. (2004). “Modeling of the spatial variability for concrete structures.” Bridge Maintenance, Safety, Management and Cost, IABMAS’04 (CD-ROM), E. Watanable, D. M. Frangopol, and T. Utsunomiya, eds., Balkema, Rotterdam, The Netherlands.
Mangat, P. S., and Limbachiya, M. C. (1999). “Effect of initial curing on chloride diffusion in concrete repair materials.” Cem. Concr. Res., 29, 1475–1485.
Nasu, S., Okamura, H., and Kokubo, S. (2004). “Maintenance and management of concrete bridges.” IABMAS’04. Bridge Maintenance, Safety, Management and Cost, IABMAS’04 (CD-ROM), E. Watanable, D. M. Frangopol, and T. Utsunomiya, eds., Balkema, Rotterdam, The Netherlands.
Sterritt, G., Chryssanthopoulos, M. K., and Shetty, N. K. (2001). “Reliability-based inspection planning for RC highway bridges.” Proc., Int. Conf. on Safety, Risk and Reliability, IABSE, Zurich, 1001–1007.
Stewart, M. G. (2004). “Spatial variability of pitting corrosion and its influence on structural fragility and reliability of RC beams in flexure.” Struct. Safety, 26(4), 453–470.
Stewart, M. G. (2006). “Spatial variability of damage and expected maintenance costs for deteriorating RC structures.” Struct. Infrastruct. Eng., 2(2), 79–90.
Stewart, M. G., and Mullard, J. A. (2007). “Spatial time-dependent reliability analysis of corrosion damage and the timing of first repair for RC structures.” Eng. Struct., 29, 1457–1464.
Stewart, M. G., Mullard, J. A., Drake, B. J., and Al-Harthy, A. S. (2007). “Utility of spatially variable damage performance indicators for improved safety and maintenance decisions of deteriorating infrastructure.” Civ. Eng. Environ. Syst., 24(2), 149–163.
Stewart, M. G., and Val, D. V. (2003). “Multiple limit states and expected failure costs for deteriorating RC bridges.” J. Bridge Eng., 8(6), 405–415.
Sudret, B., Defaux, G., and Pendola, M. (2007). “Stochastic evaluation of the damage length in RC beams submitted to corrosion of reinforcing steel.” Civ. Eng. Environ. Syst., 24(2), 165–178.
Vanmarcke, E. (1983). Random fields: Analysis and Synthesis, MIT Press, Cambridge, Mass.
Vu, K. A. T., and Stewart, M. G. (2002). “Spatial variability of structural deterioration and service life prediction of reinforced concrete bridges.” 1st Int. Conf. on Bridge Maintenance, Safety and Management (CD-ROM), Barcelona.
Vu, K. A. T., Stewart, M. G., and Mullard, J. A. (2005). “Corrosion-induced cracking: Experimental data and predictive models.” ACI Struct. J., 102(5), 719–726.
Yunovivh, M., Thompson, N. G., Balvanyos, T., and Lave, L. (2001). “Corrosion costs and preventative strategies in the United States.” Rep. FHWA-RD-01-156, Office of Infrastructure Research and Development, Washington, D.C.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Jul 23, 2007
Accepted: Mar 24, 2009
Published online: Jul 15, 2009
Published in print: Aug 2009
Notes
Note. Associate Editor: Sankaran Mahadevan
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.